무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Nissan 쥬크

2010– · 3 세대 · 결함 21건 · 5개 시장
세대
연식
쥬크 I · 2010–2019
리콜심각엔진EU

An internal ignition switch may be defective

An internal ignition switch may be defective. As a consequence, the engine could unexpectedly stall while driving and under certain conditions the vehicle's airbag system may not function.

Safety Gate · EU2018년 8월 29일A12/1281/18연식 2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel System

On certain vehicles, the fuel pressure sensor may not have been tightened properly when the corrective measure of recall 2012-074 was performed. As a result, the fuel pressure sensor may loosen over time, which could cause a fuel leak. A fuel leak in the presence of an ignition source could result in a fire causing injury and/or damage to property. Correction: Dealers will inspect and retighten the fuel pressure sensor as necessary.

캐나다 교통부2018년 3월 8일2018121연식 2011–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel system, gasoline

Nissan North America, Inc. (Nissan) is recalling certain 2011-2012 Nissan Juke vehicles previously remedied under recall 12V-069. During that recall remedy, the fuel pressure sensor may not have been properly tightened, potentially causing the sensor to loosen and leak fuel.

NHTSA · 미국2018년 3월 7일18V156000연식 2011–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진EU

Motorrijtuigen - krachtoverbrenging

Brandstofdruksensor niet correct vastgezet. Hierdoor kan de sensor onder invloed van warmte en trillingen losraken.

rdw2015년 3월 23일MGP150107연식 2012–2013원문(네덜란드어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel System

On certain vehicles, the fuel pressure sensor connected to the engine fuel delivery rail may not have been sufficiently tightened during vehicle assembly. Should the pressure sensor loosen, fuel could leak past a gasket used in the connection between the sensor and the rail. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect the pressure sensor and tighten to specification. Note: This is an expansion of recall 2012-074. Vehicles that were repaired under the previous campaign are not affected because that remedy would have corrected the subject condition.

캐나다 교통부2014년 11월 28일2014539연식 2011–2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel system, gasoline

Nissan North America, Inc. (Nissan) is recalling certain model year 2012-2014 Nissan Juke, 2012-2013 Infiniti M56, QX56, and 2014-2015 Infiniti Q70 (V8 engine vehicles only), and QX80 vehicles. The fuel pressure sensors may not have been sufficiently tightened during production. As a result, the fuel pressure sensor may loosen with vehicle usage and cause a fuel leak.

NHTSA · 미국2014년 11월 28일14V683000연식 2012–2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진JP

その他(燃料装置)

エンジンの燃料供給レールに取り付けている燃料圧力センサの締付けが不適切なため、エンジンの振動等により締付けが緩むものがある。そのため、燃料圧力センサの取付け部のねじを伝って燃料が漏れるおそれがある。

국토교통성 · 일본2014년 11월 27일1134761연식 2010–2014원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
쥬크 I · 2010–2019
리콜심각엔진UK

Fuel may leak

Nissan has identified that the fuel rail pressure sensor of some vehicles may have not been correctly tightened to the fuel rail of the engine and may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition in extreme cases fuel leakage may occur.

DVSA · 영국2012년 4월 3일R/2012/024연식 2010–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel system, gasoline

Nissan is recalling certain model year 2011-2012 juke, infiniti qx and infiniti m vehicles. The fuel pressure sensors may not have been tightened to the correct specification. As a result, the fuel pressure sensor may loosen due to heat and vibration causing fuel to leak.

NHTSA · 미국2012년 2월 24일12V069000연식 2011–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜심각엔진NA

Fuel System

On certain vehicles, the fuel pressure sensor connected to the engine fuel delivery rail may not have been sufficiently tightened during vehicle assembly. Should the pressure sensor loosen, fuel could leak past a gasket used in the connection between the sensor and rail. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect for fuel leakage from the pressure sensor and the fuel rail. If there are no signs of a fuel leak, the fuel pressure sensor will be tightened to specifications. If a fuel leak is confirmed, the gasket between the sensor and the fuel delivery rail will be replaced, and the sensor will be tightened.

캐나다 교통부2012년 2월 23일2012074연식 2011–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
쥬크 I · 2010–2019
쥬크 I · 2010–2019
쥬크 I · 2010–2019
리콜보통엔진UK

Engine push start switch may malfunction

On affected models with a push start ignition switch the switch may remain in the pressed position and not return after switching the engine on. If the vehicle continues to be driven in this condition the emergency engine stop function may operate and cause the engine to unintentionally stop.

DVSA · 영국2015년 8월 4일R/2015/133연식 2013–2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진EU

null The push engine start switch may remain in the pressed position and not return after switching the…

null The push engine start switch may remain in the pressed position and not return after switching the engine on. If the vehicle continues to be driven in this condition, the emergency engine stop function may operate and cause the engine to stop unexpectedly.

Safety Gate · EU2015년 6월 30일A12/0850/15연식 2013–2015원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진JP

始動装置

プッシュエンジンスタータスイッチを組み付けるイモビライザアンテナの成形条件が不適切なため、熱収縮により、当該プッシュエンジンスタータスイッチとの隙間が狭くなり、摺動抵抗が増加したものがある。そのため、そのまま使用を続けると、当該スイッチ操作時に押したまま戻らず、緊急停止操作と判定してエンジンを停止することがあり、最悪の場合、走行中にエンストするおそれがある。

국토교통성 · 일본2015년 6월 25일1135950연식 2013–2014원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진JP

エンジン本体

エンジンのタイミングチェーンにおいて、プレートを連結するピンの耐久性が不足しているため、表面処理が摩耗するものがある。そのまま使用を続けると、プレートのピン挿入穴が摩耗してタイミングチェーン全長が伸び、チェーンガイドと干渉して異音が発生し、最悪の場合、タイミングチェーンが破損してエンストに至るおそれがある。

국토교통성 · 일본2015년 6월 25일1135940연식 2010–2012원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진UK

Fuel may leak

On affected vehicles the fuel pressure sensor may not have been tightened to the correct specification. Heat and engine vibration may cause the sensor to loosen and in extreme cases allow fuel to leak.

DVSA · 영국2015년 3월 30일R/2014/167연식 2012–2014원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
쥬크 I · 2010–2019
쥬크 I · 2010–2019
리콜보통엔진UK

Engine may stall

The Turbocharger boost sensor bracket may separate from the air inlet tube. This means the boost pressure may be measured incorrectly and the engine warning lamp may be illuminated. During low-speed driving this could cause the engine to stall and not restart

DVSA · 영국2012년 1월 23일R/2011/166연식 2010–2011원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진NA

Engine

On certain vehicles, a weld at the boost sensor bracket may fail, allowing the bracket to separate from the air inlet tube. If this occurred, the engine would enter fail-safe driving mode, resulting in reduced motive power in which the vehicle could still be driven for short distances. Continued operation could cause the engine to stall which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the air inlet tube assembly.

캐나다 교통부2011년 12월 12일2011431연식 2011원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
쥬크 I · 2010–2019
리콜보통엔진NA

Engine and engine cooling:Engine:Gasoline:Turbo/supercharger

Nissan is recalling certain model year 2011 nissan juke vehicles manufactured from april 9, 2010, through may 12, 2011. The turbocharger boost sensor bracket may separate from the air inlet tube due to a defective weld.

NHTSA · 미국2011년 12월 8일11V583000연식 2011원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).