Electrical system: problems reported by owners
35 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2017–2020), typically at around 9,000 miles. Reported consequences: 1 crash, 6 fires.
🔔 무료 계정을 만들고 Mercedes-Benz X166 (모든 세대) 이메일 알림 받기
Mercedes-Benz X166의 모든 세대를 한곳에: 결함, 리콜, 서비스 회보, 토론. 세대를 선택해 범위를 좁히세요.
35 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2017–2020), typically at around 9,000 miles. Reported consequences: 1 crash, 6 fires.
25 owners in the United States reported problems with the engine of this car to NHTSA (model years 2017–2020), typically at around 15,000 miles. Reported consequences: 9 fires, 1 injury.
18 owners in the United States reported problems with the fuel system of this car to NHTSA (model years 2017–2020), typically at around 4,000 miles. Reported consequences: 1 crash, 5 fires, 3 injuries.
14 owners in the United States reported problems with the suspension of this car to NHTSA (model years 2017–2020), typically at around 75,000 miles. Reported consequences: 1 fire.
12 owners in the United States reported problems with the transmission and drivetrain of this car to NHTSA (model years 2017–2020), typically at around 1,000 miles.
De drie aluminium schroeven waarmee de power-pack aan de stuurinrichting is bevestigd, kunnen door blootstelling aan water en strooizout roesten.
엔진의 질소산화물 배출량 개선을 위한 소프트웨어 업데이트에 따른 리콜 <대상차량별 생산일자는 상이할 수 있으므로 자세한 사항은 제작사 고객센터(080-001-1886)으로 문의하여 주시기 바랍니다.>
스티어링 박스의 알루미늄 나사 3개는 분사되는 물과 빙판을 녹이기 위해 사용되는 공격적인 도로 제설재(염화물)에 노출되어 부식될 수 있습니다. 부식이 심해지면 나사가 약해져 기동이나 주차 중에 파손될 수 있습니다. 고정 나사가 모두 파손되면 파워 어시스트 스티어링이 분리될 수 있으며, 이로 인해 파워 스티어링 기능을 잃고 사고 위험이 높아질 수 있습니다.
Complaint Customer concern of Air Conditioning not cooling. *NOTE Use of tracer DYE for leak checks is not approved. Only approved leak check procedures as per WIS are approved. Cause Possible refrigerant leak. Remedy Perform the following measures : *Important* Photo documentation requirement is no longer in effect as of 10/1/2025. Remedy 1: Replace Evaporator (Only applies to vehicles produced PRIOR to April 15, 2022 and has NOT had the evaporator replaced previously) 1. Ensure that the rest of the AC system has been thoroughly checked for leaks with forming gas as per WIS before condemning the evaporator. 2. If no other leaks are found, replace the evaporator 3. *Important* when you get the new evaporator, check the expansion valve bracket to see if there are any bends (see attachment "Bent Bracket"). a. If bent, remove the expansion valve and bracket and check for damage to the flange (see attachment "Flange Damage"). i. If damage is found, order another evaporator and claim the part under parts warranty. The warranty claim MUST include a photo of the damage found. ii. If no damage is found, flip the bracket and torque to 7Nm. Check the evaporator for proper sealing before fully installing. b. If no bends are found, the evaporator should be installed in the vehicle. Note *If the evaporator housing has been opened or the evaporator or housing has been tampered with, the claim will be debited. Remedy 2: (Applies to all vehicles produced on or AFTER April 15, 2022 up to August 1, 2025) 1. Ensure that the entire AC system has been thoroughly checked for leaks with forming gas as per WIS . 2. If no leaks were found AND the system came in with no cooling/low charge, OR the evaporator is suspected of leaking: 3. Replace ONLY the expansion valve bracket, seals, and bolts as supplied in kit A 167 832 47 00, in accordance with the procedure outlined in WIS document AR83.30P5520ME. 4. IF THE PRODUCTION DATE IS BETWEEN JUNE 1, 2023 AND JULY 1, 2024, REPLACE THE DRYER AS WELL. (NOT THE CONDENSER) 5. After, charge the system and perform a few drive cycles. 6. Recheck the vehicle for leaks. 7. If no leaks are found, the vehicle can be released. 8. If a minor leak is detected that is less than 50ppm, then perform the following steps: If a leak is detected, fill the system with forming gas Close all doors and windows for 10 minutes. Vehicle off with no blower activation. Open the driver's door and measure ppm detection as soon as the door is open and the sniffer goes into the vehicle. If no leaks are measured, fill the system and release. If you still feel the evaporator is needed/leaks are still detected, a TIPS case is required for replacement. Provide all documentation listed in Remedy 3. Remedy 3: (Only applies to vehicles produced AFTER August 1, 2025) Ensure that the entire AC system has been thoroughly checked for leaks with forming gas as per WIS . If no leaks are found or the expansion valve has been found to be leaking, remove the expansion valve and check the bracket. If the bracket is bent, replace the expansion valve bracket, seals, and bolts as supplied in kit A 167 832 47 00. In the warranty submission, include photos of both sides of the bracket and a side profile so it can be seen that the bracket is bent. If the bracket is NOT bent or leaks from other locations are found, then open a TIPS case with the following: 1. Initial Quick Test 2. Create a short video of the actual pressures via AC machine, showing the engine running, and hold a copy of the VIN/RO in view as well. 3. OBS recording of XENTRY AC actual values of compressor request to be on and current value. (Instructions in Attachments) 4. Video recording of the leak being found via sniffer at the R/F AC drain after removing the under dash panel if the evaporator is suspected. (see attached videos) 5. If the evaporator is found to be leaking via sniffer, another video needs to be uploaded (or a continuation if only making the video after checks
**고객 불만:** 도어 내 스피커 부근에서 덜컹거리는 소음이 발생함. **원인:** 분석 중. **조치:** 원인을 좁히기 위해 먼저 도어 트림을 분리하십시오. 도어 트림을 분리한 상태에서도 소음이 계속 발생하면 스피커 쪽으로 진단을 계속 진행하고, 필요한 경우 유용한 동영상을 첨부하여 TIPS 케이스를 생성하십시오. **참고:** 보증 클레임에서 이 문서를 참조하고, 진단이 완료되면 문제를 일으키는 부품에 따라 손상 코드를 선택하십시오. 도어 트림을 분리했을 때 소음이 멈추면 LI72.10P067691에 따라 진행하십시오. **정보:** 이 경우 보증 클레임에서 스피커에 대한 손상 코드를 사용하지 마십시오!
Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.
결함과 토론은 세대별로 정리됩니다. 글을 올리려면 위에서 세대를 선택하세요.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).