It has been identified on a small number of vehicles that the spacer for the front right-hand seat belt fixing bolt may have been incorrectly fitted. It is therefore possible that in time this could result in the fixing for the assembly becoming insecure.
DVSA · Regno Unito22 nov 2006R/2006/212Mostrato in inglese originale · traduzione in attesaVedi dettagli →
It is necessary to exchange the two clevis pins on the brake pedal system to avoid any loss of braking. Peugeot have experienced a limited number of incidents where one of the pins has not been locked properly during fitting.
DVSA · Regno Unito24 nov 2003R/2003/158Anni modello 1998–2002Mostrato in inglese originale · traduzione in attesaVedi dettagli →
It is possible that the con-rod bearing shells will not conform to manufacturer specification. This could lead to premature deterioration of the shells and in time cause the engine to fail.
DVSA · Regno Unito13 nov 2012R/2012/135Anni modello 2010Mostrato in inglese originale · traduzione in attesaVedi dettagli →
It has been identified that on subject vehicles the windscreen wiper mechanism has not been manufactured to specification. As a result in time the windscreen wipers could fail.
DVSA · Regno Unito27 ott 2008R/2008/155Anni modello 2005–2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The possibility exists that the starter motor wiring loom has been positioned incorrectly. In consequence there is a risk that this could cause a short circuit.
DVSA · Regno Unito13 set 2004R/2004/167Anni modello 2004Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The software may cause erratic operation of the motorized throttle which may result in breakage of the throttle stop. This can result in the engine reverting to limp home mode with a possible reduction in braking assistance.
DVSA · Regno Unito14 mag 2004R/2004/087Mostrato in inglese originale · traduzione in attesaVedi dettagli →
There is a possibility that the steering column cowling may move out of alignment causing the ignition switch to foul on the steering cowling and possibly stick in the start position.
DVSA · Regno Unito4 mag 2002R/2002/068Mostrato in inglese originale · traduzione in attesaVedi dettagli →
There is a possibility that the front stub axle lower ball joint fixing may have been incorrectly machined which may result in separation of the stub axle from the ball joint/lower suspension arm.
DVSA · Regno Unito15 gen 2001R/2001/008Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).