Fuel system, gasoline:Storage
On certain vehicles, variations in the manufacturing process or exposure to high ambient temperatures may lead to fracture of the fuel tank inlet check valve (icv).
🔔 무료 계정을 만들고 Pontiac Aztek (모든 세대) 이메일 알림 받기
On certain vehicles, variations in the manufacturing process or exposure to high ambient temperatures may lead to fracture of the fuel tank inlet check valve (icv).
On certain passenger vehicles, a weld between the fuel tank inlet check valve and the fuel tank can fail.
In some of these sport utility vehicles, the diameter of the steering column intermediate shaft is too small.
Vehicle description: Passenger, sport utility vehicles and minivans. The passenger air bag inflator modules were built without the correct amount of generant, which produces the gas that fills the air bag. Some were built with a double load of generant and some were built without generant.
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
On certain sport utility vehicles, contamination on ignition relay contacts can cause high resistance. This can affect signals to the powertrain control module and, could cause intermittent vehicle stalls at any time.
On certain vehicles, the aluminum wheels are not marked with "T" and "DOT" as required by CMVSS 120. Correction: Since this does not pose any safety risk, no corrective action is required.
On certain passenger, sport utility vehicles and mini vans, some of these vehicles have a passenger air bag that was manufactured without a check valve pin. An air bag without the check valve pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward.
Vehicle description: Certain mini vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." the seat latch anchor wire diameter is greater than 6.1 mm.
Certain minivans, passenger and sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 225, "child restraint anchorage system." the owner's manual does not explain the meaning of the location symbols for the child restraint lower universal anchorage system.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).