On certain passenger vehicles, if the engine fails to start and the driver keeps the key in the "start" position for an extended period, high current flows through the ignition switch, and this sometimes generates enough heat to melt internal switch parts.
On certain passenger vehicles, if the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and this can sometimes generate enough heat to melt internal switch parts.
On certain passenger vehicles, the rear lamps that provide stop and turn signals and tail lamp functions stop working because of inadequate contact between the bulb and socket. In addition, if one bulbs were to become inoperative while the vehicle was operating in cruise control, the cruise control would disengage when the remaining bulb was activated. If both lamps were to become inoperative, the cruise control would not engage.
Certain vehicles do not comply with the requirements of CMVSS 101- Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Generator Low Voltage" indicator light will not illuminate under low voltage conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Vehicle description: Passenger vehicles. These vehicles do not comply with requirements of fmvss no. 101, "control location, identification, and illumination." the instrument panel backlighting may not function after adjusting the interior light intensity.
Vehicle description: Passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of fmvss no. 101, "controls and displays."
These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The interior lamps may turn on by themselves, five to thirty minutes after the vehicle is started and cannot be turned off by the switch. The lamp control module will turn them off after thirty minutes. If the interior lamps turn on while the vehicle is being driven at night, the increased glare could make it more difficult to see objects outside the vehicle. Correction: Lamp control module will be tested and replaced if necessary.
These vehicles may not comply with c.M.V.S.S. 108 - lighting equipment. Vehicles may exhibit a condition in which the front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. Correction: Vehicles will be inspected and hazard lamp switch replaced if necessary.
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with fmvss no. 108, "lamps, reflective devices, and associated equipment."
Note: Vehicles with automatic transmissions. These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The instrument panel trim plate may sag and cover the light emitting diode of the shift indicator display. If this occurs, the driver may not be able to determine the actual position of the transaxle gear selector and could inadvertently leave an idling vehicle in drive, reverse or neutral rather than in park. This could result in a vehicle crash. Correction: A new instrument panel cluster trim plate/bezel assembly will be installed on affected vehicles.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。