전기 시스템
1996년부터 1998년까지 캔자스시티 쿠아티틀란 조립 공장에서 제작된 일부 승용차나 1999년 오토모티얼라이언스 국제 조립 공장에서 제작된 승용차에서, 히터 블로어 저항기의 스테인리스 블레이드의 거친 표면이 배선 하니스 커넥터의 구리 표면을 손상시킬 수 있습니다. 이 손상은 시간이 지남에 따라 커넥터 저항을 증가시키고, 이후 단자 이완으로 인해 개방 회로 상태를 초래할 수 있습니다.
🔔 무료 계정을 만들고 Mercury Cougar (모든 세대) 이메일 알림 받기
1996년부터 1998년까지 캔자스시티 쿠아티틀란 조립 공장에서 제작된 일부 승용차나 1999년 오토모티얼라이언스 국제 조립 공장에서 제작된 승용차에서, 히터 블로어 저항기의 스테인리스 블레이드의 거친 표면이 배선 하니스 커넥터의 구리 표면을 손상시킬 수 있습니다. 이 손상은 시간이 지남에 따라 커넥터 저항을 증가시키고, 이후 단자 이완으로 인해 개방 회로 상태를 초래할 수 있습니다.
차량 설명: 2.5리터 V6 엔진이 장착된 승용차. 배터리 케이블이 잘못 배선되어 발전기 케이블과의 연결 부분이 조크가 부족했습니다. 잘못 배선되면 케이블이 파워 스티어링 라인과 접촉해 절연체가 마모되어 전기 단락이 발생할 수 있습니다.
Vehicle description: Passenger vehicles. The brake lamp switch terminals could overheat.
Vehicle description: Passenger vehicles originally sold or currently registered in the states of connecticut, district of columbia, delaware, iowa, illinois, indiana, kentucky, massachusetts, maryland, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, wisconsin, and west virginia. Movement of the fuel lines causes the nylon fuel line jumper to chafe against the floor pan. This wear can cause a pin hole in the fuel line resulting in fuel leakage.
점화 스위치에 내부 단락이 발생할 수 있습니다.
자동차 결함 위키의 내용을 번역합니다. 이그니션 스위치에서 단락(쇼트)이 발생하여 과열, 연기, 그리고 차량 조향 칼럼 내부에서 화재로 이어질 수 있습니다. 이 현상은 차량 운행 중에도, 또는 주차 등으로 방치된 상태에서도 발생할 수 있습니다. 시정 조치: 이그니션 스위치를 설계가 개선된 신형 스위치로 교체합니다.
Battery to starter cables are longer than specified; excessive cable length could contact engine damper pulley.
EFI 또는 CFI가 장착된 차량에서, 연료 공급 및 리턴 라인을 EFI 연료 레일 또는 CFI 스로틀 바디에 연결하는 데 사용되는 스프링 록 연료 라인 커플링과, 일부 차량의 대시 패널 근처에 있는 기타 연료 라인 연결부가 차량 사용 중 분리될 수 있습니다. 이런 현상이 발생하면 연료가 누출되어 차량 화재 가능성이 있습니다. 시정 조치: 해당 차량에는 커플링 고정 클립(retainer clip)이 설치됩니다. 참고: Escort 차량에는 EFI와 CFI가 모두 장착되어 있습니다. Lynx 차량에는 CFI만 장착되어 있습니다. EFI - 전자식 연료 분사(electronic fuel injection) CFI - 중앙 연료 분사(central fuel injection)
Spring lock fuel line coupling may not be properly engaged.
프로판 차량. 일부 차량은 연료 탱크 지지 스트랩이 부적절하게 용접된 상태로 생산되었을 수 있습니다. 특정 차량 충돌 조건에서는 스트랩이 탱크를 충분히 지지하지 못해 손상 위험이 높아질 수 있습니다. 연료 누출이 발생하면 화재가 발생할 가능성이 있습니다.
Vehicles with 3.8 litre engines. Vehicles may have been produced with inadequately welded front seams on the fuel tank. A fuel leak could develop and in the presence of an ignition source, present a potential for fire.
일부 해당 차량은 엔진룸 내 프로판 연료 계통 피팅이 부적절하게 조여진 상태로 생산되었을 수 있으며, 이 경우 연료 누출이 발생할 수 있습니다.
Vehicles modified to run on propane may leak fuel in the engine compartment as the result of improperly tightened fuel system components thus creating a risk of fire.
일부 승용차에서는 연료 공급 모듈(FDM) 내 필터 오염이 엔진으로 가는 연료 흐름을 감소시키거나 결국 차단할 수 있습니다.
차량 설명: 미끄럼 방지 제동 장치(ABS)가 장착되지 않은 승용차. 도로의 제빙 또는 먼지 억제를 위해 염화물 화합물을 사용하는 지역에서 운행할 경우, 후륜 브레이크의 압력 감지 감압 밸브(PCRV)가 부식되어 오작동을 일으킬 수 있습니다.
Vehicle description: Passenger vehicles equipped with fog lights, in which the headlights may go out for various intervals and which may be preceded by flickering or blinking as a result of the circuit breaker opening.
Vehicle description: Passenger vehicles. The door latch may have been manufactured with a latch pawl that has a coating which will swell in high humidity conditions. The latch pawl may then stick in the open or unlatched position.
Vehicle description: Passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the accelerator is released.
Certain vehicles may not comply with CMVSS 1105 - evaporative emissions. The rear fuel lines may allow fuel to seep and evaporate at the metal line to nylon tube joint at the rear of the vehicle near the fuel filter. This may cause evaporative emissions in excess of the standard. Correction: Vehicle will be inspected for signs of fuel escaping a joint between a nylon tube and a metal fuel line. If wetness or fuel odor are detected a reinforcement kit will be installed.
These vehicles may not comply with c.M.V.S.S 206 - door latches, hinges and locks. The driver's door, when closed only to the secondary latched position, may not sustain a 1000 pound transverse load as required by the standard. Correction: Driver door latch will be inspected and, if necessary, replaced.
When in the secondary latched position, the driver door latches may open when subjected to transverse loads less than that specified in fmvss no. 206, "door locks and door retention components."
The semi-automatic temperature control module may malfunction and cause erratic blower operation, high blower or no blower regardless of control position. Should the no blower condition occur, the vehicle's defroster may not clear the windshield of frost/fog. Correction: Dealers will inspect and if necessary, replace the semi-automatic temperature control module with a revised design module.
Under certain conditions, the climate control blower does not operate as intended. The blower could (1) stick on "high;" (2) operate erratically with blower output varying between no blower and maximum blower; or (3) not operate at all due to malfunction of the temperature control module.
특정 Cougar XR-7, Thunderbird Turbo, Merkur XR4TI 차량은 CMVSS 1103 - 배기 배출가스 요건을 충족하지 못합니다. 시정 조치: 딜러가 배기 시스템 촉매 컨버터를 교체하고, EGC 진공 라인에 진공 지연 밸브(vacuum delay valve)를 설치합니다.
Note: Thunderbird super coupe and cougar xr7 equipped with manual transmission and 3.8 litre supercharged engine. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Higher than anticipated exhaust system temperatures may cause damage to the exhaust system catalyst thereby increasing exhaust emission levels in excess of the standard. Correction: Dealers will replace exhaust system catalyst assembly and powertrain control module.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).