전기 시스템:점화 장치
점화 스위치에 내부 단락이 발생할 수 있습니다.
🔔 무료 계정을 만들고 Ford EXP (모든 세대) 이메일 알림 받기
점화 스위치에 내부 단락이 발생할 수 있습니다.
자동차 결함 위키의 내용을 번역합니다. 이그니션 스위치에서 단락(쇼트)이 발생하여 과열, 연기, 그리고 차량 조향 칼럼 내부에서 화재로 이어질 수 있습니다. 이 현상은 차량 운행 중에도, 또는 주차 등으로 방치된 상태에서도 발생할 수 있습니다. 시정 조치: 이그니션 스위치를 설계가 개선된 신형 스위치로 교체합니다.
1984년형 모델에서는 엔진 실린더 헤드에 외부 균열이 생겨 오일이 배기 매니폴드로 새어 나올 수 있습니다. 1985년형 모델에서는 엔진 로커 커버 가스켓이 찢어져 오일이 배기 매니폴드로 새어 나올 수 있습니다. 두 상태 모두 오일이 발화하여 후드 아래에서 화재가 발생할 가능성을 만듭니다. 시정 조치: 1984년형 모델은 실린더 헤드에 외부 균열이 발견되면 점검 후 교체합니다. 1985년형 모델은 더 새로운 설계가 적용된 경우를 제외하고 로커 커버 가스켓을 점검하여 필요시 교체합니다.
외부 균열이 1984년형에서 3번 실린더 위쪽에 생기거나, 1985년형에서 로커 암 커버 가스켓이 갈라지면 오일이 배기 매니폴드 위로 새어 나갈 수 있습니다.
차량에 따라 오른쪽 앞 브레이크 튜브와 엔진에 장착된 브래킷 사이의 간격이 부족할 수 있습니다. 특정 조건에서는 브래킷이 금속 브레이크 튜브에 닿아 튜브가 마모될 수 있으며, 이로 인해 브레이크 액이 누출되고 제동력이 부분적으로 상실될 수 있습니다. 이 경우 제동 거리가 길어지게 됩니다.
The front sleeve bushings of the cooling fan motors are susceptible to excessive corrosion in areas of high road salt use. This may increase the rotational friction of the fan motor or result in seizure of the armature shaft to the bushing. Either condition may draw current in excess of that of a normally operating motor but less than required to operate the fuse link. This could overheat the motor wiring circuitry and possibly result in an underhood or instrument panel fire. Vehicles affected: Cars not equipped with factory air conditioning. Quebec and atlantic provinces only.
이 차량들은 C.M.V.S.S. 1103(배기 가스 배출) 기준을 충족하지 않을 수 있습니다. 중앙 연료 분사장치(CFI)는 특정 운전 조건에서 농후(rich) 상태로 작동할 수 있습니다. 시정 조치: 개선된 CFI 연료 분사기가 장착되고 공회전 속도가 조정됩니다.
These vehicles do not comply with cmvss 1103 - exhaust emissions. Vehicles affected: 1.6 l engine and atx transmissions
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
Two door models. Fatigue cracks may occur in the door lock pillars at the front door latch striker reinforcement attachment locations. The fatigue cracks may propogate to the extent that the structural integrity of the door latch striker attachment may be significantly reduced creating the possibility that the door may not be securely retained. This condition is observable by visibly noticeable cracks on the door lock pillar adjacent to the striker assemblies.
Door lock pillars could develop fatigue cracks from normal usage of door, at the point where door latch striker reinforcements are attached.
On the involved vehicles, a thermal limiter in the blower motor resistor circuit of the air conditioner/heater assembly may not function as intended. If the blower motor becomes jammed when the system is operating in the medium-low blower speed, the resistor coils can overheat causing melting and possible ignition.
Vehicles with optional air conditioning. The air conditioner blower motor thermal limiter may not operate as intended when there is a motor blockage or malfunction. Thus, if the blower motor becomes jammed when the system is operating in the medium-low blower speed mode, the resistor coils may overheat causing melting and possible ignition of the polyproplene evaporator housing with associated vehicle damage.
Vehicles equipped with power brakes. Power brake boosters may have bewen improperly assembled by supplier. Mis-indexing of rear shell of some boosters relative to the front shell may have resulted in inadequate crimping of the two shells. If booster were to separate during vehicle operation, complete loss of service brakes would result.
Some vehicles equipped with power brake boosters have front and rear shells that may have been improperly joined. Improperly joined booster shells may separate either partially or completely during brake application.
Vehicle may not meet the fuel spillage requirements of cmvss 301 - fuel system integrity.
Certain vehicles may not meet applicable minimum fuel spillage requirements of federal motor vehicle safety standard no. 301, "fuel system integrity". During a 30 mph rear impact test, fuel spillage limits were exceeded by vehicle.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).