안전벨트: 후방/기타
일부 승용차는 연방 자동차 안전 기준 210호인 '안전벨트 조립 고정장치'를 준수하지 않습니다. 조수석 뒷좌석 안전벨트가 잘못된 너트와 볼트로 장착되었을 수 있습니다.
🔔 무료 계정을 만들고 Pontiac Sunfire (모든 세대) 이메일 알림 받기
일부 승용차는 연방 자동차 안전 기준 210호인 '안전벨트 조립 고정장치'를 준수하지 않습니다. 조수석 뒷좌석 안전벨트가 잘못된 너트와 볼트로 장착되었을 수 있습니다.
특정 승용차에서 나타나는 문제입니다. 엔진이 시동되지 않는데 운전자가 키를 "시동(start)" 위치에 오랫동안 유지하면, 점화 스위치에 큰 전류가 흐르고, 경우에 따라 그 열로 인해 스위치 내부 부품이 녹을 수 있습니다.
Certain vehicles, after being exposed to substantial amounts of water, may experience deployment of either the driver or passenger front airbag without a crash. The owner’s manual for these vehicles does not provide specific information about this situation. Inadvertent deployment of the driver and / or passenger front airbag in a non-accident (non-impact) situation may cause damage to the surrounding vehicle environment (windshield / instrument panel), and create expensive vehicle repair, including replacement of the airbag module(s) and the Sensing and Diagnostic Module (SDM). In some instances, inadvertent deployment could cause minor injuries to vehicle occupants. Correction: GM will notify the owners of these 1996 and 1997 vehicles of the potential affect of water accumulating in the vehicle interior on the function of the airbag system (as included in the owner's manuals of 1998 and later model years vehicles).
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Vehicle description: Passenger vehicles. The wheel lug nuts were not tightened securely resulting in a fracture of the wheel studs.
Vehicle description: Passenger vehicles. The compact spare tire assemblies were assembled with incorrect rims. If the spare tire is underinflated, the bead can separate from the rim causing a rapid loss of air. This does not comply with the requirements of fmvss no. 110, "tire selection and rims."
차량에 따라 제동등과 방향지시등, 그리고 후미등 기능을 담당하는 후방 램프가 전구와 소켓 사이의 접촉 불량으로 작동하지 않는 경우가 있습니다. 또한 차량이 크루즈 컨트롤 상태로 주행 중에 한쪽 전구가 작동하지 않게 되면, 남은 전구가 켜질 때 크루즈 컨트롤이 해제됩니다. 두 전구가 모두 작동하지 않는 경우에는 크루즈 컨트롤이 작동하지 않습니다.
특정 승용차 및 미니밴의 파워 랙 앤 피니언 조립체에 있는 하단 피니언 베어링은 리테이너 탭이 제대로 압착되지 않은 상태로 장착되어 있습니다. 이 제품과 1996년 1월 1일부터 1997년 10월 31일 사이에 조립된 차량에 사용된 일부 다른 리테이너는 고장 나서 볼 베어링이 이탈할 수 있습니다.
Certain vehicles do not comply with the requirements of CMVSS 101- Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Generator Low Voltage" indicator light will not illuminate under low voltage conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
Vehicle description: Passenger vehicles. These vehicles do not comply with requirements of fmvss no. 101, "control location, identification, and illumination." the instrument panel backlighting may not function after adjusting the interior light intensity.
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
Certain vehicles may have a condition which could result in one of the rear suspension trailing arm bolts breaking. If this were to occur while the vehicle was in motion, vehicle control would be affected and a crash could occur without prior warning. Correction: Dealers will replace the rear suspension trailing arm fasteners.
Vehicle description: Passenger vehicles. One of the rear suspension trailing arm bolts can fatigue and break.
Because of certain calibrations in the air bag's computer, there is an increased risk of an air bag deployment in a low speed crash or when an object strikes the floor pan. Correction: The sdm module will be recalibrated to reduce the sensitivity to short and mid-duration commanded deployments.
Vehicle description: Passenger vehicles. Because of certain calibrations in the air bag's sensing and diagnostic module, an inadvertent air bag deployment could occur in a low speed crash or when an object strikes the floor pan.
These vehicles may not comply with c.M.V.S.S. 214 - side door strength. There may be mis-located welds at the joint between the left rocker panel inner reinforcement and the body side ring. In the event of a vehicle crash, the sheet metal structure may not perform as designed. This could result in reduced levels of occupant protection. Correction: Vehicles will be inspected for mis-located welds and, if necessary, up to five welds will be placed between the involved panels.
Vehicle description: Passenger vehicles. These vehicles were built with mis-located welds at the joint between the left rocker panel inner reinforcement and the body side ring. This does not meet the requirements of fmvss no. 214, "side door strength."
Vehicle description: Passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of fmvss no. 101, "controls and displays."
These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The interior lamps may turn on by themselves, five to thirty minutes after the vehicle is started and cannot be turned off by the switch. The lamp control module will turn them off after thirty minutes. If the interior lamps turn on while the vehicle is being driven at night, the increased glare could make it more difficult to see objects outside the vehicle. Correction: Lamp control module will be tested and replaced if necessary.
These vehicles do not comply with c.M.V.S.S. 110 - tire selection and rims. The compact spare tire assemblies in these vehicles may have been assembled with rims that do not conform to dimensional and profile standards. If the tire is underinflated it can separate from the rim. Correction: Rim on the compact spare tire assembly will be replaced.
These vehicles may not comply with c.M.V.S.S. 108 - lighting equipment. Vehicles may exhibit a condition in which the front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. Correction: Vehicles will be inspected and hazard lamp switch replaced if necessary.
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with fmvss no. 108, "lamps, reflective devices, and associated equipment."
차량에 따라 CMVSS 1105 - 증발 배출가스 규정을 충족하지 못할 수 있습니다. 플라스틱 봉지재(encapsulant)에 응력이 가해져 연료 인젝터에서 연료 증기가 누출될 수 있습니다. 시정 조치: 해당 차량의 연료 인젝터는 관련 제조 일자 코드(date code)를 확인하여 점검하고, 필요한 경우 교체합니다.
The accelerator control cable could have been kinked during assembly causing high accelerator pedal effort, sticking accelerator control cable, or a broken accelerator control cable.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).