Issue: 이 리콜은 특정 차량에 설치되었거나 토요타 또는 렉서스 딜러십에서 액세서리로 판매된 특정 블록 히터 키트에 해당합니다. 일부 차량에서는 엔진 블록 히터 케이블의 열 보호가 충분하지 않아 고온에 의해 손상될 수 있습니다. 이런 경우 케이블이 전원에 연결된 상태에서 단락될 수 있으며, 배선이 과열되거나 녹을 수 있습니다. 참고: 이 리콜은 다음 블록 히터/코드 부품 번호에만 해당합니다: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903
Safety Risk: 과열되거나 녹은 엔진 블록 히터 배선은 화재 위험을 초래할 수 있습니다.
Corrective Actions: 토요타는 엔진 블록 히터 사용을 즉시 중단할 것을 권장합니다. 토요타는 우편으로 소유자에게 통지하고, 블록 히터를 비활성화하기 위해 차량을 딜러에게 가져가도록 안내할 예정입니다. 일부 차량의 경우 이 리콜에 대한 시정 조치는 개발 중입니다. 그 밖의 차량에는 새 엔진 블록 히터를 설치할 수 없으며, 소유자는 블록 히터 구매 가격을 환불받게 됩니다.
캐나다 교통부2021년 11월 24일2021723연식 2007–2008자동 번역 · 원문: 영어자세히 보기 →
Soldeerverbindingen in de inverter van het hybridesysteem zijn onvoldoende bestand tegen de optredende temperaturen. Hierdoor kunnen de soldeerverbindingen losraken.
rdw2013년 10월 23일MGP130134연식 2006–2007원문(네덜란드어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise and/or illumination of the discharge warning light. In addition, the power steering belt may become detached from the crankshaft pulley, which could result in a sudden increase in steering effort. A loss of steering power assist could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the crankshaft pulley.
캐나다 교통부2011년 11월 9일2011397연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages." the anchor bolt for the rear, left-hand side seat belt buckle directly behind the driver's seat does not have sufficient strength.
NHTSA · 미국2006년 1월 27일06V023000연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Een borgclip van een kunststof paneel ten hoogte van het gaspedaal kan los raken. Hierdoor zou het kunststof paneel los kunnen gaan zitten en tegen het gaspedaal leunen.
rdw2013년 12월 17일MGP110058연식 2003–2006원문(네덜란드어)으로 표시 중 · 번역 대기자세히 보기 →
It is possible that due to variations in the build specification of the Intelligent Power Module (IPM) which includes the Insluted-Gate Bipolar Transistors (IGBT's) the lead-based solder could be affected by abnormally higher operating temperatures. This could result in a degrading of the solder and eventually heat damage to the IGBT's. If this occurs then warning lights on the instrument panel will illuminate. However if the driver fails to heed these warnings or the main power supply fuse blows then the vehicle could stop without warning.
DVSA · 영국2013년 10월 16일R/2013/104연식 2004–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
null In limited instances, the fuse of the power supply circuit for the Intelligent Power Module (IPM) could blow, causing the hybrid system to shut down and resulting in the vehicle stopping while being driven, increasing the risk of a crash.
Safety Gate · EU2013년 9월 6일A12/1241/13연식 2005–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The Intelligent Power Module within the inverter system may fail. This will result in various warning lamps being illuminated. In most cases this will result in the vehicle entering the fail-safe mode resulting in limited power. In limited instances the fuse on the power supply circuit could blow resulting in the hybrid system stopping.
DVSA · 영국2011년 8월 5일R/2011/076연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, a control board for the Intelligent Power Module (IPM), part of the hybrid system inverter assembly, could fail while the vehicle is underway. This could cause various warning lamps, including the malfunction indicator lamp, slip indicator lamp, brake system warning lamp, and master warning lamp, to illuminate on the instrument panel. If this occurred, in most cases, the vehicle would enter fail-safe driving mode, resulting in reduced motive power in which the vehicle could still be driven for short distances. In some instances, the fuse of the power supply circuit could blow, causing the hybrid system to stop functioning. The resultant loss of vehicle propulsion, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the Intelligent Power Module.
