무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Nissan 무라노

2002– · 4 세대 · 결함 30건 · 5개 시장
세대
연식
무라노 I · 2002–2007
리콜심각엔진NA

Fuel system, gasoline:Storage:Tank assembly

On certain sport utility vehicles, a fitting for vapor recirculation, which is welded on the fuel tank, may come off the fuel tank because incorrect material was used.

NHTSA · 미국2006년 2월 21일06V054000연식 2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜심각엔진NA

Fuel System

On certain vehicles, an inadequate vapour recirculation fitting, which is welded to the fuel tank, may separate from the tank. This will allow some fuel leakage and cause the malfunction indicator light (MIL) in the instrument panel to illuminate. A fuel leak, in the presence of an ignition source, could result in a fire. Correction: Dealers will replace the fuel tank.

캐나다 교통부2006년 2월 15일2006044연식 2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜심각엔진JP

燃料タンク

燃料タンクの取付位置が不適切なため、高速走行中に、路上の落下物が燃料タンク前面に衝突することがある。そのため、落下物に突起があった場合、タンクに刺さり、最悪の場合、燃料タンクが損傷し、燃料が漏れるおそれがある。なお、当該タンクは、燃料タンクの技術基準に適合している。

국토교통성 · 일본2006년 2월 9일2103120연식 2004–2005원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜심각엔진NA

Fuel system, gasoline:Storage:Tank assembly

On certain sport utility vehicles, due to the location of the forward edge of the fuel tank, in the event that a vehicle front tire runs over a small, sharp object in the road, catches it and propels it towards the rear of the vehicle, it may strike and puncture the fuel tank.

NHTSA · 미국2006년 1월 10일06V003000연식 2003–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜심각엔진NA

Fuel System

On certain vehicles, the fuel tank may be punctured by road debris that has been picked up and thrown by the front tires. A fuel leak, in the presence of an ignition source, could result in a fire. Correction: Dealers will install a shield in front of the fuel tank.

캐나다 교통부2006년 1월 6일2006004연식 2003–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진JP

엔진 일반

원동기에서 엔진 회전 센서의 내열성이 부족하여, 고부하 조건에서 열부하가 반복되면 해당 센서가 단선되는 경우가 있다. 단선되면 페일세이프 기능에 의해 엔진이 꺼지지 않도록 제어하지만, 주행 조건에 따라서는 제어가 제때 이루어지지 않아 엔진이 꺼지고, 재시동에 시간이 걸리는 경우가 있다.

국토교통성 · 일본2012년 7월 27일1129750연식 2002–2007자동 번역 · 원문: 일본어자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진NA

엔진

차량에 따라 엔진의 흡기 시스템에서 중간 공명기(intermediate resonator)와 연결된 흡기 덕트가 엔진 움직임에 따라 공명기에서 분리될 수 있습니다. 이러한 분리는 흡기 덕트에 사용된 소재가 조기 노화되어 과도하게 수축하기 때문에 발생합니다. 흡기 덕트가 공명기에서 빠지면 공기유량계가 흡입 공기량을 정확하게 측정하지 못하게 되며, 이로 인해 공회전 불안정, 가속 불량 또는 엔진 정지가 발생할 수 있습니다. 엔진이 정지하면 동력을 잃게 되는데, 이는 교통 및 도로 상황, 그리고 운전자의 대응과 맞물려 사고 위험을 높일 수 있습니다. 시정 조치: 딜러가 흡기 덕트를 개선된 버전으로 교체해 드립니다.

캐나다 교통부2009년 5월 28일2009153연식 2003–2007자동 번역 · 원문: 영어자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진NA

Engine and engine cooling

Nissan is recalling 362,891 my 2003-2007 murano vehicles. The intake air ducts, which are connected to the intermediate resonator in the air intake system of the engine, may separate from the resonator with engine movement. This separation occurs due to the premature aging of the material used in the intake air ducts which causes excessive shrinking.

NHTSA · 미국2009년 5월 19일09V169000연식 2003–2007원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007무라노 II · 2007–2014
리콜보통엔진JP

エンジン一般

原動機の吸気エアダクトの材質が不適切なため、当該ダクトがエンジンの熱により収縮し、レゾネータ(吸気騒音防止装置)接続部の締付けが緩むことがある。そのため、そのまま使用を続けると、走行振動等によりエアダクトが外れてアイドリング不安定や加速不良となり、最悪の場合、エンストして再始動できなくなるおそれがある。

국토교통성 · 일본2009년 5월 14일1123050연식 2003–2008원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진UK

Possible damage to fuel tank

In the event of a front tyre travelling over a sharp object the object could be propelled towards the rear of the vehicle and possibly damage the front edge of the fuel tank.

DVSA · 영국2006년 5월 23일R/2006/028연식 2002–2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진JP

エバポ抑止装置

燃料蒸発ガスがホース内を通過する時の脈動音を低減させるパージレゾネータの製造方 法が不適切なため、パージレゾネータの溶着部がはがれることがある。そのため、そのま ま使用を続けると、パージレゾネータから燃料蒸発ガスが漏れて、炭化水素の排出量が規 制値を超えるおそれがある。

국토교통성 · 일본2004년 12월 16일1113310연식 2004원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
무라노 I · 2002–2007
리콜보통엔진NA

Engine and engine cooling

On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.

NHTSA · 미국2003년 11월 17일03V455000연식 2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).