서스펜션
차량의 휠 로크 너트가 조립 과정에서 규정 토크로 조여지지 않았을 수 있습니다. 이로 인해 휠 스터드가 파손될 수 있으며, 그 결과 휠이 차량에서 분리될 수 있습니다. 이러한 현상이 주행 중에 발생하면 사전 경고 없이 충돌 사고가 일어날 수 있습니다. 시정 조치: 휠 로크 너트를 규정 토크로 조이도록 하겠습니다.
🔔 무료 계정을 만들고 Buick 로드마스터 (모든 세대) 이메일 알림 받기
차량의 휠 로크 너트가 조립 과정에서 규정 토크로 조여지지 않았을 수 있습니다. 이로 인해 휠 스터드가 파손될 수 있으며, 그 결과 휠이 차량에서 분리될 수 있습니다. 이러한 현상이 주행 중에 발생하면 사전 경고 없이 충돌 사고가 일어날 수 있습니다. 시정 조치: 휠 로크 너트를 규정 토크로 조이도록 하겠습니다.
휠 너트(lug nut)가 조립 과정에서 올바른 토크 사양에 맞게 체결되지 않았습니다.
The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.
The fuel tank attachment strap fasteners were not properly tightened. The fasteners can completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.
Paint on the wheel mounting surfaces can act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.
On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.
The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing can eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.
ABS 모듈레이터가 부식되어 앞 브레이크 회로에서 오일이 누출될 수 있습니다. 브레이크 오일이 누출되면 제동 성능이 떨어지고 제동 거리가 길어질 수 있습니다. 이로 인해 사전 경고 없이 충돌 사고가 발생할 수 있습니다. 시정 조치: 딜러는 ABS 모듈레이터에 있는 기존 부식을 제거하고, 향후 부식을 방지하는 키트를 설치합니다.
차량 설명: 승용차. 차량용 잠김 방지 브레이크 시스템(ABS) 모듈레이터가 부식되어 앞 브레이크 회로에서 오일이 누출될 수 있습니다.
참고: Caprice 경찰 세단, 택시, 특수 서비스 왜건, Fleetwood 영구차 및 리무진이 포함됩니다. 프론트 로어 컨트롤 암 볼 조인트 체결 부위가 느슨해질 수 있습니다. 이 상태는 로어 컨트롤 암 볼 조인트가 풀리고, 피로가 누적되어 프론트 서스펜션 너클에서 분리되는 원인이 될 수 있습니다. 차량이 주행 중일 때 분리가 발생하면 차량 제어력을 잃을 수 있으며, 이로 인해 차량 충돌 사고가 발생할 수 있습니다. 시정 조치: 프론트 로어 컨트롤 암 볼 조인트 체결 너트의 적정 토크를 점검합니다. 볼 조인트가 너클에서 느슨해진 경우, 볼 조인트와 너클을 모두 교체합니다.
Defective lower control arm ball joint attachment nuts were not properly torqued and can loosen.
These vehicles do not comply with c.M.V.S.S. 102 - transmission shift control sequence. A misadjusted transmission shift control linkage may allow the transmission to be shifted out of the "p"(park) position with the ignition key removed. In the event of this condition occurring, the vehicle may roll from its parked position and cause potential damage and/or injury. Correction: Shift control linkage system will be adjusted.
These vehicles were produced with an improperly adjusted transmission shift control linkage. This does not meet with the requirements of fmvss no. 114, "theft protection."
Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.
These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.
어깨 벨트 가이드 루프의 플라스틱 커버가 갈라져 강철 서브 플레이트가 노출될 수 있습니다.
Note: 1991 caprice sedans and wagons and roadmaster wagons and 1992 roadmaster sedans. The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate. In the event of a severe vehicle crash, the exposed steel sub-plate may cut the safety belt webbing and result in an increased possibility and/or severity of injury to the affected seat occupant. Correction: New shoulder belt guide loops will be installed on involved vehicles.
The secondary hood latches on these vehicles can corrode causing a very high latch release effort and possibly preventing the hood from latching properly when it is closed. If the secondary hood latch is not properly engaged the hood could open unexpectedly. If this were to occur while the vehicle was in motion, the driver's forward vision would be impaired possibly resulting in a vehicle crash. Correction: A new scondary hood latch assembly with improved corrosion resistance will be installed on affected vehicles.
Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.
These vehicles were shipped with both the supplemental inflatable restraint caution label and a roof rack caution label installed on the same side of the sun visor. This does not meet the requirements of fmvss no.208, "occupant crash protection."
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).