閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

Nissan キューブ

2002–2019 · 2 世代 · 不具合7件 · 4市場
世代

Nissan キューブ のすべての世代をまとめて:不具合、リコール、サービス情報、ディスカッション。世代を選ぶと絞り込めます。

重大な不具合

すべて表示 (7) →

最新の公式リコール

すべて表示 (10) →
キューブ III (2008) · 2008–2019
リコール重大内装UK

Cube (Z12) Driver Airbag

For affected vehicles the Driver's Airbag module may have been incorrectly assembled during production. In this condition the driver’s airbag inflator module may detach from the steering wheel.

DVSA · 英国2026年9月25日R/2026/164モデルイヤー 2008–2010原文(英語)で表示中 · 翻訳待ち詳細を見る →
キューブ III (2008) · 2008–2019
キューブ II · 2002–2008キューブ III (2008) · 2008–2019
リコール重大内装EU

Le gonfleur de l'airbag du conducteur a un joint interne soudé au laser (côté gauche) qui peut ne pas…

Le gonfleur de l'airbag du conducteur a un joint interne soudé au laser (côté gauche) qui peut ne pas tenir de manière fiable pendant le déploiement. cela peut entraîner un risque que le module d'airbag soit séparé du volant lorsqu'il est activé. cela peut entraîner la projection de fragments métalliques à grande vitesse à travers l'airbag à l'intérieur du véhicule, ce qui peut entraîner des blessures graves et même mortelles pour les occupants.

Safety Gate · EU · RappelConso · フランス2026年5月1日sr/01308/26モデルイヤー 2008–2010原文(フランス語)で表示中 · 翻訳待ち詳細を見る →

最新の技術サービス通報

すべて表示 (17) →
キューブ III (2008) · 2008–2019
技術通報軽微その他NA

技術通報

VOLUNTARY SERVICE CAMPAIGN 2009 CUBE OWNERS MANUAL UPDATE Campaign ID # P9223 is no longer active. Repair orders opened after this bulletins published date are no longer eligible for reimbursement under Campaign ID # P9223. Discard all previous versions of NTB09-065.

NHTSA · メーカー通報11036449モデルイヤー 2009原文(英語)で表示中 · 翻訳待ち詳細を見る →
キューブ III (2008) · 2008–2019
技術通報中程度トランスミッションNA

技術通報

DRIVE SHAFT BOOT SERVICE INFORMATION SERVICE INFORMATION If a Drive Shaft (Axle Shaft) Boot on an APPLIED VEHICLE is found to be leaking grease, AND There is no abnormal noise or obvious CV Joint risk due to water intrusion and/or complete grease loss, check for REPAIR KIT-DUST BOOT (CV Joint Boot Kit) availability. If there is a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, do NOT replace the axle. Install a new boot kit following the procedure in the ESM. o Refer to the ESM: TRANSMISSION & DRIVELINE > FRONT AXLE > REMOVAL AND INSTALLATION > FRONT DRIVE SHAFT BOOT o If the complete axle (drive shaft) is replaced when only a new boot is required, the over-repair may be charged back to the dealer. If there is NOT a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, refer to the ESM for further diagnostic information. IMPORTANT: When servicing vehicles with staked axle nuts, refer to NTB21-013 to prevent Drive Shaft thread damage.

NHTSA · メーカー通報10227268モデルイヤー 2016原文(英語)で表示中 · 翻訳待ち詳細を見る →
キューブ III (2008) · 2008–2019
技術通報軽微サスペンションNA

技術通報

SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly (fuel pump assembly). The fuel level sensor can be replaced separately. P0460 (FUEL LEV SEN SLOSH) P0461 (FUEL LEVEL SENSOR) P0462 (FUEL LEVL SEN/CIRC) P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.

NHTSA · メーカー通報10213684モデルイヤー 2016原文(英語)で表示中 · 翻訳待ち詳細を見る →

最新のフォーラム

まだディスカッションはありません。

不具合とディスカッションは世代ごとに整理されています。投稿するには上で世代を選んでください。

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)。