무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

BMW M8

2019–2025 · 결함 0건 · 3개 시장

기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.

연식
공지보통엔진NA

공지

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · 제조사 공지11002676연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · 제조사 공지11000498연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan

NHTSA · 제조사 공지10249015연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.

NHTSA · 제조사 공지10239602연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Engine Return

NHTSA · 제조사 공지11020074연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

One of the six engine oil pump mounting screws may not have been tightened with the correct torque.

NHTSA · 제조사 공지11014421연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Delivery stop: Oil pump screw connection

NHTSA · 제조사 공지11012079연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

The NVLD limited emission related warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles as determined from the original in-service date

NHTSA · 제조사 공지11012066연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.

NHTSA · 제조사 공지10214256연식 2018원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Information updated about engine oil filter cap drain plug. When performing an engine oil service on vehicles equipped with a N63M, N63B or S63M engines; the ETK states to use "Set oil filter element" P/N 11 42 5 A33 C42 or P/N 11 42 5 A33 C43. The part numbers are not available at the moment.

NHTSA · 제조사 공지10212785연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

When performing an engine oil service on vehicles equipped with a S63M engine the ETK states to use "Setoil filter element" P/N 11 42 5 A33 C43. P/N 11 42 5 A33 C43 is a new part number that was recently created without current parts availability. Until further notice ONLY use "Set oil filter element" P/N 11 42 7 848 321.

NHTSA · 제조사 공지10203332연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.

NHTSA · 제조사 공지10200228연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · 제조사 공지10199292연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · 제조사 공지10198899연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

REPLACE ALL THE IGNITION COILS: The ignition coils may not have been produced to specifications which could lead to irregular running of the engine. A manufacturing defect affecting the ignition coil insulation.

NHTSA · 제조사 공지10186214연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.

NHTSA · 제조사 공지10176360연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.

NHTSA · 제조사 공지10174320연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).

NHTSA · 제조사 공지10172487연식 2019–2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Delivery Stop on certain Model Year 2019 and 2020 BMW vehicles that were produced between July 20 2018 and November 2 2019. There is a possibility of contamination in the engine.

NHTSA · 제조사 공지10169456연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

HIGH ENGINE SPEED IMMEDIATELY AFTER STARTING. In rare circumstances after the engine is started with the Start-Stop button the engine speed may immediately increase to a high constant RPM (approximately 3000 rpm).

NHTSA · 제조사 공지10163031연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · 제조사 공지10160336연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · 제조사 공지10160253연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).