技術通報
This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.
🔔 無料アカウントを作成して Audi A8 (すべての世代) のメール通知を受け取る
技術サービス通報(TSB)は、既知の不具合についてメーカーが販売店に送る修理指示です。安全リコールではありませんが、不具合の裏付けになることがよくあります。
This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.
Over time and mileage and under certain conditions, the factory-installed catalysts may not perform as required by Federal regulations. If the effectiveness of a catalyst is reduced, this may result in an increase in tailpipe emissions and the vehicle could fail to pass an emissions inspection. ? Added repair availability for A8 (criteria 4E) and A6 (criteria 4F). ? Updated claiming instructions. ? Note added to repair instructions regarding consequential damage.
Over time and mileage and under certain conditions, the factory-installed catalysts may not perform as required by Federal regulations. If the effectiveness of a catalyst is reduced, this may result in an increase in tailpipe emissions and the vehicle could fail to pass an emissions inspection. Launch repair availability for A8 (criteria 4E) and A6 (criteria 4F).
Over time and mileage and under certain conditions, the factory-installed catalysts may not perform as required by Federal regulations. If the effectiveness of a catalyst is reduced, this may result in an increase in tailpipe emissions and the vehicle could fail to pass an emissions inspection.
Over time and mileage and under certain conditions, the factory-installed catalysts may not perform as required by Federal regulations. If the effectiveness of a catalyst is reduced, this may result in an increase in tailpipe emissions and the vehicle could fail to pass an emissions inspection.
リフト上点検セクション: 取り外し 「ELSAで冷却水リザーバーキャップの圧力試験を実施する -> VIN番号を入力 -> 修理マニュアル Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking」。文書「Cooling System, Checking for Leaks」では、手順「Pressure Relief Valve in Cap, Checking」のみを実施すること。
The oil filter bypass valve on certain 2013 model year Audi 4.0L vehicles may not be present or may have been incorrectly installed during production.
This document contains the notice about an upcoming Service action on the oil filter bypass valve. The oil filter bypass valve may not be present or may have been incorrectly installed during production.
This bulletin provides information when the fuel gauge does not show after filling up tank.
This bulletin provides information when the engine does not run smoothly, misfiring - possible broken valve spring.
This bulletin provides information when the engine does not run smoothly, misfiring - possible broken valve spring.
This bulletin provides information when oil is lost from the filler cap.
This bulletin provides information when there is a loss of coolant from the coolant pump; V6 TFSI.
This bulletin provides information when there is a loss of coolant from the coolant pump; V6 TFSI.
This bulletin provides information for when the engine is misfiring, and not running smoothly with various DTCs, indicating a possible broken valve spring.
This bulletin states that it takes about 20 seconds after switching the ignition on for the Audi Pre Sense symbol advising that "Audi pre sense not available at the moment"
This bulletin provides information for when there is oil found in the engine compartment, front end, and around the filler cap, and a smell is coming from the oil compartment.
Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
VAS-PC Brand V19.47 does not spport engine diagnostic for the 203 A8.ol TDI
Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.
Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Additional component replacement may be necessary to ensure that no contamination or debris remains after repair. Reasons for fuel contamination can include: water ingress in the fuel station?s holding tanks, errors made in fuel transport, or incorrect fuel has been dispensed into the vehicle.
This bulletin advises to replace the membrane in the breather line in instances where oil found in the engine compartment, front end, and around the filler cap, or a smell is detected.
The cooling fans may operate for up to 10 minutes after the engine is turned off. This function is mapped to specific driving patterns and vehicle operating modes (for example, DPF regeneration). This is normal operation, and no parts should be replaced.
There may be slow coolant loss from the connections of the coolant feed pipe and coolant return pipe. High temperatures cause the coolant to become encrusted on the connection flange of the turbocharger (Figure 1).
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。