공지
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
🔔 무료 계정을 만들고 Ford 포커스 (모든 세대) 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
Some 2016-2017 Ford/Lincoln vehicles SYNC 3 may exhibit an intermittent blank screen. Check for SYNC software update under the OASIS Tab SYNC selection. If update is available refer to WSM, Section 415-00 and update APIM software. During the update process the SYNC status bar shows Updating System Software for approximately 30 minutes. After Installation Complete pop-up appears, remove USB flash drive and install into IDS tool to update Ford database. Perform a complete ignition cycle by turning the key off for 5 minutes which is critical for a successful installation. If no updates are available or blank screen is present after an update refer to WSM, Section 415-00 for diagnosis or SYNC 3 intermittent blank screen GSB for tips. For claiming, use causal part 14G371 and applicable labor operations in section 10 of the SLTS manual.
Some 2016 focus vehicles may not successfully complete reprogramming or programmable module installation (pmi) of the bcm. Make certain the integrated diagnostic system (ids) is at release 103.03 or higher before attempting bcm programming.
Ford: See document search button for owner letter. During testing, active grille shutter (ags) wire harness electrical terminals was damaged, and causes engine temperature to rise, if louvers are closed and open circuit occurs, whereby warning light illuminates, chime will sound and high engine temperature, stop safely message is displayed. Model 2012 focus. *pe
Some vehicles may exhibit instrument cluster warning lamps that are inoperative. *tt
Some models may exhibit instrument cluster warning lamps that are inoperative. *tt
2018년식 Focus, 2019년식 Fiesta, 2019~2020년식 Transit 및 2019~2020년식 Transit Connect 차량 일부에서, Bluetooth 기기가 연결되어 오디오를 스트리밍 중일 때 라디오가 FM 채널을 무작위로 검색하는 증상이 나타날 수 있습니다. 엔지니어링팀이 이 증상에 대한 해결책을 현재 개발 중입니다. 고객에게 Ford가 2021년 5월로 예정된 소프트웨어 수정 프로그램을 개발 중이라고 알려주십시오. 그때까지는 Bluetooth를 사용하지 않아도 라디오는 계속 작동한다고 고객에게 안내하고, 2월 말로 고객과 후속 서비스 예약을 잡으십시오. 업데이트가 제공되면 고객에게 연락하여 서비스 예약이 예정대로 진행되는지 확인하십시오. OASIS에서 추가 정보를 계속 모니터링하고, 수리가 가능해지면 고객의 서비스 예약을 잡으십시오.
어떤 2018-2020년식 Ford 및 Lincoln 차량 중 TCU와 WiFi 핫스팟이 장착된 차량에서, 핫스팟 메뉴에 진입하려고 할 때 "이 차량에서는 Vehicle Hotspot 기능이 활성화되어 있지 않습니다"라는 메시지가 표시될 수 있습니다. FordPass/Lincoln Way 애플리케이션을 사용할 때, 고객은 이 차량에서 Wi-Fi가 비활성화되었다는 메시지를 받을 수 있습니다. 차량 사양 또는 차량 빌드 정보에서 PTS 웹사이트(Detailed Vehicle Specifications)의 mfal 코드를 확인하십시오. mfal = WAFAC 또는 WAFAB인 경우 TCU를 교체하지 마십시오. 엔지니어링팀이 현재 이 상태를 조사 중입니다. 고객에게 Ford가 3월 초로 예상되는 소프트웨어 수정 사항을 개발 중이라고 안내하십시오. 그때까지는 고객이 차량을 계속 운행해도 된다고 알려주고, 3월 초에 후속 방문 예약을 고객과 잡으십시오. OASIS에서 업데이트를 지속적으로 모니터링하십시오.
Some 2018 Focus, 2019 Fiesta, 2019-2020 Transit, 2019-2020 Transit Connect, and 2020 EcoSport vehicles may exhibit a concern where the radio randomly seeks through FM stations when a Bluetooth device is connected and streaming audio. Engineering is currently working on a solution for this condition. Inform customers that Ford is developing a software fix that is expected in February 2021. In the interim, let the customer know that the radio will still function without Bluetooth and schedule a follow-up appointment with the customer for late February. Once the update becomes available, contact the customer and confirm the service appointment is going forward. Monitor OASIS for additional information and schedule service appointments for customers once the repair becomes available.
일부 2018~2020년형 Ford 및 Lincoln 차량은 TCU와 WiFi Hotspot이 장착되어 있으며, Hotspot 메뉴에 진입하려고 할 때 "Vehicle Hotspot feature not enabled on this vehicle(이 차량에서 Hotspot 기능이 활성화되지 않음)" 메시지가 표시될 수 있습니다. FordPass/Lincoln Way 앱을 사용할 때 고객에게 "이 차량에서 Wi-Fi가 비활성화되었습니다"라는 메시지가 나타날 수 있습니다. 차량 사양 또는 차량 제작 정보에서 mfal 코드를 확인하십시오. mfal이 WAFAC 또는 WAFAB인 경우 TCU를 교체하지 마십시오. 엔지니어링팀이 현재 이 증상을 조사하고 있습니다. Ford가 1월 초 출시 예정인 소프트웨어 수정 사항을 개발 중이라고 고객에게 안내하십시오. 그때까지 고객은 차량을 계속 운행해도 된다고 알려 주시고, 1월 초로 후속 예약을 잡으십시오. 업데이트가 제공되면 고객에게 연락하여 서비스 예약이 예정대로 진행되는지 확인하십시오. OASIS에서 업데이트를 계속 모니터링하십시오.
