리콜
2.5리터 엔진 차량의 경우. 연료 시스템이 스로틀 바디 분사 연료 공급 파이프 연결부에서 누유가 발생할 수 있어 보닛 아래 화재 가능성을 제기합니다.
🔔 무료 계정을 만들고 Chevrolet Citation (모든 세대) 이메일 알림 받기
2.5리터 엔진 차량의 경우. 연료 시스템이 스로틀 바디 분사 연료 공급 파이프 연결부에서 누유가 발생할 수 있어 보닛 아래 화재 가능성을 제기합니다.
연료 시스템은 스로틀 바디 분사 연료 공급 파이프 연결 부에서 누수가 발생할 수 있습니다. 결함의 결과: 이 누출은 후드 아래 화재를 초래할 수 있으며, 이는 승객 구역으로 번져 탑승자에게 화상 부상을 입힐 수 있습니다.
The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
근정 조건에서 연료 탱크 주입구 파이프와 연료 탱크 통기 파이프의 호스 클램프가 파손될 수 있습니다. 이러한 클램프가 파손되면 네 개의 파이프-호스 연결부 중 어느 곳에서든 연료가 누출될 수 있습니다. 누출은 주유 중에 또는 연료 탱크가 3/4 이상 찬 상태에서 주행하는 동안 발생할 수 있습니다.
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. Continued operation of the vehicle may result in wear through of the insulation on the clutch cable. The resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.
Vehicles equipped with 4 speed manual transmissions. The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. This could eventually result in the failure of the brake pipe causing loss of brake fluid and due to the dual braking system, a partial loss of braking action. Should a partial loss ob braking action occur while the vehicle is in motion at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.
Vehicles equipped with v6 engines and power steering may have the power steering hoses incorrectly routed. This condition may allow the hoses to contact the exhaust manifold possibly resulting in hose failure. It is possible that power steering fluid could leak onto the manifold resulting in smoke and under hood fire. Such a fire could spread to the passenger compartment.
Vehicles equipped with automatic transmissions. The automatic transmission cooler line hoses may fail during vehicle operation. Transmission fluid leakage in the engine compartment may result in a vehicle fire.
There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.
The throttle linkage may bind because during normal operation, the throttle body case may interfere with the linkage. This interference could prevent the throttle from closing even though the driver has removed his foot from the accelerator pedal.
THE THROTTLE LINKAGE RETAINING CLIP MAY INTERFERE WITH THE THROTTLE BODY CASTING DURING NORMAL ROTATION OF THE THROTTLE LEVER. THIS COULD ALLOW THE ACCELERATOR LINKAGE TO BIND AND PREVENT THE THROTTLE FROM CLOSING. iF THIS WERE TO OCCUR, VEHICLE SPEED WOULD REMAIN CONSTANT EVEN THOUGH THE DRIVER HAS REMOVED HIS FOOT FROM THE ACCELERATOR PEDAL. LOSS OF ACCELERATOR CONTROL COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.
On certain vehicles, the front seat back locks may not lock under forward load conditions and are therefore not in compliance with CMVSS 207 - Seat Anchorages.
The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
These vehicles may experience premature rear wheel skid when the brake pedal is applied. The absence of any corrective steering or braking action on the part of the driver could cause the rear of the vehicle to skid out of its lane of travel.
Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.
Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".
These vehicles do not comply with cmvss 1103 - hydrocarbon and co.
Vehicles with manual transmissions. A low spring load on the pawl to engage quadrant teeth of the self adjusting clutch mechanism will result in slippage and prevent clutch release when the pedal is depressed to the floor.
Vehicles with manual transmissions. Vehicles may be equipped with defective brake proportioner valves which could cause the rear brakes to lock up prematurely during high deceleration braking. This could result in loss of vehicle control and vehicle crash without prior warning.
Under certain conditions, the rear brakes could lock up without prior warning during high deceleration braking. The problem may be caused by defective proportioner valves in the braking system.
The terminal that attaches the engine to body ground cable to the front lower tie bar may fracture resulting in reduced voltage to body grounded electrical components and cause erratic operation of the components.
The engine-to-body ground cable on certain vehicles may have been damaged during manufacture. The cable could eventually break due to the relative motion between the engine and body during vehicle operation.
The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto the exhaust manifold.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).