Roof side rail airbag may deploy incorrectly
A roof side rail air bag may not deploy as intended
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Vauxhall Nova Corsa E
A roof side rail air bag may not deploy as intended
C'è la possibilità che l'acqua penetri nel tubo di sfiato, con conseguente infiltrazione di acqua nella pompa del vuoto attraverso il cablaggio e nella scatola dei relè. Nel peggiore dei casi, un cortocircuito potrebbe comportare il rischio di incendio.
L'acqua può penetrare nel connettore della scatola dei relè situata sulla pompa del vuoto elettronica, causando un cortocircuito che potrebbe portare a un incendio.
Water ingress to the relay on the electrical vacuum pump may cause a short. In extreme instances this may lead to fire.
The gears within the steering rack may not have been manufactured to the correct specification which may allow them to crack over a period of time. Prolonged use could cause loss of steering control.
A small number of steering knuckles on hub swivels have been manufactured incorrectly. In time these knuckles might fail with the attendant loss of directional control of the vehicle.
THE MANUFACTURER HAS RECOMMENDED THAT AFFECTED VEHICLES ARE NOT DRIVEN UNTIL CHECKED BY THEIR OFFICIAL AGENTS. The steering system may not have been produced according to specification. There is a risk that the steering intermediate shaft may break while driving resulting in the loss of steering control.
There could be an unexpected loss of braking performance due to the ABS/ESP Modulator not being correctly filled with hydraulic oil at the factory.
It has been identified that due to a manufacturing deviation the base material for the telescopic tube of the intermediate steering shaft may lack the required rigidity. This may lead to breakage of the shaft which in the worst case would lead to loss of steering control.
It has been identified that the above vehicles could be affected by moisture ingress at the ABS connector. The moisture can enter through the ground wiring connection which can lead to the ABS not functioning correctly overheating within the connector and in extreme cases a fire.
I veicoli possono essere influenzati da prestazioni errate delle Diagnostiche a bordo relative al sistema di riduzione catalitica selettiva e/o al filtro a particelle diesel. La spia indicatrice di malfunzionamento (MIL) potrebbe non accendersi in caso di malfunzionamento e quindi non rispettare le normative sulle emissioni.
Affected vehicles may exceed regulatory emission standards
On affected vehicles the AC compressor stator wiring could develop a fault leading to current loss inside the AC compressor that could result in a vehicle powertrain shutdown when driving.
Software does not allow the authorities to test according to regulation.
The customer might not be alerted to a malfunction of the turn indicator.
A potential for an intermittent internal connection issue on the DC/DC chip of the on-board charger.
On affected vehicles certain seat belts might stick when pulled out and retracted.
il controllo lambda può portare al superamento del limite di NOx durante la vita del veicolo.
Unexpected opening of the hood while driving.
Due to a possible contamination of the tooth segment the handbrake pawl may not latch correctly. This may cause the handbrake to disengage.
Due to a manufacturing process deviation the toothed rack of the steering gear might break under extensive force application i.e. when manoeuvring at slow speed.
The connection between the steering knuckle and the lower control arm may not be assembled correctly. If this condition is evident the connection could become insecure. The event can happen suddenly and unexpectedly in which case the vehicle is no longer controllable.
Er kan scheurvorming in de tandheugel van de stuurinrichting ontstaan. Hierdoor kan de tandheugel breken.
Het materiaal dat gebruikt is voor de fabricage van de stuurkolomtussenas voldoet niet aan de voorgeschreven specificaties. Hierdoor is de sterkte van de stuurkolomtussenas onvoldoende.
It has been identified that on a certain number of 2007 model year vehicles the front lower suspension control arms might fracture near the bushing due to a production deviation during the welding process. The control arm may then lack rigidity; which may impair driving stability. In the worst case the driver may loose control of the vehicle.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).