閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

BMW M8

2019–2025 · 不具合0件 · 3市場

技術サービス通報(TSB)は、既知の不具合についてメーカーが販売店に送る修理指示です。安全リコールではありませんが、不具合の裏付けになることがよくあります。

技術通報中程度エンジンNA

技術通報

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · メーカー通報11002676モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報中程度エンジンNA

技術通報

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · メーカー通報11000498モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報中程度エンジンNA

技術通報

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan

NHTSA · メーカー通報10249015モデルイヤー 2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報中程度エンジンNA

技術通報

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.

NHTSA · メーカー通報10239602モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

Engine Return

NHTSA · メーカー通報11020074モデルイヤー 2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

One of the six engine oil pump mounting screws may not have been tightened with the correct torque.

NHTSA · メーカー通報11014421モデルイヤー 2024原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

Delivery stop: Oil pump screw connection

NHTSA · メーカー通報11012079モデルイヤー 2024原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

The NVLD limited emission related warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles as determined from the original in-service date

NHTSA · メーカー通報11012066モデルイヤー 2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.

NHTSA · メーカー通報10214256モデルイヤー 2018原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

Information updated about engine oil filter cap drain plug. When performing an engine oil service on vehicles equipped with a N63M, N63B or S63M engines; the ETK states to use "Set oil filter element" P/N 11 42 5 A33 C42 or P/N 11 42 5 A33 C43. The part numbers are not available at the moment.

NHTSA · メーカー通報10212785モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

When performing an engine oil service on vehicles equipped with a S63M engine the ETK states to use "Setoil filter element" P/N 11 42 5 A33 C43. P/N 11 42 5 A33 C43 is a new part number that was recently created without current parts availability. Until further notice ONLY use "Set oil filter element" P/N 11 42 7 848 321.

NHTSA · メーカー通報10203332モデルイヤー 2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.

NHTSA · メーカー通報10200228モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · メーカー通報10199292モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · メーカー通報10198899モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

REPLACE ALL THE IGNITION COILS: The ignition coils may not have been produced to specifications which could lead to irregular running of the engine. A manufacturing defect affecting the ignition coil insulation.

NHTSA · メーカー通報10186214モデルイヤー 2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.

NHTSA · メーカー通報10176360モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.

NHTSA · メーカー通報10174320モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).

NHTSA · メーカー通報10172487モデルイヤー 2019–2020原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

Delivery Stop on certain Model Year 2019 and 2020 BMW vehicles that were produced between July 20 2018 and November 2 2019. There is a possibility of contamination in the engine.

NHTSA · メーカー通報10169456モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

HIGH ENGINE SPEED IMMEDIATELY AFTER STARTING. In rare circumstances after the engine is started with the Start-Stop button the engine speed may immediately increase to a high constant RPM (approximately 3000 rpm).

NHTSA · メーカー通報10163031モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · メーカー通報10160336モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報軽微エンジンNA

技術通報

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · メーカー通報10160253モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。