On vehicles with four wheel drive and automatic locking front hubs, the front brake hose, between the body brake tubing and the front axle connector, may have been improperly installed (twisted) during vehicle assembly. If twisted, the hose can be looped upon itself in a manner that may allow abrasive contact during normal suspension travel. This could result in eventual hose failure and partial loss of braking capability. Correction: Vehicles will be inspected and brake lines rerouted if necessary.
캐나다 교통부1987년 7월 3일1987068연식 1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain vehicles may have been built with an improperly installed (twisted) front brake hose. This could allow abrasive contact during normal suspension travel and result in eventual hose failure and partial loss of braking capability.
캐나다 교통부1984년 10월 10일1984122연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicles are not in compliance with the impact test requirements of federal motor vehicle safety standard 301, "fuel system integrity." the structure of the rear step bumper may not withstand a rear end collision similar to the force created in testing; fuel leakage may occur upon impact.
NHTSA · 미국1984년 9월 24일84V115000연식 1980–1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
온라인 결함 위키의 내용을 번역해 드립니다.
특정 차량에서는 자동변속기에 파킹 스프래그 로드 어셈블리가 포함되어 있을 수 있으며, 이 부품이 치아 끝(비결합) 위치에 걸려 고착될 수 있습니다. 이런 현상이 발생하면 차량이 주차된 상태에서 굴러가 사고를 일으킬 수 있습니다. 시정 조치: 해당 차량을 점검하고, 결함이 의심되는 파킹 스프래그 로드 어셈블리는 교체합니다.
캐나다 교통부1988년 1월 5일1988002연식 1988자동 번역 · 원문: 영어자세히 보기 →
On certain vehicles, the master cylinder may have been overstressed and cracked during cylinder manufacture. A cracked cylinder may fail during braking resulting in loss of vehicle braking capability. This could result in a vehicle crash without prior warning.
캐나다 교통부1986년 2월 7일1986020연식 1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The front brake hose, which is routed from the body brake tubing to the front axle connector, may have been twisted when installed. If the hose is twisted, it may become looped or coiled upon itself resulting in abrasive contact during normal operation.
NHTSA · 미국1984년 9월 24일84V117000연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Ignition switches installed in the involved vehicles may have been distorted during a crimping operation which resulted in the internal plastic contact carrier of the switch cracking. Pieces of a cracked carrier may break away, permitting abnormal switch electrical contact and the potential for starter actuaton when the switch is turned to the accessory position.
NHTSA · 미국1982년 10월 5일82V095000연식 1983원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Clamp bolts installed on certain vehicles may contain cracks. Eventually these bolts may break through, causing separation of the ball joint from the steering knuckle.
NHTSA · 미국1982년 5월 27일82V055000연식 1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).