캐나다 교통부2011년 6월 29일2011243연식 2006–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may lean toward the accelerator pedal and interfere with the operation of the accelerator pedal arm. If this occurs, the accelerator pedal could temporarily become stuck in a partially depressed position, rather than return to the idle position. This could result in a loss of throttle control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the floor carpet cover with a newly designed version. Note: This campaign also covers vehicles which may have been previously included in recall 2006168 (Toyota 609).
캐나다 교통부2011년 2월 24일2011081연식 2004–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Toyota is recalling certain model year 2004-2006 highlander, highlander hybrid, and model year 2004-2007 lexus rx330, rx350, and rx400h vehicles. If the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly the cover may lean toward the accelerator pedal and interfere with the accelerator pedal arm.
NHTSA · 미국2011년 2월 24일11V112000연식 2004–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
If the incorrect brake fluid is used in the brake system it is possible that the rear seal can become dry and curl in its recess due to the operation of the piston. This can result in a brake fluid leak which will when the fluid reaches a low level illuminate the brake fluid low warning light on the dash.
DVSA · 영국2010년 11월 8일R/2010/170연식 2003–2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain vehicles use brake fluids containing polymers that act as lubricants for certain brake system components. If during vehicle maintenance, brake fluid is used that does not contain such polymers or only small amounts, part of the internal rubber seal located at the end of the brake master cylinder piston may become dry and may curl during movement of the piston. If this occurs, a small amount of the brake fluid could slowly leak from the brake master cylinder into the brake booster, resulting in illumination of the brake warning lamp. If the brake warning light has illuminated and the vehicle continues to be operated without refilling the master cylinder brake fluid reservoir, the driver will begin to notice a spongy or soft brake pedal feel and braking performance may gradually decline. This will increase the stopping distance, increasing the likelihood of a crash. Correction: Dealers will replace the brake master cylinder seal with a newly designed one.
캐나다 교통부2010년 10월 21일2010361연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Toyota is recalling certain model year 2005-2006 avalon, model year 2004-2006 highlander, model year 2004-2006 lexus rx, and model year 2006 lexus gs and is vehicles. Brake fluid containing polymers is used that acts as lubricants for certain brake system components. If replacement brake fluid is used that does not contain such polymers, or that contains only small amounts, a part of the rubber seal located at the rear of the brake master cylinder may become dry, and the seal may curl during movement of the piston. If this occurs, a small amount of brake fluid could slowly leak from the seal into the brake booster.
NHTSA · 미국2010년 10월 21일10V499000연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain sport utility and hybrid vehicles, the two retaining clips for the driver's side forward center console can become loose. If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod.
NHTSA · 미국2006년 7월 13일06V253000연식 2004–2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, due to the improper installation of the retaining clips for the floor carpet cover located in front of the center console, there is a possibility that the clips may become loose. If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod. In the worst case, the accelerator pedal may become stuck in a partially depressed position when returning to the idle position. Correction: Dealers will install new clips.
캐나다 교통부2006년 7월 11일2006168연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain vehicles do not comply with the requirements of CMVSS 210. The left rear seat belt buckle anchor may separate from the floor before holding the required test load for the required time. If a separation occurred in a crash, the left rear seat occupant may not be properly restrained, increasing the risk of personal injury. Correction: Dealers will replace the left rear seat belt buckle anchor bolt.
캐나다 교통부2006년 1월 26일2006021연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
In the stop lamp switch of subject vehicles equipped with LED stop lamps there is the possibility that silicone oxide may be generated the surface of the contact point and in consequence the resistance of the contact could increase. In this circumstance current may not flow causing the stop lamp to become inoperative.
DVSA · 영국2004년 12월 15일R/2004/199연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles equipped with a light emitting diode (LED) stop lamp, there is a possibility that silicon oxide may be generated on the surface of the contact point inside the stop lamp switch. Consequently, current may not flow at the contact, causing the stop lamp to become inoperative. The loss of stop lamps would result in failure to warn following drivers that the vehicle is braking and/or is stopped, which could lead to a vehicle crash. Correction: Dealers will replace the stop lamp switch.
캐나다 교통부2004년 11월 23일2004409연식 2004원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).