In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market
Some 2013-2016 Escape and 2016 Focus, Transit and Transit Connect vehicles equipped with a front control display interface module (FCDIM) may exhibit the inability to store AM/FM presets, select AM/FM presets and/or erratic preset button operation. Reprogram the front control display interface module (FCDIM) using Integrated Diagnostic System (IDS) or Ford J2534 Diagnostic Software (FJDS) release 109.02 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com. For claiming, use causal part 18C869 and applicable labor operations in Section 10 of the Service Labor Time Standards(SLTS) manual.
Some 2017 Escape and Focus vehicles may experience a message during key programing that states "Back End Server Failed". To correct this condition, reprogram the Remote Frequency Actuator (RFA) module to the latest level using Integrated Diagnostic System (IDS) or Ford J2534 Diagnostic Software (FJDS) release 108.06 or higher. For claiming, use causal part 19G481 and applicable labor operations in section 10 of the SLTS manual.
Some 2016 Escape and Focus vehicles equipped with a front control display interface module (FCDIM) may exhibit the inability to store AM/FM presets and/or preset buttons work erratically. Engineering is currently investigating this concern. Until a new service procedure and/or parts are available use the pre-set buttons in the following manner. To store/program a new station for a pre-set location, press and hold desired button for 3 seconds. To select a previously programmed pre-set location, perform a quick press and release of the button. Refer to Workshop Manual (WSM) Section, 415-00 for normal diagnostics. Continue to monitor OASIS for updates.
Some 2016 c-max energi/focus electric and 2016-2017 fusion energi vehicles built on or before 10-jul-2016, may exhibit a 12-volt and/or high voltage battery with a low state of charge and/or an intermittent battery draw. Reprogram the telematics control unit (tcu) to the latest level using ids release 104.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.Motorcraftservice.Com. For claiming, use causal part 14g229 and applicable labor operations in section 10 of the service labor time standards (slts) manual.
Some 2016 focus battery electric vehicle (bev) and c-max energi plug-in hybrid vehicles (phev) equipped with sync3 may be unable to change the settings for the charge port light ring under vehicle settings function. This may be due to the gateway module (gwm) configuration, defaulting to always on. Reprogram the gwm to the latest level using ids release 103.05a or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. For claiming, use causal part 14g229 and applicable labor operations in section 10 of the service labor time standards (slts) manual.
Some 2016 focus, c-max, fiesta, expedition, and navigator vehicles equipped with sync 3 may exhibit a condition in which the sirius satellite channel guide category buttons may not respond when selected and a loading message is displayed continuously. To correct this condition reprogram the audio control module (acm) with latest calibration using ids release 101.05 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.Motorcraftservice.Com. Use causal part 19c107 and refer to section 10 of the slts manual for applicable labor operations. The sync version can be determined via oasis.
Some 2016 escape/mkc/fiesta/f150/expedition/navigator/mustang /transit/focus/c-max/mkx/taurus/mks/flex/mkt/edge and 2017 escape/explorer/mkc/fusion and mkz vehicles equipped with sync 3 might exhibit a blank screen or other various sync symptoms only when the vehicle is in transport mode. Engineering is aware of this possibility and it is considered normal due to the power saving features enabled while in transportation mode. It is beneficial to extended battery life to keep the vehicle in transport mode until the vehicle is prepped for sale. If the vehicle should exhibit a blank screen or other sync symptoms after it has been taken out of transport mode, refer to workshop manual, section 415-00 for normal diagnosis. The sync version can be confirmed via oasis.
Sync 3 accessory protocol interface module (apim) dtcs u3000 or b108e or u1a00
Ford/lincoln: Global positioning satellite module (gpsm) needs reprogramming to latest calibration due to voice prompt failing to locating vehicle, screen message indicator fault of navigation, instead of current location indicates previous location. Model 2014 ford, lincoln. *pe
Ford: Clock fails to be set unless front control display interface module fcdim) has date set first and then time. Model 2013-2015 c-max, 2014-2015 escape, 2014 focus. *pe
Ford: In battery junction box, is a damaged or an improperly seated connector, causing check engine light to illuminate, with diagnostic trouble codes (dtcs) p2122, p2127 and/or 02138. Model 2012-2013 focus, 2013 escape. *pe
Ford: Some vehicles may experience instrument panel cluster (ipc) message center outside air temperature (oat) display defaulting to c and additionally, the ability to switch display back to f is disabled. Model 2013 focus s. *pe
Ford: On some vehicles, when diagnosing dtcs p26db, p26dd, p26de, check workshop manual regarding testing intake air distribution and filtering, for engine sound symposer valve wiring. Models 2013 focus st. *pe
Ford/lincoln: See document search button for owner letter. Information regarding improve overall software system functionality upgrade on voice recognition, response to touch, simplify screens for easy use, and screen refresh rates. *pe updated 4/5/13. *pe
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).