무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Mini Hatch III

2013–2024 · 결함 11건 · 3개 시장

기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.

연식
시장전체NA
공지보통엔진NA

공지

Due to a manufacturing defect, the left charge air line can fail and cause an induction leak. In some casesthe Engine Malfunction warning may illuminate.

NHTSA · 제조사 공지10242925연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

The left charge air line can fail and cause an induction leak. In some cases the Engine Malfunctionwarning may illuminate. Note: This Service Information is similar to M11 03 23; though this one pertains to vehicles already retailed.

NHTSA · 제조사 공지10242926연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil

NHTSA · 제조사 공지10216761연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

During the vehicle's operational life, normal engine oil seepage or sweating, in addition to accumulated road dust, dirt and grime in the engine compartment can give an appearance that there is an active engine oil leak. This is further exaggerated by residual oil that remains on the engine assembly after maintenance services are performed, for example, oil filter changes, engine oil top-offs, etc. If this visual appearance of accumulated oil on the engine assembly is misinterpreted as an active engine oil leak, then unnecessary gasket repairs/replacements will result.

NHTSA · 제조사 공지10201151원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SERVICE ACTION - MOUNTING THE OIL FILLER CAP CORRECTLY: The oil filler cap may not be mounted correctly. The cap was not installed correctly during assembly.

NHTSA · 제조사 공지10182925연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SERVICE ACTION - MOUNTING THE OIL FILLER CAP CORRECTLY: The oil filler cap may not be mounted correctly. The cap was not installed correctly during assembly.

NHTSA · 제조사 공지10182626연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

ENGINE STALLS AFTER STARTING OR WILL NOT START. The engine stalls right after starting (when stationary).

NHTSA · 제조사 공지10153782연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

VANOS AND VANOS CENTRAL BOLT IDENTIFICATION. INFORMATION Replacing the VANOS gear central bolts or the VANOS gear will require a component inspection when the engine assembly has been previously replaced in one of the vehicles listed above. Ordering the parts via the model, production or VIN may provide the incorrect part numbers. The procedure below will help identify which VANOS parts are installed in the replacement engine. 11 36 7 608 788 Inlet adjustment unit Oulet adjustment unit Refer to the ETK and the repair instructions for one time use fastener and component information regarding additional screws, gaskets and seals.

NHTSA · 제조사 공지10151386연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151154연식 2015–2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151152연식 2015–2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151153연식 2015–2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151055연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151057연식 2016–2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · 제조사 공지10151056연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

"N14 and N18 Engine: High-pressure Pump Repair Instruction. INFORMATION The current version of ISTA/D Repair Instruction 13 51 017, ""Removing and installing or replacing high-pressure pump (N14, N18)"" has a procedure error. The current version of the Repair Instruction states to replace the highpressure supply hose on the N14 engine. The Repair Instruction also states not to replace the high-pressure supply hose on the N18 engine. The N18 portion of the Repair Instruction is incorrect. As an interim solution, follow the procedure outlined below until this portion of the Repair Instruction is corrected. https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/15601.2.M130113... 8/30/2013 Page 2 of 2 All vehicles equipped with the N18 engine and produced from 3/2012 and later. When the engine is fitted with a Bosch High-pressure Pump (1) the highpressure supply hose (2) MUST NOT be replaced when making repairs. The remaining portion of the Repair Instruction and tightning torques are correct. Refer to EPC for the applicable part numbers when making repairs. "

NHTSA · 제조사 공지10150238연식 2013원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

"N14 and N18 Engine: High-pressure Pump Repair Instruction. INFORMATION The current version of ISTA/D Repair Instruction 13 51 017, ""Removing and installing or replacing high-pressure pump (N14, N18)"" has a procedure error. The current version of the Repair Instruction states to replace the high-pressure supply hose on the N14 engine. The Repair Instruction also states not to replace the high-pressure supply hose on the N18 engine. The N18 portion of the Repair Instruction is incorrect. As an interim solution, follow the procedure outlined below until this portion of the Repair Instruction is corrected. https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/159...2/5/2014 Page 2 of 2 Bosch High-pressure Pump (1): All vehicles equipped with the N18 engine and produced from 3/2012 and later When the engine is fitted with a Bosch High-pressure Pump (1), the highpressure supply hose (2) MUST NOT be replaced when making repairs. The remaining portion of the Repair Instruction and tightening torques is correct. Refer to EPC for the applicable part numbers when making repairs."

NHTSA · 제조사 공지10147960연식 2013원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

ENGINE CRANKS, NO START AND/OR ENGINE COOLANT TEMPERATURE FAULTS: NOTE: The engine may also exhibit the same starting behavior as in Situation1.

NHTSA · 제조사 공지10145369연식 2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

JCW ENGINE TUNING KIT - ENGINE LOSS OF POWER IN STOP-AND-GO DRIVING: The engine may lose power if the vehicle is decelerated, in gear, to a near stop and then accelerated again.

NHTSA · 제조사 공지10143573연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통엔진NA

공지

Mini: The oil filter housing assembly is leaking engine oil and/or coolant. No model or years listed. *pe

NHTSA · 제조사 공지10054636원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Turbocharger Return

NHTSA · 제조사 공지11029017연식 2022자동 번역 · 원문: 영어자세히 보기 →
공지경미엔진NA

공지

During a vehicle inspection and/or while addressing a customer's concern, the engine stabilizer bar/link appears to be worn.

NHTSA · 제조사 공지10228445연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Mini parts logistics TEC 26 turbo charger return

NHTSA · 제조사 공지10216708연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Service action: B46 AND B48 ENGINES - CHECK AND REPLACE CRANKSHAFT GUIDE BEARING

NHTSA · 제조사 공지10216762연식 2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

B38, B46 and B48 Engines: Engine Replacement Procedures

NHTSA · 제조사 공지10216766연식 2015원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

Engine will not start (no crank). The engine will not crank or the engine loses power while driving, followed by a no crank situation.

NHTSA · 제조사 공지10216767연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
이전 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).