The gas generator on the passenger side airbags may be defective
The gas generator on the passenger side airbags may be defective. Metal fragments can be released when the airbag is activated, causing injuries to the occupants.
🔔 무료 계정을 만들고 Nissan 펄사 (모든 세대) 이메일 알림 받기
The gas generator on the passenger side airbags may be defective. Metal fragments can be released when the airbag is activated, causing injuries to the occupants.
null The chemical composition in the gas generator of the curtain (head-protection) airbag may not be correct. It is therefore possible that, in the event of a side-on collision, the curtain airbag may not be deployed, and passengers in the vehicle may be injured.
null Deterioration of the inflator propellant’s density can result in abnormal driver airbag deployment in case of an accident causing injuries to the driver.
원동기 점화계 배선에 설치된 라디오 잡음 방지용 콘덴서(축전기)에 제조 불량이 있는 것이 있으므로, 그대로 사용을 계속하면 해당 콘덴서의 단자 사이가 단락되어 소손될 수 있으며, 최악의 경우 화재로 이어질 우려가 있다.
The soldered joint where inlet pipe attaches to the fuel tank may be cracked.
The soldered joint where the inlet pipe attaches to the fuel tank may be cracked as the result of a production error. This could result in fuel seepage and in the presence of an ignition source, a vehicle fire. Correction: Tanks will be inspected for fuel seepage and replaced if necessary.
Le générateur de gaz sur les coussins gonflables côté passager peut être défectueux.
La serrure de l’enfant sur les portes arrière pourrait être défectueuse. en conséquence, il pourrait être possible d’ouvrir la porte même lorsque la serrure de l’enfant est activée, ce qui augmente le risque d’accident.
The child lock on the rear doors could be defective.As a result, it might be possible to open the door even when the child lock is activated, increasing the risk of an accident.
Possible reduced retention force of the Rear Door Child Lock switch.
If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.
The rear oxygen sensor's sensing element may fail and not set a Diagnostic Trouble Code (DTC) when the exhaust gas composition is inappropriate. In such cases, the driver is not alerted through the Malfunction Indicator Light (MIL) on the dashboard.
Software van de Intelligent Power Distribution Module (IPDM), bedoeld voor de automatische hoogteregeling van de koplampen, bevat een fout
null The IPDM (Intelligent Power Distribution Module) software data file calculating the headlamp aiming position does not correctly adjust the height of headlamp aim when the rear of the vehicle is heavily laden. Other car drivers could be dazzled by the incorrectly positioned light.
On affected vehicles with Pulsar headlight auto levelling the initialisation process during production was incorrect. In this condition affected vehicles may not correctly adjust the height of the headlamp aim when the rear of the vehicle is heavily laden and therefore may not comply with the specific regulation requirements
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions due to an inoperative electrical contact spring for the throttle body mixture heater. Correction: Mixture heater will be replaced with an improved type. Note: 4wd vehicles only.
Impure lubricating grease used in the headlight switches could contaminate one or more contact points. Operation of the headlights could be delayed or not light when the switch is turned on or when the dimmer switch is operated. Consequence of defect: Loss of head lights while driving could result in a vehicle accident.
The grease used to lubricate the headlamp switch was formulated incorrectly to contain silicone. Electrical arcing during switch operation could produce silicone oxide deposits which could prevent the switch contact points from completely closing. This could result in either delayed or non-illumination of one of the head- lights when the switch is turned on or during dimmer switch operation.
Due to improper operation of the secondary hood latch by owners using excessive force on the lever, the hood latch assembly may become damaged, resulting in separation of the secondary latch from the latch assembly.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).