Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Toyota Tercel I

1978–1982 · 2 difetti documentati · 2 mercati

Questo fascicolo raccoglie i difetti noti della Toyota Tercel I, scritti e documentati dalla comunità. La lettura è libera; un account gratuito permette di contribuire. Un difetto ottiene il sigillo quando abbastanza contributori affidabili lo hanno convalidato.

Difetti più gravi

Vedi tutto (2) →
m
ModeratoSospensioniNA

Broken stabilizer bar (US safety investigation)

NHTSA, the US road safety agency, opened a preliminary evaluation (PE89134) into this problem on 3 July 1989 for 1982 models; it was closed on 22 September 1989 without a recall.

✓ Analisi Mecafile di dati ufficiali1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Ultimi richiami ufficiali

Vedi tutto (2) →
RichiamoModeratoSospensioniNA

Suspension:Rear

The lower control arms, which support the rear wheels, are subject to corrosion if operated in areas where a large amount of road salt is used to aid in snow and ice removal. Consequence of defect: Continuous exposure to road salt may cause corrosion failure of the lower control arm affecting vehicle operation; this could result in loss of control and an accident.

NHTSA · Stati Uniti10 mar 198686V038000Anni modello 1980–1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoSospensioniNA

Suspension

Vehicles located ontario, quebec and the maritime provinces. In areas of high corrosion, the rear control arm that supports the rear wheel may rust. Should the vehicle continue to be driven under severe environmental conditions the rusting will progress and the control arms could deform thereby adversely affecting vehicle operation.

Transport Canada30 apr 19851985051Anni modello 1980–1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Ultimi bollettini tecnici

Vedi tutto (12) →
BollettinoModeratoCambioNA

Bollettino

Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance

NHTSA · bollettino del costruttore10234321Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoCarrozzeriaNA

Bollettino

TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.

NHTSA · bollettino del costruttore10173973Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveSospensioniNA

Bollettino

TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.

NHTSA · bollettino del costruttore10173975Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).