Note: Vehicles equipped with all-wheel drive manual transmission. Under cold and humid conditions, frost may form at the transmission oil level gauge (dipstick) where the breathing mechanism is incorporated. This could cause pressure to build inside the transmission case which in turn could push out the oil seal. Subsequent oil leakage could result in burning of transmission components and possible loss of control due to wheel lock-up. Correction: On vehicles with an all metal type dipstick, the oil level gauge tube will be modified and the dipstick will have a spacer added. Vehicles with a plastic dipstick will have a modified type dipstick installed.
Transport Canada29 mar 19941994067Anni modello 1989–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
When the vehicle is driven continuously under extremely cold temperatures (-22 degrees f.) and high humidity weather conditions, the transmission breathing (air) vent can be blocked due to moisture freezing at the oil level gauge. If this occurs, pressure inside the transmission case will increase and push out the rear oil seal, causing transmission oil leakage. The lack of lubrication can burn the internal components of the transmission, cause the transmission to seize and the vehicle to come to a sudden stop.
NHTSA · Stati Uniti23 mar 199494V052000Anni modello 1990–1992Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The electronically controlled motor pump power steering system may malfunction, causing intermittent loss of power steering assist and requiring varying degrees of increased steering effort.
NHTSA · Stati Uniti12 nov 199191V193000Anni modello 1988–1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Non-compliance with c.M.V.S.S.301-fuel system integrity. Due to insufficient spot welding adhesion,the rear bumper rail,under rear impact conditions,may break loose and move forward,damaging the fuel tank air vent hose. Thus creating the possibility of fuel leakage and the risk of vehicle fire.
Transport Canada21 ott 19851985114Anni modello 1985Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Excessive tolerance variation may have created a gap between the bumper bracket rail and the right front frame of the rear side member. This could result in insufficient spot welding adhesion at this location. Under rear impact conditions, bumper could break loose and damage the air vent hose. This may cause fuel to leak in access of the maximum requirement of fmvss 301. Consequence of defect: Fuel leakage caused by a rear end collision may contribute to a fire if a source of ignition is present.
NHTSA · Stati Uniti21 ott 198585V132000Anni modello 1985Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland. Continuous exposure to road salt and chemicals may cause corrosion of the rear suspension inner arms which could affect the operation and control of the vehicle. Correction: Inner arms of the rear suspension will be inspected and rust proofed or replaced.
Transport Canada27 mar 19921992035Anni modello 1985–1987Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The electronically controlled motor pump power steering system may malfunction, resulting in intermittent loss of power assist. When power assist fails, the vehicle may be manually steered, however, since power steering assist may come back suddenly after the loss of power assist has occurred, it can conceivably lead to loss of vehicle control. Correction: Dealers will install a new modified signal controller and power controller on affected vehicles.
Transport Canada8 gen 19921992001Anni modello 1988–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On electronically controlled automatic transmissions, the park gear disengagement mechanism, when subject to loads resulting from certain parking situations, may not release immediately into reverse gear resulting in delayed and possibly abrupt vehicle movement. This could result in possible loss of control and the risk of a vehicle crash. Correction: Transmission will be repaired with a modified parking pawl.
Transport Canada12 giu 19911991092Anni modello 1989–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain vehicles do not comply with CMVSS 108 - Lighting. The resinous reflex reflectors of the front parking/side marker lamps do not meet the photometric requirements of the Standard. Correction: Front parking/side marker lamps will be replaced on affected vehicles.
Transport Canada12 mar 19911991043Anni modello 1989–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, continuous exposure to road salt and chemicals may cause corrosion of the rear suspension components, especially inner arms which could affect the operation and control of the vehicle. Correction: Rear suspension will be inspected and rust proofed or replaced. Note: Recall applies to vehicles in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland.
Transport Canada4 giu 19901990080Anni modello 1984Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain vehicles do not comply with CMVSS 1101(5)(b)(ii) - Fuel Warning Label.
Transport Canada18 lug 19861986080Anni modello 1985–1986Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).