The steering column coupler may become disconnected when the vehicle experiences a severe impact to the undercarriage. This would result in loss of steering control. Correction: Steering column coupler will be replaced with one that collapses on impact.
캐나다 교통부1997년 10월 8일1997171연식 1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The fuel and rear brake tubes may experience accelerated corrosion between the tubes and a rubber isolator. Failure of these tubes could result in fuel leakage and/or diminished braking capacity. Correction: Brake, fuel supply and fuel vapour tubes will be inspected for the presence of red corrosion. Any tubes showing evidence of red corrosion will be replaced. In addition vehicles will have the rubber isolator replaced with a plastic clip.
캐나다 교통부1996년 11월 20일1996186연식 1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
이 차량들은 C.M.V.S.S. 1103 - 배기가스 배출 기준을 준수하지 않습니다. 고체 상태 냉각팬 릴레이가 열로 인한 전기적 과부하로 고장 날 수 있으며, 이로 인해 팬이 멈추고 차량이 과열될 수 있습니다. 차량이 과열되면 배출가스와 주행성능 모두에 영향을 미칠 수 있습니다. 시정 조치: 고체 상태 릴레이를 교체하고, 팬 배선 회로에 다이오드 점퍼 와이어를 설치합니다.
캐나다 교통부1998년 3월 27일1998053연식 1997–1998자동 번역 · 원문: 영어자세히 보기 →
The circuit design in the air bag electronic control module may allow the potential for inadvertent air bag deployment upon vehicle ignition shut down. Correction: The air bag electronic control module will be replaced with a module that incorporates the latest production redesigned circuit to prevent this condition.
캐나다 교통부1997년 5월 21일1997102연식 1997원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one portion of the split brake system. Correction: Rear brake master cylinder piston assemblies will be replaced.
캐나다 교통부1996년 5월 17일1996079연식 1995–1996원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
An engine wiring harness may short due to contact with the exhaust gas recirculation (egr) tube. Shorting of the harness may cause various electrical malfunctions, including engine die out. Correction: Wiring harness will be properly routed and any damaged wiring will be replaced.
캐나다 교통부1996년 2월 12일1996029연식 1996원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The rear brake hose mounting bracket screws can fail allowing the brake hoses to move out of position. The unrestrained hoses are then susceptible to damage which could result in brake fluid leakage.
NHTSA · 미국1994년 2월 23일94V034000연식 1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicles may experience an engine die out due to moisture in the powertrain control module (pcm) caused by inadequate potting material sealing. Also, the rear brake lines may be out of position due to failure of the mounting bracket screws. Correction: Powertrain control module and rear brake line bracket screws will be replaced on affected vehicles.
캐나다 교통부1994년 2월 21일1994038연식 1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicles may have been built with a rear abs brake master cylinder seal that may allow air ingestion into the cylinder and cause spongy brake feel or partial brake system loss. Correction: Vehicles will be inspected and suspect master cylinders will be replaced.
캐나다 교통부1994년 2월 8일1994024연식 1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).