공지
Certain Model S and Model X vehicles were equipped with driver airbags that do not meet internal quality standards.
🔔 무료 계정을 만들고 Tesla X 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
Certain Model S and Model X vehicles were equipped with driver airbags that do not meet internal quality standards.
Some Model S Palladium and Model X Palladium vehicles were built without a hydraulic control unit (HCU) wake-up line, and in rare circumstances, braking and stability control related alerts may appear on the instrument cluster and touchscreen during the vehicle power-on process. Such faults can typically be corrected and the affected functionality restored with a vehicle power cycle.
On certain Model S and Model X vehicles, the 2nd generation High Voltage (HV) harness between the Front Junction Box (FJB) and the front drive unit might become disconnected, which could prompt a driver alert to bring the vehicle to a safe stop, advise the driver of limited acceleration, or prevent the driver from operating the vehicle upon startup. This condition does not affect steering or braking.
On some Model X vehicles, one or both intrusion sensors may have been incorrectly installed and may not function properly.
일부 Model X 차량은 잘못된 앞 반축(프런트 하프샤프트)으로 제작되었을 수 있습니다. 서스펜션이 완전히 늘어난 상태에서 핸들을 끝까지 돌리면(풀 락 조향), 잘못된 반축이 과도하게 늘어나 더스트 부츠나 등속 조인트(CV 조인트)가 손상될 수 있습니다. 이로 인해 덜컹거리는 소리나 갈리는 소리가 발생하거나, 계기판에 경고 메시지가 표시될 수 있습니다.
On some model x vehicles, the a/c condenser pipes might have been installed on the incorrect condenser ports. This might cause poor or no a/c cooling performance, slow supercharging, and/or noise from the condenser pipes touching the front suspension sway bar.
Describes how to install the performance pedal set accessory.
On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.
On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.
On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.
On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.
Owners manual
On some Model X vehicles, the front door(s) may require manual assistance to fully close the doors because the cinch actuator(s) may not have been manufactured to Tesla specifications. The cinch actuators assist with the closing of the front doors on the automatic door feature. The front doors can always be manually opened or closed.
일부 Model X 차량에서 좌측(LH) 및/또는 우측(RH) 리어 쿼터 이너 패널의 판금에 갈라짐이 발생할 수 있습니다. 이러한 상태가 있는 경우, 이는 외관상의 문제이며 차량의 구조적 무결성, 기능 또는 안전성에는 영향을 미치지 않습니다.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
특정 Model S, Model X 및 Fremont에서 생산된 Model 3 차량에서, 좌측(LH) 및 우측(RH) 측면 리피터 카메라의 인쇄 회로 기판(PCB)이 시간이 지나면서 전기적 연속성을 잃을 수 있으며, 이로 인해 카메라가 조기에 고장 날 수 있습니다.
특정 Model X 차량에 제조 결함이 있는 키 페어가 장착되어 출고된 사례가 있습니다. 이러한 키 페어는 차량과 페어링은 가능하지만, 기능(예: 버튼 눌러 잠금 해제, 패시브 잠금 및 잠금 해제 등)이 제대로 작동하지 않을 수 있습니다.
일부 Model S, Model X 및 Fremont에서 생산된 Model 3 차량에서, 좌측(LH) 측면 리피터 카메라의 인쇄회로기판(PCB)이 시간이 지나면서 전기적 연속성을 잃어 카메라가 조기에 고장 날 수 있습니다.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
특정 Model X 차량은 트리플 카메라 윈드실드 브래킷이 윈드실드에 제대로 고정되지 않은 상태로 생산되었습니다. 브래킷이 기울어 보이거나 손으로 조작하면 움직일 수 있습니다. 그러나 Autopilot 기능이나 룸미러의 안정성에는 영향이 없습니다.
Certain Model 3, Model S, and Model X vehicles were equipped with 2nd generation Universal Mobile Connector (UMC) inline units having a proximity circuit resistor that is out of specification. This resistor within the affected UMC inline unit might prevent charging, might interrupt charging while in progress, and might affect the functionality of the UMC charge handle button when disconnecting the charge handle from the vehicle charge port.
Inspect Front Door Fixed Glass Seals
The rear node of some Model S and Model X vehicles might have damage in the forward mounting location of the rear subframe, resulting in noise, vibration, or harshness coming from that location.
Early front door latches are susceptible to water ingress, which might cause the touchscreen to show the door in the wrong position or prevent the door from opening and closing automatically. The door can still be opened with the inside handle.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).