안전벨트
일부 승용차량은 선바이저에 위치한 에어백 라벨이 적용되어 있으며, 연방 자동차 안전 기준 No. 208 "탑승자 충돌 보호"를 준수하지 않습니다. 이러한 차량의 메시지 영역은 30cm 미만으로, 해당 기준의 요건을 충족하지 않습니다.
🔔 무료 계정을 만들고 Buick Century (모든 세대) 이메일 알림 받기
일부 승용차량은 선바이저에 위치한 에어백 라벨이 적용되어 있으며, 연방 자동차 안전 기준 No. 208 "탑승자 충돌 보호"를 준수하지 않습니다. 이러한 차량의 메시지 영역은 30cm 미만으로, 해당 기준의 요건을 충족하지 않습니다.
Vehicle description: Passenger vehicles. Some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.
Vehicle description: Passenger vehicles. The clamp that secures the flexible fuel fill hose to the metal fill tube may be loose and could separate.
Some of these vehicles with the key in the "on" position, exhibit a condition in which the antilock brake system (abs) motor shorts to its case and grounds through a flexible brake fluid pipe.
Note: Vehicles located in ontario(4) and british columbia(1). These vehicles may have an under torqued right hand front spindle nut. If this nut were to fall off, the wheel could separate from the vehicle possibly resulting in a crash without prior warning. Correction: Vehicles will be inspected and if the right hand front spindle nut is under torqued, the wheel bearing assembly and nut will be replaced.
The right hand spindle nut was not properly tightened during assembly. This can cause premature wheel bearing failure and over time, the spindle can fracture.
The power door lock relay on these vehicles can short internally due to water intrusion. This condition may result in a vehicle fire. Correction: Power door lock relay and any corroded terminals will be replaced. In addition, the new relay will be relocated to an area where water intrusion is less likely
Water intrusion can cause a short circuit in the power door lock assembly.
전동 시트나 리클라이너 배선 하니스가 좌석 프레임이나 스프링 지지봉에 끼이거나 긁혀 전선 절연체를 마모시키고 전기 단락을 일으킬 수 있습니다.
The fuel feed hose could leak at the coupling on the engine end of the hose assembly. This condition could allow fuel to leak into the engine compartment and possibly result in an engine compartment fire. Correction: Fuel feed hose assembly will be inspected and replaced if necessary with a new hose assembly.
Fuel feed hose could leak at the coupling on the engine end of the hose assembly.
Front suspension lower control arm bracket could develop metal cracks.
On certain vehicles, excessive enlargement of a pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate possibly leading to loss of brake fluid in the rear brakes and loss of rear braking capability.this Would result in increased stopping distances and possible crash. note: vehicles in ontario and quebec only.
The generator "bat" terminal located on the rectifier end frame may contact the carburetor fuel inlet pipe. Consequence of defect: The "bat" stud may rub through the terminal boot and contact the fuel pipe which could result in an underhood fire and cause burn injuries to the occupant.
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
2.5리터 엔진 차량의 경우. 연료 시스템이 스로틀 바디 분사 연료 공급 파이프 연결부에서 누유가 발생할 수 있어 보닛 아래 화재 가능성을 제기합니다.
연료 시스템은 스로틀 바디 분사 연료 공급 파이프 연결 부에서 누수가 발생할 수 있습니다. 결함의 결과: 이 누출은 후드 아래 화재를 초래할 수 있으며, 이는 승객 구역으로 번져 탑승자에게 화상 부상을 입힐 수 있습니다.
The axle retaining "c" clip in the differential may dislodge and allow the axle, wheel and brake drum to separate from the vehicle when subjected to side forces. Axle separation could result in loss of vehicle control and possible crash.
The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
근정 조건에서 연료 탱크 주입구 파이프와 연료 탱크 통기 파이프의 호스 클램프가 파손될 수 있습니다. 이러한 클램프가 파손되면 네 개의 파이프-호스 연결부 중 어느 곳에서든 연료가 누출될 수 있습니다. 누출은 주유 중에 또는 연료 탱크가 3/4 이상 찬 상태에서 주행하는 동안 발생할 수 있습니다.
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
"tx" heavy duty wheels may have been manufactured with laminated steel. The wheel disc may fracture and the wheel and tire could partially or completely separate from the vehicle.
일부 승용차는 연방 자동차 안전 기준 제108호 "램프, 반사 장치 및 관련 장비"의 요건을 충족하지 않습니다. 이러한 차량 중 일부는 오버헤드 표지판 조명 요건을 충족하지 않습니다.
차량 일부가 CMVSS 101 - 제어장치 및 표시장치의 위치와 식별 요건을 충족하지 않습니다. 해당 차량은 저유압 또는 무유압 상태에서 "오일 경고등"이 점등되지 않는 현상을 보입니다. 시정 조치: 딜러가 새로운 교정 소프트웨어로 차량 PCM을 재플래시(reflash)합니다.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).