Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.
NHTSA · 제조사 공지11034449연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Several complaints are possible: Vehicle does not start Gear cannot be engaged Various Check Control Messages Malfunction indicator lamp (MIL) on Several Check Control messages are possible: It is possible to continue driving. High-voltage system. You can continue driving. Drivetrain. Restart not possible. Drivetrain fault. Call Roadside Assistance. Drivetrain failure. Information: Total error of vehicle. The following fault memory entries are stored in the CCU: D796D9 - Message (- 0x91) not up-to-date, receiver CCU, transmitter EME D796DC - No message (- 0x91), receiver CCU, transmitter EME D796D8 - No message (- 0x91), receiver CCU, transmitter EME Other fault codes below may be stored in the EGS BA09B8 Inverter, Voltage Sensor, 5V HV AUX: Out of range or open connection detected BA0A45 ECU internal: Internal error of the synchronous serial data bus. Additional fault memory entries are possible. Similar fault memory entries indicating a missing EMEmessage (Traction E-Machine Electronic) can also be stored in other control units.
NHTSA · 제조사 공지11030054연식 2026원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
BMW AG has decided on a service campaign for certain vehicles from the G0x, G12 and G20 series. Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according to the vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehicles enter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, the power of the starter motor decreases. As a result, the engine does not start.
NHTSA · 제조사 공지11013434연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.
NHTSA · 제조사 공지11008104연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · 제조사 공지11006766연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.
NHTSA · 제조사 공지11006719연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · 제조사 공지11002858연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · 제조사 공지11000500연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
?BMW AG has issued a Delivery Stop (effective July 12, 2023) on certain Model Year 2023 - 2024 BMW vehicles that were produced between July 21, 2022, and July 11, 2023. A software logic error in the diagnostic module for tank leaks (DMTL) could cause the Service Engine Soon light (MIL) to not turn on when there is an electrical fault with pump or diverter valve for the DMTL even after several driving cycles with the fault/s being currently present.
NHTSA · 제조사 공지10242687연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
BMW AG has issued a Delivery Stop (effective July 12, 2023) on certain Model Year 2023 - 2024 BMW vehicles that were produced between July 21, 2022, and July 11, 2023. A software logic error in the diagnostic module for tank leaks (DMTL) could cause the Service Engine Soon light (MIL) to not turn on when there is an electrical fault with pump or diverter valve for the DMTL even after several driving cycles with the fault/s being currently present.
NHTSA · 제조사 공지10241365연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Butt connector for repairing a plug connection. The ?top up coolant? message is displayed in the central display (CC message ID 166). When checking the cooling system there are no leaks found and the expansion tank is filled to the proper level.
NHTSA · 제조사 공지10193494연식 2013원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full: Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full.There are no faults stored in the system for the washer fluid level switch.
NHTSA · 제조사 공지10184584연식 2018원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
KAFAS04 (CAMERA-BASED DRIVER ASSISTANCE SYSTEMS) LIMITATIONS: Various functions of the KAFAS (without radar installed) are not operating up to customer expectations.
NHTSA · 제조사 공지10175290연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
ENGINE DOES NOT START BELOW FREEZING TEMPERATURES: Engine designation correction Parts availability Warranty. The engine will not start at temperatures below freezing. The starter does not turn and engage.
NHTSA · 제조사 공지10170572연식 2018원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
HU-H3 MGU 헤드 유닛이 시작되지 않음, CID 화면이 계속 검은색으로 남음: 점화 스위치를 잠시 끄고 차량이 절전 모드(sleep mode)로 들어가지 않은 상태에서는 MGU(Media Graphics Unit) 헤드 유닛이 시작되지 않습니다. CID 디스플레이 화면은 계속 검은색으로 남습니다.
NHTSA · 제조사 공지10166391연식 2019자동 번역 · 원문: 영어자세히 보기 →
ERRONEOUS FAULT 1F2505 IS STORED IN THE DME This Service Information bulletin replaces SI B12 30 18 dated November 2018. This fault does not cause any drivability complaints or engine warning lamps.
NHTSA · 제조사 공지10163998연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
NHTSA · 제조사 공지10160330연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
NHTSA · 제조사 공지10160247연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
SERVICE ACTION: PROGRAM DYNAMIC STABILITY CONTROL SYSTEM (DSC). During certain faults in the Dynamic Stability System (DSC) a yellow warning light could be illuminated instead of a red warning light. Software error in the DSC
NHTSA · 제조사 공지10153697연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
"The calendar page has flipped to November and we are pleased to announce that you can now deliver and retail RDR the all new X5 (G05) once you have remedied all recalls/delivery stops. As previously communicated, ALL G05s will need to be flashed with updated software to enhance the customer experience - I-Level S18A-11-523. This straightforward appx. 45 minute flashing procedure will remedy either or BOTH the open KAFAS and BDC control unit stop sales (same remedy for each). Additionally, there a small number of G05s that will require more extensive technical service campaigns, thereof the most time consuming is the baffle seal repair (if applicable). Limited parts will be available next week for the baffle seal repair and BMW will reimburse dealers $260 for 1 month of floorplan expense on the baffle seal impacted vehicles only due to the delay of parts availability. BMW will automatically push that reimbursement out to affected dealers on the November parts statement. Attached are the latest details on all of the campaigns."
NHTSA · 제조사 공지10152653연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
ERRONEOUS FAULT 1F2505 IS STORED IN THE DME. The following fault is erroneously store in the Digital Motor Electronics (DME). ??FC 1F2505 - DME, encoding: Self-detection components implausible. This fault does not cause any drivability complaints or engine warning lamps. This fault is normally detected during unrelated work An error in the DME software.
NHTSA · 제조사 공지10152659연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
"The crankcase ventilation connection line may deteriorate prematurely causing any of the following: vacuum leak various fault codes related to mixture control stored in the DME customer complaints about rough idle speed Check Engine Light illumination. AFFECTED VEHICLES This Service Action involves certain E70 X5 M and E71 X6 M vehicles produced from March 1, 2011 to July 23, 2014. Vehicles which require this Service Action to be completed will show it as ""Open"" when checked either in the ""Service Menu"" of DCSnet (Dealer Communication System) or with the Key Reader."
NHTSA · 제조사 공지10151246연식 2013원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
N55: Engine Difficult to Start at Cold Ambient Temperatures. The complaint may include any of the following symptoms: * The engine stalls immediately after a cold start before driving away * The engine may run roughly or misfire after a cold start * The engine does not start cold or may take several attempts * To assist starting when cold, the accelerator may need to be depressed slightly and the idle speed raised for a few seconds so the engine does not stall This can occur most frequently at outside ambient temperatures between -15C and + 15C. It is possible that the Service Engine Soon (MIL) lamp is on with misfire fault(s) stored, but it is equally possible that there will be no faults stored in the DME. Unfavorable DME software Cold start or idling problems may arise due to poor fuel quality. The use of summer fuel during cold outside temperatures may also lead to such problems.
NHTSA · 제조사 공지10150161연식 2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).