Some vehicles may exhibit the inner cloth (A) falling down at the rear end causing a poor appearance and obstructing the view of the back window. This is caused by the J-hook binding holding the inner cloth coming loose during the opening/closing of the convertible top, from vibration during driving or from high ambient temperatures. To correct the problem, two top-protector clips have been additionally installed to both side edges of the J-hook to prevent the J-hook from loosening and separating.
NHTSA · 제조사 공지10185955연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
IDS 114.00-114.02 릴리스에서 발견된 데이터베이스 오류(이는 리콜 3719F에 영향을 미침)로 인해 IDS 114를 제거하고 IDS 113.00 및 113.06 업데이트를 설치해야 합니다. IDS 114를 제거하고 IDS 113을 설치한 후에 리콜을 수행할 수 있습니다. 이 SA는 더 많은 정보가 확보되면 업데이트될 예정입니다.
NHTSA · 제조사 공지10163333연식 2019자동 번역 · 원문: 영어자세히 보기 →
On May 1, 2018, Japan produced vehicles starting using 17 mm hex lug nuts instead of 21 mm on the same size thread. When installing the accessory locking lug nuts, make sure to use the appropriate part number for the vehicle you are working on.
NHTSA · 제조사 공지10159199연식 2018–2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
2019년 3월부터 마쓰다는 새로운 MRT 유통을 지원하기 위해 새로운 이중 목적 진단 누설 탐지기(Dual Purpose Diagnostic Leak Detector)를 딜러에게 출하할 예정입니다. 교육 영상은 곧 MGSS에 게시될 예정이며, 워크숍 매뉴얼 절차는 점진적으로 개정될 것입니다.
NHTSA · 제조사 공지10154879연식 2019자동 번역 · 원문: 영어자세히 보기 →
This service bulletin provides information regarding the proper use of the driver's floor mat to avoid anypotential interference with the foot pedals. The following are possible causes of floor mat interference,which can be avoided with proper usage. Floor mat moves forward due to improper installation. Inappropriate floor mat (such as aftermarket, non-factory-equipped, or non-genuine) is used. Floor mat is stacked one on top of another.
NHTSA · 제조사 공지10153331연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On May 1, 2018, Japan produced vehicles starting using 17 mm hex lug nuts instead of 21 mm on the same size thread. When installing the accessory locking lug nuts, make sure to use the appropriate part number for the vehicle you are working on.
NHTSA · 제조사 공지10153304연식 2018–2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some customers may complain that the the middle headliner looks loose at the center rear. This is caused by parts variation. To correct the concern, an additional fastener can be installed in the headliner.
NHTSA · 제조사 공지10118475연식 2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some vehicles may experience poor a/c performance due to a slow refrigerant leak from the o-ring groove on the cooler pipe (high pressure side) at the expansion valve.
NHTSA · 제조사 공지10105622연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some vehicles may experience poor a/c performance due to a slow refrigerant leak from the o-ring groove on the cooler pipe (high pressure side) at the expansion valve.
NHTSA · 제조사 공지10101455연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some vehicles may exhibit the inner cloth (a) falling down at the rear end causing a poor appearance and obstructing the view of the back window. This is caused by the j-hook binding holding the inner cloth coming loose during the opening/closing of the con-vertible top, from vibration during driving or from high ambient temperatures.To correct the problem, two top-protector clips have been additionally installed to both side edges of the j-hook to prevent the j-hook from loosening and separating.
NHTSA · 제조사 공지10101101연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some vehicles may exhibit the inner cloth (a) falling down at the rear end causing a poor appearance and obstructing the view of the back window.This is caused by the j-hook binding holding the inner cloth coming loose during the opening/closing of the con-vertible top, from vibration during driving or from high ambient temperatures.This is caused by the j-hook binding holding the inner cloth coming loose during the opening/closing of the con-vertible top, from vibration during driving or from high ambient temperatures.To correct the problem, two top-protector clips have been additionally installed to both side edges of the j-hook to prevent the j-hook from loosening and separating.
NHTSA · 제조사 공지10093144연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Workshop manual evap system leak inspection using the m-mds has been discontinued for some models. Instead, the workshop manual evap system leak inspection using evap leak tester will be used to troubleshoot evap system leaks.
NHTSA · 제조사 공지10092322연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Some vehicles may exhibit the inner cloth (a) falling down at the rear end causing a poor appearance and obstructing the view of the back window. This is caused by the j-hook binding holding the inner cloth coming loose during the opening/closing of the con-vertible top, from vibration during driving or from high ambient temperatures.To correct the problem, two top-protector clips have been additionally installed to both side edges of the j-hook to prevent the j-hook from loosening and separating.
NHTSA · 제조사 공지10090903연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
When the Telematics Control Unit (TCU) replacement is necessary due to a failure, use MDARS to activate the new TCU after replacement. Use the information in this service alert to initialize the new TCU until the procedure on MGSS is updated.
NHTSA · 제조사 공지11011140연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
When the Telematics Control Unit (TCU) replacement is necessary due to a failure, use MDARS to activate the new TCU after replacement. Use the information in this service alert to initialize the new TCU until the procedure on MGSS is updated.
NHTSA · 제조사 공지11008578연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).