Steering malfunction (US safety investigation)
NHTSA, the US road safety agency, opened a preliminary evaluation (PE87051) into this problem on 25 August 1987 for 1983 models; it was closed on 9 December 1987 without a recall.
🔔 무료 계정을 만들고 Toyota 코롤라 AE86 이메일 알림 받기
이 파일은 Toyota 코롤라 AE86의 알려진 결함을 커뮤니티가 출처와 함께 정리한 것입니다. 누구나 무료로 읽을 수 있고, 무료 계정으로 기여할 수 있습니다. 신뢰할 수 있는 기여자가 충분히 검증하면 결함에 인증 마크가 붙습니다.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE87051) into this problem on 25 August 1987 for 1983 models; it was closed on 9 December 1987 without a recall.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE87057) into this problem on 10 September 1987 for 1983–1986 models; it was closed on 30 March 1988 without a recall.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE88059) into this problem on 13 June 1988 for 1987 models; it was closed on 14 September 1988 without a recall.
Cruise control computer malfunction could occur upon shutting off the control after continuous use followed by cold ambient temperatures.
Voltage regulator which controls the amount of flow in the electrical system between the battery and the alternator, may have manufacturing errors in an integrated circuit. The regulator may overcharge the battery.
Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance
TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.
TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).