The pressure regulator installed in the fuel supply plumbing system may be the source of fuel leakage which can cause an engine compartment fire. Correction: Fuel supply system pressure regulator and associated plumbing will be replaced with components of another configuration.
캐나다 교통부1991년 8월 13일1991114연식 1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
캐나다 교통부1985년 2월 5일1985021연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
NHTSA · 미국1985년 1월 1일85V010000연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The potential for fuel leakage exists in the engine compartment at the fuel reservoir seam and its hose connections. The fuel reservoir is a silver colored can mounted to the air cleaner.
NHTSA · 미국1984년 11월 21일84V147000연식 1984–1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Rear suspension trailing arm-to-hanger bracket pivot bolts may fail from stress corrosion cracking possibly caused by processing deviations in the construction of the pivot bolt.
NHTSA · 미국1991년 4월 11일91V056000연식 1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
These vehicles may experience a rear suspension trailing arm to hangar bracket pivot bolt failure, which could result in partial separation of the rear suspension from the vehicle. This could result in loss of vehicle control and a vehicle crash without prior warning. Correction: Involved vehicles will have both trailing arm pivot bolts replaced with properly processed bolts.
캐나다 교통부1991년 4월 8일1991060연식 1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Plugged choke vacuum delay valve. Note: Vehicles equipped with 2.2 litre carbureted engines.
캐나다 교통부1987년 1월 6일1987001연식 1985–1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
NHTSA · 미국1986년 4월 10일86V053000연식 1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
An emissions system valve may allow an overly rich mixture (excessive fuel) in the engine during deceleration. The mixture of air and excessive fuel can cause the engine to stall while stopping, coasting, or turning.
NHTSA · 미국1984년 9월 24일84V116000연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Involved vehicles may have been built with improperly forged or heat treated bolts used to attach the front suspension ball joints to the steering knuckles. Some of the bolts may eventually fail which could result in ball joint separation and affect vehicle directional controllability.
캐나다 교통부1982년 5월 28일1982050연식 1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Clamp bolts installed on certain vehicles may contain cracks. Eventually these bolts may break through, causing separation of the ball joint from the steering knuckle.
NHTSA · 미국1982년 5월 27일82V055000연식 1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On the involved vehicles, the bolts used to attach the front suspension ball joints to the control arms may fail due to a bolt section crack condition. The ball joint may separate from the arm possibly affecting vehicle directional control.
NHTSA · 미국1982년 1월 28일82V011000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The engine compartment fuel line hoses installed on certain vehicles were fabricated from a defective rubber compound. When subjected to continuous high underhood temperatures, these hoses may become brittle and crack.
NHTSA · 미국1980년 10월 21일80V139000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The hood secondary latch on the involved vehicles may be subject to binding due to variations in the latch and its mounting base assembly. A problem could occur if the primary latch became inoperative or was not properly engaged.
NHTSA · 미국1980년 10월 17일80V138000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Steering wheel horn pads do not contain the horn symbol display as required by fmvss 101.
NHTSA · 미국1989년 6월 5일89V091000연식 1988원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).