이 파일은 Nissan 무라노 IV의 알려진 결함을 커뮤니티가 출처와 함께 정리한 것입니다. 누구나 무료로 읽을 수 있고, 무료 계정으로 기여할 수 있습니다. 신뢰할 수 있는 기여자가 충분히 검증하면 결함에 인증 마크가 붙습니다.
가장 심각한 결함
이 조건에 해당하는 결함이 아직 없습니다.
리콜경미변속기NA
이슈: 일부 차량에서 소프트웨어 문제로 인해 시동을 걸 때 인포테인먼트 시스템 디스플레이가 계속 블랙 스크린 상태로 남을 수 있습니다. 그 결과 변속기를 후진 기어로 넣어도 후방 카메라 영상이 디스플레이에 나타나지 않습니다.
참고: 이번 리콜은 일부 트림 레벨에만 해당합니다.
안전 위험: 후방 카메라 영상이 표시되지 않으면 운전자가 후진 시 차량 뒤쪽을 확인하는 능력이 떨어질 수 있습니다. 이로 인해 충돌 위험이 높아질 수 있습니다.
시정 조치: 회사는 우편으로 소유주에게 통지하며, 인포테인먼트 시스템 소프트웨어 업데이트를 위해 차량을 딜러십으로 가져갈 것을 안내할 예정입니다.
리콜경미전장NA
Nissan North America, Inc. (Nissan) is recalling certain 2025 Murano, 2025-2026 Armada, and Infiniti QX80 vehicles. A software error may occur in the In-Vehicle Infotainment (IVI) system at vehicle startup, resulting in the rearview camera image not displaying when the vehicle is shifted into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
리콜보통브레이크NA
Issue: On certain vehicles, the front brake calipers may not have been manufactured correctly. As a result, the caliper(s) could crack and cause reduced braking. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace front brake caliper(s).
공지경미기타NA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH This bulletin is no longer active. Please discard previous versions of NTB26-047.
공지경미전장NA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH IF YOU CONFIRM The BSW warning was displayed, and one or more of the following DTCs are stored as Current: C1E00-47 for "Control Unit" stored in the Side radar "Rear Left" C1E80-47 for "Control Unit" stored in the Side radar "Rear Right" ACTION 1. Confirm the current part number of the Side Radar (Rear LH) and/or Side Radar (Rear RH) that corresponds to the stored DTC(s). 2. Based on the DTCs stored, individually reprogram each applicable Side Radar (Rear LH) and/or Side Radar (Rear RH).
공지보통서스펜션NA
ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and Key System Error warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL RELAY" is stored in the BCM. Figure 1 HINT: This DTC and warning message (Figure 1) may occur if the customer does not place the vehicle in Park Gear according to the Owners Manual for shifter operation. ACTION 1. Confirm the current ECM part number. 2. Confirm the current TCM part number. 3. Reprogram the ECM, and then the TCM, if applicable. 4. Erase the DTCs. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).