전기 시스템:점화:스위치
특정 승용차에서 나타나는 문제입니다. 엔진이 시동되지 않는데 운전자가 키를 "시동(start)" 위치에 오랫동안 유지하면, 점화 스위치에 큰 전류가 흐르고, 경우에 따라 그 열로 인해 스위치 내부 부품이 녹을 수 있습니다.
🔔 무료 계정을 만들고 Pontiac Sunfire (모든 세대) 이메일 알림 받기
특정 승용차에서 나타나는 문제입니다. 엔진이 시동되지 않는데 운전자가 키를 "시동(start)" 위치에 오랫동안 유지하면, 점화 스위치에 큰 전류가 흐르고, 경우에 따라 그 열로 인해 스위치 내부 부품이 녹을 수 있습니다.
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
차량에 따라 제동등과 방향지시등, 그리고 후미등 기능을 담당하는 후방 램프가 전구와 소켓 사이의 접촉 불량으로 작동하지 않는 경우가 있습니다. 또한 차량이 크루즈 컨트롤 상태로 주행 중에 한쪽 전구가 작동하지 않게 되면, 남은 전구가 켜질 때 크루즈 컨트롤이 해제됩니다. 두 전구가 모두 작동하지 않는 경우에는 크루즈 컨트롤이 작동하지 않습니다.
Certain vehicles do not comply with the requirements of CMVSS 101- Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Generator Low Voltage" indicator light will not illuminate under low voltage conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Vehicle description: Passenger vehicles. These vehicles do not comply with requirements of fmvss no. 101, "control location, identification, and illumination." the instrument panel backlighting may not function after adjusting the interior light intensity.
Vehicle description: Passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of fmvss no. 101, "controls and displays."
These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The interior lamps may turn on by themselves, five to thirty minutes after the vehicle is started and cannot be turned off by the switch. The lamp control module will turn them off after thirty minutes. If the interior lamps turn on while the vehicle is being driven at night, the increased glare could make it more difficult to see objects outside the vehicle. Correction: Lamp control module will be tested and replaced if necessary.
These vehicles may not comply with c.M.V.S.S. 108 - lighting equipment. Vehicles may exhibit a condition in which the front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. Correction: Vehicles will be inspected and hazard lamp switch replaced if necessary.
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with fmvss no. 108, "lamps, reflective devices, and associated equipment."
Note: Vehicles with automatic transmissions. These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The instrument panel trim plate may sag and cover the light emitting diode of the shift indicator display. If this occurs, the driver may not be able to determine the actual position of the transaxle gear selector and could inadvertently leave an idling vehicle in drive, reverse or neutral rather than in park. This could result in a vehicle crash. Correction: A new instrument panel cluster trim plate/bezel assembly will be installed on affected vehicles.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).