The NADI (non-azide driver inflator) type airbag may have improper sealing that could allow moisture to enter into the propellant.If the propellant afterwards dries out, it could lead to decreased density resulting in a too high burn rate. Consequently the airbag may not deploy as designed and provide less protection, increasing the risk of injury.
Safety Gate · UE15 giu 2021A12/00893/21Anni modello 2000Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The ammonium nitrate propellant used in the air bag inflator may degrade over time. In the event of the airbag being deployed, the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the driver.
Safety Gate · UE14 dic 2018A12/1968/18Anni modello 2003–2008Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2004-2006 Mitsubishi Lancer vehicles that previously received a like-for-like passenger side frontal air bag inflator under recall 15V321 as interim remedy. Also recalled are 2004-2006 Lancer vehicles located in Guam or Saipan that previously received or never received a new inflator under 15V321 or 17V569. These passenger side frontal air bag inflators may be susceptible to moisture intrusion which, over time, could cause the inflator to explode in the event of an air bag deployment.
NHTSA · Stati Uniti5 apr 201818V220000Anni modello 2004–2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain 2004-2006 Lancer and Lancer Evolution vehicles and 2004 Lancer Sportback vehicles. These vehicles are equipped with a passenger side frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture.
NHTSA · Stati Uniti14 set 201717V569000Anni modello 2004–2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that attaches it to the vehicle. Over time, repeated freezing/thawing cycles could cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. In the event of a crash, this could result in delayed deployment of the driver and passenger front airbags which would increase the risk of injury. Correction: Dealers will inspect the front impact sensor and replace it if it is found to be cracked. An updated designed bracket and cover will also be installed.
Transport Canada29 lug 20162016382Anni modello 2008–2015Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the airbag inflator. Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.
Transport Canada25 mag 20162016254Anni modello 2006–2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2007 Lancer and Lancer Evolution vehicles manufactured June 29, 2005, to June 19, 2007, equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating air bag deployment, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
NHTSA · Stati Uniti23 mag 201616V334000Anni modello 2006–2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2014-2015 Lancer Evolution vehicles manufactured January 31, 2014, to September 5, 2014, and 2014-2015 Lancer Ralliart vehicles manufactured February 3, 2014, to September 5, 2014. The affected turbocharged vehicles have a right parking brake cable that may contact the fuel tank, wearing away the tank's protective coating.
NHTSA · Stati Uniti31 ago 201515V546000Anni modello 2014–2015Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, the right parking brake cable may have been incorrectly installed resulting in insufficient clearance with the fuel tank, causing abrasive contact between the two components. This contact could result in the coating on the fuel tank deteriorating and allowing rust to form, which could result in fuel leakage. Fuel leakage, in the presence of an ignition source, could result in a fire causing injury and/or damage to property. Correction: Dealers will replace the right parking brake cable and inspect the fuel tank. If the fuel tank’s exterior coating is damaged from contact with the parking brake cable, the fuel tank will also be replaced.
Transport Canada28 ago 20152015386Anni modello 2014–2015Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the passenger airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace front passenger airbag inflators. Note: This recall has been superseded. For unrepaired vehicles, see <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2017444">recall 2017444 for more information</a>. Vehicles previously serviced under this recall may have received an interim repair - See <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018166">recall 2018166 for more information</a>.
Transport Canada28 mag 20152015236Anni modello 2004–2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley and detach, affecting electrical charging system and cooling system function and would illuminate the engine warning lamp(s) on the instrument panel. This could result in battery depletion and an overheated engine, resulting in a loss of motive power. Vehicles equipped with a hydraulic power steering system could also experience loss of power steering assist. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the drive belt, and the pulley will be replaced if it is found worn beyond a certain level.
Transport Canada15 set 20142014397Anni modello 2008–2011Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2014 Lancer Evolution vehicles manufactured January 31, 2014, through February 21, 2014, and 2014 Lancer Ralliart vehicles manufactured February 3, 2014, through February 14, 2014. The affected vehicles may have insufficient clearance between the power steering pressure tube and the crossmember brace.
NHTSA · Stati Uniti27 mag 201414V281000Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles operated in areas of heavy road salt usage, the front impact sensors may corrode between the sensor bushing and sensor bracket. Over time, the corrosion may cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. This could result in delayed deployment of the driver and passenger front airbags during a vehicle crash, increasing the risk of personal injuries or death. Correction: Dealers will replace the front impact sensors.
Transport Canada9 nov 20092009317Anni modello 2008–2009Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).