技術通報
TT: Injector Maintenance Required message shows at approximately 6000 miles.
🔔 無料アカウントを作成して Lexus GS (すべての世代) のメール通知を受け取る
技術サービス通報(TSB)は、既知の不具合についてメーカーが販売店に送る修理指示です。安全リコールではありませんが、不具合の裏付けになることがよくあります。
TT: Injector Maintenance Required message shows at approximately 6000 miles.
TT: Injector Maintenance Required message shows at approximately 6000 miles.
Tt: Injector maintenance required message shows at approximately 6000 miles.
DL: On December 20, 2022, a settlement of claims for certain low pressure fuel pumps was approved by the federal court. The settlement includes Lexus?s agreement to provide a Customer Support Program for certain 2013-2020 model year (MY) vehicles originally equipped with low pressure fuel pumps repaired under Safety Recall 20LA01 or Special Service Campaign 21LC01. The purpose of this Customer Support Program letter is to help clarify how to administer this coverage in accordance with the settlement.
This is to advise of various price adjustments affecting Genuine Lexus Motor Oil and Long-Life Coolant, effective March 1, 2023. These products are ordered through the Lexus Complete Maintenance Care (LCMC) website.
Fuel Delivery Pipe Replacement
接着剤・シーラント 互換表 / エンジン ハイブリッドシステム
接着剤・シーラント 互換表 / エンジン ハイブリッドシステム
Engine Misfire Duplication Procedure - MIL on DTC p030 and /or Intermittently Runs Rough
Engine Misfire Duplication Procedure - MIL on DTC p030 and /or Intermittently Runs Rough
Fuel Injection Active Test Remedy - 2GR-FKS and 8AR-fts
TT: The current engine active test Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. To avoid this condition, technicians should raise engine RPM when changing back and forth between the Direct Injection and Port Injection active tests. Use the recommended procedure below to avoid this concern while testing injection mode of FKS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.
TT: 一部のIS250およびGS300車両では、次のいずれかの状態が発生する場合があります: ・MILの点灯 DTC P0300、P0301、P0302、P0303、P0304、P0305および/またはP0306。 ・エンジンが動作温度にあるときに停車後、断続的にアイドリングが不安定になる。 ・冷間始動後(コールドソーク後)に、断続的にエンジンの失火を伴いながらアイドリングが不安定になる。 注記:本書の推奨事項は、断続的な失火の問題に適用されます。車両に持続的な失火が見られる場合、根本原因は本書で参照しているサービスブルティンとは関係がなく、診断には修理マニュアルを参照してください。
TT: TMS has discovered the current engine active test ?Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS or 8AR-FTS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. In order to avoid this condition, technicians should raise engine RPM when changing from Direct Injection active test to Port Injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2GR-FKS or 8AR-FTS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.
TSB: 2013 ? 2016 年式の一部の FR-S 車両では、エンジンが十分に暖機された状態でアイドリングしている際に、高圧燃料ポンプアセンブリから高音の「チリッ」という音や「キーッ」というきしみ音が発生することがあります。この状態に対処するには、本技術サービス情報の手順に従ってください。
Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: MIL "ON" DTC P0300, P0301, P0302, P0303, P0304, P0305, and or P0306. Intermittently runs rough after coming to a stop with the engine at operating temperature. intermittently runs rough with engine misfires present after a cold soak startup.
Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: MIL ?ON? DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306 Intermittently runs rough after coming to a stop with the engine at operating temperature Intermittently runs rough with engine misfires present after a cold soak startup
Tech Tip: Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: MIL "ON" DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306. Intermittently runs rough after coming to a stop with the engine at operating temperature. Intermittently runs rough with engine misfires present after a cold soak startup. NOTE: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis.
"tt: Tms has discovered the current engine active test control the injection mode is not operating as desired when controlling the direct injectors manually on 2gr-fks or 8ar-fts engines. When direct injection is started and then stopped using the active test, current ecu logic does not turn off the direct injectors and can cause dtcs p017200, p017500 and p0160300. In order to avoid this condition, technicians should raise engine rpm when changing from direct injection active test to port injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2gr-fks or 8ar-fts equipped vehicles. Note: If the active test is used multiple times without using this procedure to raise engine rpm, it may be necessary to reset learning values for fuel trim and air to fuel ratio before returning vehicle to customer."
"tt: Some is250 and gs300 vehicles may exhibit one or more of the following conditions: Mil on dtc p0300, p0301, p0302, p0303, p0304, p0305, and/or p0306. Intermittently runs rough after coming to a stop with the engine at operating temperature. Intermittently runs rough with engine misfires present after a cold soak startup. Note: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis."
Lexus: Is250-gs300: Engine runs rough when coming to a stop, after cold soak start up engine misfires. *lj
Lexus: Vehicle engine runs rough after coming to a stop or misfires. *pe
Lexus: Mil on dtc p030# and/or intermittently runs rough. Engine/hybrid. Engine control. Some vehicles may exhibit one or more of the following conditions. Mil on dtc p0300, p0301, p0302, p0303, p0304, p0305 and/or p0306. Runs rough after stopping with engine at operating temperature; runs rough with engine misfires after cold soak startup. *pe
Ilsac gf-4 engine oil standard. '06 lexus. *tt excluding hybrid vehicles. *tt recommendation. *tt
Repair manual correction for the engine (3uz-fe). 00245-rm112-6u1. *tt
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。