These vehicles may not comply with c.M.V.S.S. 301 - fuel system integrity. Some welds in the left rear quarter panel may have been missed during assembly. In the event of a vehicle crash, the vehicle sheet metal structure may not perform as designed. This could result in unexpected damage to the fuel tank or fuel lines and leakage of fuel. If there is a fuel leak and an ignition source, a fire could occur. Correction: Dealers will inspect for missing welds and, if necessary, place three welds between the involved panels.
캐나다 교통부1996년 10월 30일1996173연식 1997원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
During assembly of the left rear quarter panel, some welds were missed. This does not comply with the requirements of fmvss no. 301, "fuel system integrity."
NHTSA · 미국1996년 10월 30일96V212000연식 1997원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
These vehicles were constructed with welds in the rear compartment pan assembly that are not sufficient to comply with the requirements pertaining to fuel tank leakage in the event of a rear impact collision. The fuel tank assemblies do not comply with fmvss no. 301, "fuel system integrity."
NHTSA · 미국1994년 7월 1일94V122000연식 1994원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicles may have improperly torqued connections of the front fuel feed/return hoses to the fuel pipes at the body rail. A fitting may loosen enough to leak fuel into the underhood area, and, in the presence of an ignition source, a fire could result. Correction: Front fuel feed/return hose fittings will be properly torqued.
캐나다 교통부1990년 6월 11일1990083연식 1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On vehicles with quad 4 engines, the front fuel feed assembly could crack or separate at the coupling on the engine end of the assembly, allowing fuel to leak into the underhood area. This would create the possibility of an engine compartment fire. Correction: Front fuel feed hose assembly will be replaced on affected vehicles.
캐나다 교통부1990년 3월 7일1990043연식 1988–1989원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Front fuel feed hose assembly could crack or separate at the coupling on the engine end of the hose assembly, allowing fuel to leak into the engine compartment.
NHTSA · 미국1990년 3월 5일90V042000연식 1988–1989원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
근정 조건에서 연료 탱크 주입구 파이프와 연료 탱크 통기 파이프의 호스 클램프가 파손될 수 있습니다. 이러한 클램프가 파손되면 네 개의 파이프-호스 연결부 중 어느 곳에서든 연료가 누출될 수 있습니다. 누출은 주유 중에 또는 연료 탱크가 3/4 이상 찬 상태에서 주행하는 동안 발생할 수 있습니다.
NHTSA · 미국1982년 3월 8일82V021000연식 1982자동 번역 · 원문: 영어자세히 보기 →
These vehicles do not comply with c.M.V.S.S. 301 - fuel system integrity. Rear compartment pan welds may not meet manufacturing standards. Correction: Dealers are to install rivets adjacent to the locations where suspect welds may have occurred.
캐나다 교통부1994년 7월 20일1994117연식 1994원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The vehicles were assembled with an incorrect suspension upper spring seat at the right-rear position. If the vehicle is involved in a rear impact accident, the right-hand rear wheel house flange could sever the fuel tank filler pipe and spill fuel.
NHTSA · 미국1992년 7월 17일92V106000연식 1992원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Note: Vehicles equipped with 2.3 litre engine. In sub zero temperatures, moisture from the crankcase ventilation system could cause ice buildup behind the throttle blade thereby preventing the throttle from returning to idle when the accerator pedal is released. This could result in loss of vehicle control. Correction: An engine ventilation kit will be installed on affected vehicles to prevent moisture accumulation in the crankcase.
캐나다 교통부1991년 12월 12일1991174연식 1988원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain vehicles may not comply with CMVSS 1103 - Exhaust Emissions. Cracks may develop in the casing of the integrated direct ignition coil. Correction: Ignition coils will be inspected and replaced if necessary.
캐나다 교통부1991년 3월 5일1991037연식 1988–1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. - mass airflow sensor failure - note : Vehicles with 3.0 litre and 3.8 litre engines.
캐나다 교통부1987년 1월 27일1987007연식 1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Fuel hoses may be incorrectly positioned and contact the right front drive axle boot during vehicle operation. After a period of time, the rotating boot could wear a hole in the fuel hose, resulting in fule leakage.
NHTSA · 미국1979년 4월 5일79V091000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
These vehicles do not comply with c.M.V.S.S. 1101 - emission device. Unilingual unleaded fuel label.
캐나다 교통부1989년 9월 29일1989139연식 1989원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).