Vehicle description: Passenger cars. The seat belt buckle tongue may not fully eject from the buckle assembly when the release button is pushed slowly. This condition could also result in a partial latch of the tongue in the buckle.
NHTSA · 미국2001년 4월 27일01V144000연식 2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
캐나다 교통부1990년 11월 21일1990182연식 1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Ford Motor Company (Ford) is recalling certain model year 2009-2012 Ford Flex, 2008 and 2010-2012 Ford Taurus, 2008-2009 Ford Taurus X, 2008 Mercury Sable, 2009 and 2011 Lincoln MKS vehicles. The driver frontal air bag may improperly inflate during second-stage deployment in the event of a high speed crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
NHTSA · 미국2016년 4월 26일16V247000연식 2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Certain sport utility vehicles, pickup trucks, and passenger vehicles fail to comply with the requirements of fmvss 225, "child restraint anchorage systems." the affected expedition/navigator owner guides do not identify the locations of seating positions equipped with tether anchorages, and do not provide instructions for securing child seats to these tether anchorages. The f150 sc owner guides do not provide the procedure for securing child seats to the tether anchorages. The taurus/sable owner guides do not identify the center rear seating position as having latch compatible lower anchorages.
NHTSA · 미국2000년 11월 28일00V396000연식 2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Passenger vehicles. The child safety seat anchor latch (iso-fix anchor) fasteners do not have adequate residual torque. The anchors are secured to the floor pan with a reinforcement plate that has two studs that extend upward through the floor pan and the iso-fix anchor. The sealer on the floor pan could cause a soft joint and, even if the nuts are properly torqued, road vibrations could cause the nut to work its way completely off the stud.
NHTSA · 미국2000년 8월 24일00V240000연식 2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
차량 설명: 승용차. 안전벨트 리트랙터의 전환식 ELR/ALR 기구에 있는 핀 샤프트가 잘못 성형되어 있을 수 있습니다. 특정 상황에서는 전환 기구가 작동하지 않게 되어 안전벨트 웨빙을 리트랙터에서 풀어낼 수 없을 수 있습니다. 또한 이 기구의 오작동으로 인해 벨트를 ALR 모드로 전환하지 못할 가능성도 있습니다. ELR 기구는 이 상태의 영향을 받지 않습니다.
NHTSA · 미국1999년 9월 20일99V250000연식 1999자동 번역 · 원문: 영어자세히 보기 →
These vehicles may have a front seat belt buckle attaching stud that may have been improperly heat treated. This heat treating may have resulted in cracks developing in the stud. If the stud is cracked, there is the potential for less than the intended level of occupant restraint in the event of a vehicle crash. Correction: Seat belt buckle mounting bracket and stud assembly will be replaced on affected vehicles.
캐나다 교통부1998년 8월 28일1998173연식 1998–1999원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Passenger vehicles equipped with manual seat tracks. The front seat belt buckle attaching stud may have been improperly heat treated. This heat treatment may have resulted in cracks developing in the stud.
NHTSA · 미국1998년 8월 25일98V198000연식 1998–1999원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.
캐나다 교통부1992년 9월 29일1992120연식 1989–1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.
NHTSA · 미국1992년 8월 17일92V113000연식 1989–1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The power seat switch wiring is routed over rather than under the front seat support brace, allowing damage by seat cushion spring ends when seat is occupied.
NHTSA · 미국1991년 3월 4일91V036000연식 1988–1989원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The right quarter windows may contain glass which was improperly tempered. This glass may yield pieces larger than the maximum allowed by fmvss 205, glazing material. Consequence of defect: In case of an accident these large pieces of glass may seriously injure the occupants of the car.
NHTSA · 미국1986년 3월 10일86V039000연식 1986원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).