燃料システム、その他:貯蔵:タンクアセンブリ
バイフューエル車:これらの車両は、バイフューエルシステムの取り付け時に損傷している可能性のある燃料タンク給油パイプのグロメットを備えている場合があります。グロメットが損傷していると、燃料が漏れるおそれがあります。点火源がある状態で燃料が漏れると、火災につながるおそれがあります。販売店が燃料タンク給油パイプのグロメットを交換します。
🔔 無料アカウントを作成して Ford コントゥア のメール通知を受け取る
バイフューエル車:これらの車両は、バイフューエルシステムの取り付け時に損傷している可能性のある燃料タンク給油パイプのグロメットを備えている場合があります。グロメットが損傷していると、燃料が漏れるおそれがあります。点火源がある状態で燃料が漏れると、火災につながるおそれがあります。販売店が燃料タンク給油パイプのグロメットを交換します。
On certain vehicles, the fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking. A cracked hose could result in fuel leakage when the vehicle is being fueled. Fuel leakage in sufficient quantity in the presence of an ignition source could potentially result in a fire. Correction: Dealers will install a fuel filler vent hose containing the appropriate blend of PVC and nitrile rubber.
Vehicle description: Passenger vehicles. The fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking.
Vehicle description: Bi-fuel vehicles modified to run on either gasoline or compressed natural gas (cng). The natural gas fuel tanks have a solenoid shut-off valve that stops fuel flow from the fuel tank in the event of certain moderate to severe collisions. If the vehicle is in a collision and the natural gas fuel line is damaged, the system could leak natural gas.
燃料タンク給油口パイプの開口部補強材は、2つの別々に成形された部品をスピン溶接で接合して製作されているため、溶接部から燃料が漏れる可能性があります。点火源が存在する状態で燃料が漏れると、火災につながるおそれがあります。 是正措置:燃料タンクアセンブリは、一体成形の補強材を備えたものに交換されます。
The fuel tank filler pipe opening reinforcement, constructed from two separately molded pieces, can leak at the weld.
The fuel tank filler pipe opening reinforcement can leak at the weld.
The fuel filler opening reinforcement (an integral part of the fuel tank assembly) may leak fuel. In the presence of an ignition source, a fire could result. Correction: Fuel tank will be replaced on affected vehicles.
A metal shield on the outside of the plastic fuel filler pipe can develop a static electrical charge during refueling of the vehicle.
車両概要:2.0Lおよび2.5Lエンジンを搭載した1995年式乗用車、ならびに2.5Lエンジンを搭載した1996年式車両。 エンジン冷却ファンモーターのベアリングが固着し、モーターのストール(停止)に至るまで進行すると、モーターのトルクが増加し、通常より高いモーター電流と、それに伴うモーター温度の上昇を招くおそれがあります。
Vehicle description: Passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the accelerator is released.
Certain vehicles may not comply with CMVSS 1105 - evaporative emissions. The rear fuel lines may allow fuel to seep and evaporate at the metal line to nylon tube joint at the rear of the vehicle near the fuel filter. This may cause evaporative emissions in excess of the standard. Correction: Vehicle will be inspected for signs of fuel escaping a joint between a nylon tube and a metal fuel line. If wetness or fuel odor are detected a reinforcement kit will be installed.
Note: Vehicles equipped with 2.5 litre engines. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Premature failure of the catalyst substrate material in the catalyst and exhaust manifold assemblies (light-off catalysts) can result in restricted exhaust gas flow, loss of power and exhaust emission levels in excess of those specified in the standard. Correction: Left and right hand light-off catalysts will be replaced. Underbody catalyst will be inspected and replaced if necessary.
Note: Only vehicles equipped with the traction control option are involved. The throttle cables on these vehicles may have been damaged during vehicle assembly. This may lead to fraying or separation of the throttle cable, which could prevent the engine from returning to idle. This could adversely affect vehicle control. Correction: Throttle cable will be replaced with a revised design version.
Vehicle description: Passenger vehicles equipped with the traction control option. The throttle cables were damaged during vehicle assembly leading to fraying or separation of the throttle cable.
Defect: These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Correction: Powertrain control module will be replaced on affected vehicles.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。