무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Porsche 928

1977–1995 · 결함 0건 · 2개 시장
연식
리콜심각기타JP

その他(その他)

音響機器のオーディオ本体(メーカー:ソニー(株)、型式:XR-5H911,XRー5H912)の配 線基板において、当該基板の製造工程が不適切なため、コンデンサーが損傷しているもの があり、そのままの状態で使用を続けると、当該コンデンサーの端子間が短絡して、スピ ーカーに過大な電流が流れ発熱し、最悪の場合、火災に至るおそれがある。

국토교통성 · 일본1999년 12월 7일1207700연식 1990–1991원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
리콜심각전장JP

その他(その他)

音響機器のオーディオ本体の配線基盤において、当該基盤の製造工程が不適切なため、コ ンデンサが損傷しているものがあり、そのままの状態で使用を続けると、当該コンデンサ の端子間が短絡して、スピーカーに過大な電流が流れ、最悪の場合、火災にいたるおそれ がある。

국토교통성 · 일본1997년 12월 19일1206650연식 1990–1995원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
리콜심각엔진NA

Fuel System

The fuel gauge sending unit mounting nut may crack and, under certain fuel level and operational conditions, result in fuel tank leakage. Leaking fuel could ignite on the hot exhaust system and result in a vehicle fire. Correction: Mounting nuts will be inspected and replaced as required.

캐나다 교통부1990년 6월 14일1990089연식 1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜심각엔진NA

Engine

The heatshield above the catalytic converter is inadequate under certain circumstances involving engine malfunction. A misfiring engine could overheat the catalytic converter causing materials in the vicinity of the converter, including the automatic transmission fluid lines to ignite resulting in an underbody fire. Correction: 1) replace the heatshiel with a larger improved heatshield. 2) install a heat resistant sleeve on atf lines where necessary. 3) replace plastic atf line mounting bracket in proximity to the catalytic converter with a metal mounting bracket.

캐나다 교통부1989년 6월 28일1989091연식 1985–1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜심각엔진NA

Fuel System

Lack of ozone resistance in the fuel return hoses may cause cracking of the fuel line. This could result in fuel leakage and engine compartment fire. Correction: Fuel return hoses will be replaced.

캐나다 교통부1987년 3월 16일1987033연식 1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜심각엔진NA

리콜

A brazed joint on the metal fuel line may leak and result in a vehicle fire.

캐나다 교통부1980년 2월 18일1980020연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통변속기NA

Powertrain

A filler piece with insuffient support was installed in the automatic transmission. This piece can move and inhibit the kickdown function. This could result in an accident during overtaking.

캐나다 교통부1992년 8월 6일1992091연식 1991원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통변속기NA

Power train:Automatic transmission

A plastic filler piece located in the automatic transmission was installed without sufficient support. This filler piece can move because of the hydraulic pressure in the system, and not allow the automatic transmission to kick down to a lower gear.

NHTSA · 미국1992년 8월 3일92V092000연식 1991원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통서스펜션NA

리콜

Vehicles were equipped with an engine carrier which has a faulty weld to the support bracket. If the weld were to give way, a break in the engine carrier could develop, resulting in a steering blockage and possible loss of vehicle control.

캐나다 교통부1985년 7월 9일1985082연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통엔진NA

Engine and engine cooling:Engine

The engine carrier has a faulty weld to the support bracket eyes. Consequence of defect: The weld could give way and the bracket eye separate from the carrier. With higher mileage accumulation a break in the engine carrier could develop and result in a steering blockage, loss of control with possibly an accident.

NHTSA · 미국1985년 7월 1일85V084000연식 1985원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통브레이크NA

리콜

The front brake hoses may have been incorrectly routed during production.If this occurred,the brake hose could rub against the rim at certain road wheel postions and eventually wear through

캐나다 교통부1982년 7월 22일1982063연식 1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통서스펜션NA

리콜

The univesal joint connecting the steering shaft to the steering rack may be improperly positioned. If the vehicle is driven on rough roads for an extended period of time the connection could loosen an cause excessive steering wheel free play.

캐나다 교통부1982년 7월 22일1982062연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통브레이크NA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

Due to the improper installation of hydraulic brake hoses, the hose could rub against the rim in certain wheel positions. Brake fluid loss could result, causing a degradation in the performance of the front brake system. This would cause an increase in vehicle stopping distances.

NHTSA · 미국1982년 5월 12일82V049000연식 1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통서스펜션NA

Steering: Steering wheel/handle bar

On the involved vehicles, the universal joint which connects the steering shaft to the steering rack may have been improperly positioned during assembly. If vehicle is driven on poor roads for an extended period of time, the connection between the steering shaft and universal joint could loosen and cause excessive steering wheel free play.

NHTSA · 미국1982년 5월 12일82V048000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통서스펜션NA

Suspension:Front:Shock absorber

Front shock absorbers on some vehicles may have improperly welded mounting eyes. The shock absorber mounting could separate and cause the suspension to collapse if vehicle is driven on rough roads for a long period of time.

NHTSA · 미국1981년 3월 25일81V040000연식 1980–1981원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).