Sui veicoli con motori da 2.5 l. Il sistema di alimentazione del carburante può perdere in corrispondenza del collegamento del tubo di alimentazione del carburante per l'iniezione nel corpo farfallato, con il possibile rischio di incendio nel vano motore.
Transport Canada29 mar 19851985032Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
Il sistema di alimentazione del carburante potrebbe presentare una perdita in corrispondenza del raccordo del tubo di alimentazione del carburante all'iniettore del corpo farfallato. Conseguenza del difetto: questa perdita potrebbe causare un incendio nel vano motore, che potrebbe propagarsi all'abitacolo e causare ustioni agli occupanti.
NHTSA · Stati Uniti29 mar 198585V034000Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
Le valvole dosatrici del freno possono rompersi e staccarsi dal cilindro principale durante la frenata. Ciò causerà una perdita di liquido dei freni e una perdita parziale dell'azione frenante.
Transport Canada7 ott 19841983084Anni modello 1983Tradotto automaticamente · originale: ingleseVedi dettagli →
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
Transport Canada26 gen 19831983009Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
NHTSA · Stati Uniti8 mar 198282V021000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
Transport Canada3 mar 19821982026Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. Continued operation of the vehicle may result in wear through of the insulation on the clutch cable. The resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.
NHTSA · Stati Uniti2 mar 198282V018000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicles equipped with 4 speed manual transmissions. The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. This could eventually result in the failure of the brake pipe causing loss of brake fluid and due to the dual braking system, a partial loss of braking action. Should a partial loss ob braking action occur while the vehicle is in motion at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.
Transport Canada25 feb 19821982022Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicles equipped with v6 engines and power steering may have the power steering hoses incorrectly routed. This condition may allow the hoses to contact the exhaust manifold possibly resulting in hose failure. It is possible that power steering fluid could leak onto the manifold resulting in smoke and under hood fire. Such a fire could spread to the passenger compartment.
Transport Canada16 ott 19801980132Anni modello 1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicles equipped with automatic transmissions. The automatic transmission cooler line hoses may fail during vehicle operation. Transmission fluid leakage in the engine compartment may result in a vehicle fire.
Transport Canada26 set 19791979162Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.
NHTSA · Stati Uniti5 apr 197979V090000Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Su alcuni veicoli, i meccanismi di bloccaggio dello schienale dei sedili anteriori potrebbero non bloccarsi in condizioni di carico frontale e pertanto non sono conformi alla norma CMVSS 207 - Ancoraggi dei sedili.
Transport Canada27 feb 19841984027Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
Alcuni veicoli sono dotati di bloccaggi dello schienale dei sedili a guscio che non sono conformi allo standard federale di sicurezza dei veicoli a motore 207, ancoraggio dei sedili. In caso di collisione, il bloccaggio dello schienale potrebbe non funzionare.
NHTSA · Stati Uniti6 feb 198484V011000Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
NHTSA · Stati Uniti13 ott 198383V105000Anni modello 1983Mostrato in inglese originale · traduzione in attesaVedi dettagli →
These vehicles may experience premature rear wheel skid when the brake pedal is applied. The absence of any corrective steering or braking action on the part of the driver could cause the rear of the vehicle to skid out of its lane of travel.
Transport Canada28 mar 19831983035Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.
NHTSA · Stati Uniti24 feb 198383V018000Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".
NHTSA · Stati Uniti1 gen 198383V007000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicles with manual transmissions. A low spring load on the pawl to engage quadrant teeth of the self adjusting clutch mechanism will result in slippage and prevent clutch release when the pedal is depressed to the floor.
Transport Canada25 ago 19811981089Anni modello 1980–1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicles with manual transmissions. Vehicles may be equipped with defective brake proportioner valves which could cause the rear brakes to lock up prematurely during high deceleration braking. This could result in loss of vehicle control and vehicle crash without prior warning.
Transport Canada17 ago 19811981087Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certain conditions, the rear brakes could lock up without prior warning during high deceleration braking. The problem may be caused by defective proportioner valves in the braking system.
NHTSA · Stati Uniti10 ago 198181V095000Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The terminal that attaches the engine to body ground cable to the front lower tie bar may fracture resulting in reduced voltage to body grounded electrical components and cause erratic operation of the components.
Transport Canada26 mar 19811981037Anni modello 1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The engine-to-body ground cable on certain vehicles may have been damaged during manufacture. The cable could eventually break due to the relative motion between the engine and body during vehicle operation.
NHTSA · Stati Uniti24 mar 198181V038000Anni modello 1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto the exhaust manifold.
NHTSA · Stati Uniti8 ott 198080V129000Anni modello 1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The steering gear mounting plate on the involved vehicles may develop fatigue cracks at high mileage which would allow the steering gear attachment to become loose. If this condition exists, the driver may notice considerable "free play" in the steering wheel.
NHTSA · Stati Uniti17 ott 197979V221000Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The steering gear mounting plate may develop fatigue cracks which would allow the steering gear attachment to become loose. The driver may notice that the steering wheel can be turned several degrees before a change in vehicle direction occurs.
Transport Canada26 set 19791979161Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).