무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

LexusLexus RX II

2003–2008 · 결함 9건 · 2개 시장
연식
리콜심각전장NA

전기 장치

Issue: 이 리콜은 특정 차량에 설치되었거나 토요타 또는 렉서스 딜러십에서 액세서리로 판매된 특정 블록 히터 키트에 해당합니다. 일부 차량에서는 엔진 블록 히터 케이블의 열 보호가 충분하지 않아 고온에 의해 손상될 수 있습니다. 이런 경우 케이블이 전원에 연결된 상태에서 단락될 수 있으며, 배선이 과열되거나 녹을 수 있습니다. 참고: 이 리콜은 다음 블록 히터/코드 부품 번호에만 해당합니다: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: 과열되거나 녹은 엔진 블록 히터 배선은 화재 위험을 초래할 수 있습니다. Corrective Actions: 토요타는 엔진 블록 히터 사용을 즉시 중단할 것을 권장합니다. 토요타는 우편으로 소유자에게 통지하고, 블록 히터를 비활성화하기 위해 차량을 딜러에게 가져가도록 안내할 예정입니다. 일부 차량의 경우 이 리콜에 대한 시정 조치는 개발 중입니다. 그 밖의 차량에는 새 엔진 블록 히터를 설치할 수 없으며, 소유자는 블록 히터 구매 가격을 환불받게 됩니다.

캐나다 교통부2021년 11월 24일2021723연식 2007–2008자동 번역 · 원문: 영어자세히 보기 →
리콜보통전장UK

Vehicle could suddenly stop

It is possible that due to variations in the build specification of the Intelligent Power Module (IPM) which includes the Insluted-Gate Bipolar Transistors (IGBT's) the lead-based solder could be affected by abnormally higher operating temperatures. This could result in a degrading of the solder and eventually heat damage to the IGBT's. If this occurs then warning lights on the instrument panel will illuminate. However if the driver fails to heed these warnings or the main power supply fuse blows then the vehicle could stop without warning.

DVSA · 영국2013년 10월 16일R/2013/104연식 2004–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통전장KR

각종 조작 스위치

하이브리드 시스템 인버터의 igbt(절연게이트 양극성 트랜지스터) 회로 과열로 계기판에 경고등이 점등되고 안전주행모드나 주행이 되지 않아 안전운행에 지장

국토교통부 · 한국2013년 9월 26일1398연식 2006–2008자세히 보기 →
리콜보통전장UK

Vehicle may loose power

The Intelligent Power Module within the inverter system may fail. This will result in various warning lamps being illuminated. In most cases this will result in the vehicle entering the fail-safe mode resulting in limited power. In limited instances the fuse on the power supply circuit could blow resulting in the hybrid system stopping.

DVSA · 영국2011년 8월 5일R/2011/076연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통전장KR

전기장치

자동차의 인버터(교류전력을 직류전력으로 변환해주는 장치) 불량으로 주행 중 하이브리드 기능이 상실되고 이 경우 출력이 제한(엔진 최고회전수 2,000rpm) 생산일자:`06.03.01, `06.08.01∼`06.08.09

국토교통부 · 한국2011년 7월 25일841연식 2006자세히 보기 →
리콜보통전장NA

Electrical

On certain vehicles, a control board for the Intelligent Power Module (IPM), part of the hybrid system inverter assembly, could fail while the vehicle is underway. This could cause various warning lamps, including the malfunction indicator lamp, slip indicator lamp, brake system warning lamp, and master warning lamp, to illuminate on the instrument panel. If this occurred, in most cases, the vehicle would enter fail-safe driving mode, resulting in reduced motive power in which the vehicle could still be driven for short distances. In some instances, the fuse of the power supply circuit could blow, causing the hybrid system to stop functioning. The resultant loss of vehicle propulsion, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the Intelligent Power Module.

캐나다 교통부2011년 6월 29일2011243연식 2006–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통전장UK

Possibility that the stop lamp could fail

In the stop lamp switch of subject vehicles equipped with LED stop lamps there is the possibility that silicone oxide may be generated the surface of the contact point and in consequence the resistance of the contact could increase. In this circumstance current may not flow causing the stop lamp to become inoperative.

DVSA · 영국2004년 12월 15일R/2004/199연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통전장NA

Electrical

On certain vehicles equipped with a light emitting diode (LED) stop lamp, there is a possibility that silicon oxide may be generated on the surface of the contact point inside the stop lamp switch. Consequently, current may not flow at the contact, causing the stop lamp to become inoperative. The loss of stop lamps would result in failure to warn following drivers that the vehicle is braking and/or is stopped, which could lead to a vehicle crash. Correction: Dealers will replace the stop lamp switch.

캐나다 교통부2004년 11월 23일2004409연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).