Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
NANHTSA · bollettino del costruttore10223854
Bollettini tecnici
Mostrato in inglese originale · traduzione in attesa
Riguarda: Dodge Avenger sedan (Anni modello 2008) · Dodge Caravan IV (Anni modello 2007) · Dodge Challenger (Anni modello 2008) · Dodge Durango II (Anni modello 2007) · Dodge Magnum (2005–2008) (Anni modello 2007) · Dodge Neon II (Anni modello 2001) · Dodge Nitro (Anni modello 2007) · Dodge Ram II (Anni modello 1998) · Dodge Ram SRT-10 (Anni modello 2006) · Dodge Ram Van III (Anni modello 2001) · Dodge SRT-4 (Anni modello 2005) · Ram ProMaster III (Anni modello 2015–2016)
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).