조향: 스티어링 휠/핸들바
상부 조향 칼럼 샤프트 커플링 볼트에 아연 도금 작업이 이루어져 수소 취성과 볼트 파손이 발생했습니다.
🔔 무료 계정을 만들고 Chrysler LeBaron (모든 세대) 이메일 알림 받기
상부 조향 칼럼 샤프트 커플링 볼트에 아연 도금 작업이 이루어져 수소 취성과 볼트 파손이 발생했습니다.
스티어링 칼럼 커플링 볼트는 수소 취성으로 인해 파손될 수 있으며, 이로 인해 스티어링 칼럼 샤프트 커플링의 클램핑 하중이 손실되고 그로 인해 조향 제어가 상실됩니다. 정정: 아연 도금 스티어링 칼럼 커플링 볼트는 인산염 코팅 볼트로 교체됩니다.
Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
엔진 밸브 커버 가스켓이 이탈(위치 이탈)하여 가스켓 부위에서 엔진 오일이 새는 현상이 발생할 수 있습니다.
차량 2.2리터 또는 2.5리터 EFI(비터보) 엔진 탑재 차량에서 밸브 커버 가스켓이 누유되어 엔진룸 화재가 발생할 가능성이 있습니다. 시정 조치: 밸브 커버 가스켓을 개선된 커버로 교체하고, 가스켓 대신 RTV 실란트를 도포합니다.
연료 누출은 저온 환경에서 운전할 때 엔진룸 연료 공급 호스와 압력 조절기 및 연료 레일의 연결부에서 발생할 수 있습니다.
A resister in the instrument cluster may be subjected to an electrical current overload due to failure of a switching transister.The overheated resister could possibly start a fire in the instrument panel.
계기판 전자 클러스터의 저항기가 스위칭 트랜지스터의 고장으로 인해 과전류에 노출될 수 있습니다. 결함의 결과: 과열된 저항기가 발화하여 계기판 화재를 일으킬 수 있습니다.
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
The potential for fuel leakage exists in the engine compartment at the fuel reservoir seam and its hose connections. The fuel reservoir is a silver colored can mounted to the air cleaner.
On certain vehicles, hydraulic brake tube may interfere with exhaust system hangar bolt and eventually result in brake fluid leakage. This could create a partial loss of braking capability. Should this occur the brake warning light on the instrument panel will warn driver.
Hydraulic brake tube routing to the rear wheels may alloow interference between the tube and the rear park brake cable. Resulting abrasion could cause tube failure and partial loss of braking capability. The instrument panel light will provide warning of the partial loss.
These vehicles may not comply with c.M.V.S.S 207 - anchorage of seats. The travelling seat buckle lock bars (seat belt anchors) on some vehicles equipped with bucket seats may have inadequate strength and may not meet the static load requirements of the standard. Correction: Lock bar assemblies will be replaced.
An improperly adjusted hood latch assembly could prevent engagement of the secondary latching mechanism. In such a case the secondary latch would not function to restrain the hood in the event that the primary latch was not engaged for any reason and hood fly-up could occur, blocking the driver's vision. Correction: Secondary hood latch will be inspected and adjusted if necessary, to ensure proper engagement.
The hood latch assembly may not have been properly installed and the secondary hood latch may be prevented from engaging when the hood is closed.
In areas of high road salt use, vehicles may experience a bonded disc brake pad separation from the front or rear brake plates. This could cause a reduction in brake performance and a possible vehicle crash. Correction: Bonded disc brake linings will be replaced on affected vehicles.
The bonded disc brake linings may separate from the shoes due to a bonding deficiency which may allow corrosion degradation of the bond attachment.
Parking brake cables may be mismatched in length resulting in reduced parking brake application on one wheel and so may not comply with c.M.V.S.S. 105-hydraulic brake systems. Correction: Vehicles will be inspected and those with mismatched cables will have the longer cable replaced with a shorter version.
On vehicles with a 50/50 bench seat, the front outboard passenger seat belt may become difficult to latch and/ or unlatch due to a belt webbing stiffener which could enter the buckle housing and dislodge the buckle latch guide. This could also result in partial latch engagement. Correction: Buckle assembly will be replaced with a revised version if necessary.
Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.
Mismatched parking brake cable lengths to the rear wheels reduces braking ability of one of the rear wheels, in violation of fmvss 105.
노트: 온타리오, 퀘벡, 뉴브런즈윅, 노바스코샤, 프린스에드워드아일랜드, 뉴펀들랜드 지역에 있는 차량입니다. 주간주행등(DRL) 모듈의 부식 고장으로 인해 이 차량들은 C.M.V.S.S. 108 - 조명 기준을 준수하지 못할 수 있습니다. 시정 조치: 기존에 노출되어 있던 모든 부품을 덮는 추가 포팅 재료가 적용된 DRL 모듈로 교체됩니다.
두 개의 에어백 시스템 전면 충돌 센서가 장착 브래킷에 제대로 고정되어 있지 않을 수 있습니다.
앞 디스크 캘리퍼 가이드 볼트가 규정 토크로 충분히 조여지지 않았을 수 있습니다. 이로 인해 제동 기능에 어느 정도 이상이 발생할 가능성이 있습니다. 시정 조치: 앞 브레이크 캘리퍼 가이드 핀 볼트는 규정 토크로 체결될 예정입니다.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).