Over time partial wear of the gearbox control harnesses may occur due to contact with surrounding components. Gear selection may be affected as a result of electrical faults in some rare cases including the lighting of the warning lamp on the instrument panel and the driveability of the vehicle may be compromised.
DVSA · 영국2013년 10월 1일R/2013/106연식 2008–2010원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
It has been established that the con-rod (big end) shell bearings may not have been manufactured to specification. This could lead to premature deterioration of the shells and if not identified it could result in engine failure.
DVSA · 영국2012년 11월 14일R/2012/129연식 2010원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Over a period of time a small crack can appear on the rear axle cross member particularly under conditions of repeated maximum suspension travel. The small crack could increase in size and eventually lead to the rear wheel rubbing on the wheel arch.
DVSA · 영국2012년 10월 22일R/2012/099연식 2008–2010원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Due to incorrect machining it is possible that the crankshaft is not to the correct specification which can lead to insufficient lubrication of the crankshaft and subsequent engine failure.
DVSA · 영국2010년 11월 5일R/2010/192연식 2010원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).