무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

IsuzuIsuzu Ascender

2002–2008 · 1 세대 · 결함 7건 · 1개 시장
세대

기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.

연식
시장전체NA
공지보통차체NA

공지

Isuzu diesel engines available in the above affected vehicles meet the california air resource board's (carb) optional idling emissions standard of 30 grams per hour of oxides of nitrogen (nox) with no increase in the emission of other regulated pollutants. As a result these vehicles have been approved as "certified clean idle" and are "exempt" from the engine shutdown system (ess) requiremnet pursuant ot section 1956.8 of title 13, california code of regulations. As required by the ess regulation, for "certificed clean idle" vehicles, isuzu has introduced a tamper resistance "certified clean idle" label located on the driver's side door panel. It is important that this label remain, permanently, on the vehicle to identify it as "certified clean idle." carb requires this label as evidence that, at hte time of manufacture, the engine installed met the applicable emission standards. Should the label be found missing or damged during an inspection, a citation and penalties may be issued. If the vehicle is operated in california with a damaged or missing clean idle label, isuzu recommends vehicle operators follow the 5 minute ess requirement by manually turning off the engine. Following this ess requiremnet will keep the vehicle operation compliant until a replacement label can be installed. "clean air idle" labels are printed with a serial number and registered to an individual vin. As a result, a replacemnet label will also include a new serial number which must be registered to the vehicle's vin by the manufacturer. The below information is provided to assit in acquiring, replacing and registering a replacement label.

NHTSA · 제조사 공지10178754연식 2009원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통변속기NA

공지

This Preliminary Information communication provides information to the technician with the axel setup information from American Axle Manufacturing. Technician should be advised that the maximum pinion shim to be used or stacked behind the pinion is 0.050?, and the minimum pinion shim is 0.020? for an 8.6 axle. The range for available pinion depth shims for the 10.5? axle is 0.006? to 0.024?. When setting the backlash it should be set between 0.003? to 0.005? on a new ring and pinion for any American Axle Manufacturing application. The ring and pinion can be reused or adjusted if the mileage is less than 500 miles, if not used for towing. Technician should be advised that a ?roller coaster? or ?hourglass? pattern on the bearings may be normal up to 10,000 miles and possibly longer. With a mis-machined housing you may get a heel pattern on both sides of the gear teeth at build up can generally be corrected with backlash adjustments. When setting up an 8.6? axle with a 5 cut gear set is to use a 0.035? pinion shim and set backlash to 0.004?. When using the newer 2 cut gear set also use a 0.035? pinion shim and still set backlash to 0.004?. To set the gear pattern use backlash to adjust the pattern heel to toe. Use the pinion shim to adjust the height of the pattern. The proper drive pinion bearing pre-load is from 15 - 30 inch pounds with new bearings. The total torque to turn after the differential case is installed should increase 5 - 10 inch pounds at the pinion. A new pinion nut must be used whenever the old one is removed. The axle shaft end play specification is 0.012? per side and the radial specification is 0.002? - 0.003?. Technician should be advised that synthetic lube can be used in all new American Axle Manufacturing axle assemblies. The new pinion seal for the 8.6? axle assembly is a two piece design.

NHTSA · 제조사 공지10112600연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통실내NA

공지

Airbag light on, passenger airbag status indicator reads off, dtc b0092. *kb

NHTSA · 제조사 공지10022540연식 2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통변속기NA

공지

4l60-e automatic transmission fluid leak from oil pump or bell housing area. *kb

NHTSA · 제조사 공지10020537연식 2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

Revised steering wheel replacement procedure (service manual revision). *tt

NHTSA · 제조사 공지10006663연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통기타NA

공지

Intermittent hesitation, stumble or idle stall after soak, harsh 1-2 shift, slipping 1-2 shift followed by a harsh engagement. *tt

NHTSA · 제조사 공지10006094연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

Revised steering wheel replacement procedure. *tt

NHTSA · 제조사 공지10005165연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

Squeak noise coming from the steering column while turning the steering wheel. *tt

NHTSA · 제조사 공지10001769연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미기타NA

공지

Policies and procedures update for all commercial vehicles. This bulletin provides instructions with regard to the Isuzu Commercial Vehicle (CV) Warranty Parts Center on the topics of parts retention, parts preparation for shipping, and administration.

NHTSA · 제조사 공지10243651연식 2009원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · 제조사 공지10139099연식 2009원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미기타NA

공지

This informational bulletin is a revision for 10-00-89-005B to add the 2014 model year and labor codes.

NHTSA · 제조사 공지10139026연식 2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · 제조사 공지10135290연식 2009원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미기타NA

공지

This informational bulletin provides Information Regarding Servicing Components Located Near SIR Components and how to properly disable the SIR system for repairs at or near

NHTSA · 제조사 공지10116912연식 2009원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

This informational bulletin provides dealership personnel with information on flexible fuel vehicles (FFVs) and the usage of E85 fuel in GM vehicles.

NHTSA · 제조사 공지10113662연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Isuzu: 2008 ascender. It may develop a crack in the exhaust manifold which will cause increased exhaust noise. *rm

NHTSA · 제조사 공지10041391연식 2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

Izuzu: 2006 ascender. The malfunction light won't turn on when there is a fault in the air injector system. *rm

NHTSA · 제조사 공지10039116연식 2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미기타NA

공지

Pass-thru programming only for 2008 model year. *nj

NHTSA · 제조사 공지10022919연식 2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미기타NA

공지

Product enhancement for inventory and customer vehicles - obd system improvement. *kb

NHTSA · 제조사 공지10022538연식 2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미변속기NA

공지

Malfunction indicator lamp (mil) on, diagnostic trouble code (dtc) p0894, harsh 1-2 shift with 4l60-e auto transmission. *kb

NHTSA · 제조사 공지10021354연식 2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

Service update for inventory and customer vehicles fuel sending unit port fracture-extended starts/sluggish acceleration/check engine light-expires with base warranty. *kb

NHTSA · 제조사 공지10021202연식 2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Reduced engine power mil illuminated. *kb

NHTSA · 제조사 공지10021196연식 2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

Malfunction indicator lamp illuminated with engine cooling fan system performance dtc p0483 currently set or stored in history. *kb

NHTSA · 제조사 공지10020538연식 2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미변속기NA

공지

Product enhancement for inventory vehicles only engine/powertrain control module reprogram. *kb

NHTSA · 제조사 공지10020535연식 2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미변속기NA

공지

Oil life monitoring system - powertrain control module (pcm) reset. *tt

NHTSA · 제조사 공지10016591연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미전장NA

공지

Onstar system inoperative onstar system status light is red radio locked in phone mode or dtc b1000. *eh

NHTSA · 제조사 공지10014832연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
이전 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).