Richiamo
There is a possible loss of torque retention of the steering wheel shaft nut . This may lead to steering wheel detachement and loss of steering control.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Renault 18 (tutte le generazioni)
There is a possible loss of torque retention of the steering wheel shaft nut . This may lead to steering wheel detachement and loss of steering control.
The 12 mm spacer used on the rear seat belt anchorage bolts may affect anchor bolt load capacity and fail to comply with fmvss 210, seat belt assembly anchorages. Consequence of defect: The rear outboard seat belt anchorages may not maintain load requirements for the specified time. This failure may cause the seat belt system not to restrain the occupant in position if an accident were to occur, causing serious injuries.
Some electrical wires in the engine compartment may not be properly routed or secured. This may allow the wires to come into contact with the engine compartment components which may result in potential circuit malfunctions and damage to the vehicle electrical system including the remote possibility of an electrical fire.
Some of the involved vehicles may develop a fuel leak near the engine due to a loose fuel line connection.
A cruise control accelerator clip could allow the accelerator to disgengage from the throttle control,causing the throttle to remain in a partially open position when the cruise control is in use.
A wrong cruise control accelerator cable clip was installed in the assembly. This could allow the accelerator cable to disengage from the throttle control. Consequence of defect: The disengaged accelerator cable causes the throttle to remain partially open when cruise control is in use and results in loss of acceleration control and could cause an accident.
The steering wheel could loosen due to inadequate tightening of the wheel shaft nut. Consequence of defect: Loosening of the steering wheel would affect the steering control of the car and may result in an accident.
Vehicles do not comply with c.M.V.S.S. 210-seat belt anchorages.
On certain vehicles, the wiring system in the engine compartment may have been improperly routed. If so, the wires may come in contact with some of the engine compartment components.
Vehicles may have been assembled with a restricted fuel supply system that does not function properly. The engine may stop unexpectedly, even though the fuel gauge indicates fuel is available.
Vehicles may have been built with loose fuel line connections that could develop a leak near the engine.
Vehicles may have been built with a fuel line that could develop a leak near the fuel tank.
The fuel supply system could be restricted or contaminated which could result in the engine stopping unexpectedly.
On certain vehicles, the wiring harness for the air conditioner may provide power to the ignition circuit while the key is in the off position.
On certain vehicles, the cruise control actuation chain could catch on certain carburetor hardware, causing the throttle plate to remain in a partially open position.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).