Issue: 이 리콜은 특정 차량에 설치되었거나 토요타 또는 렉서스 딜러십에서 액세서리로 판매된 특정 블록 히터 키트에 해당합니다. 일부 차량에서는 엔진 블록 히터 케이블의 열 보호가 충분하지 않아 고온에 의해 손상될 수 있습니다. 이런 경우 케이블이 전원에 연결된 상태에서 단락될 수 있으며, 배선이 과열되거나 녹을 수 있습니다. 참고: 이 리콜은 다음 블록 히터/코드 부품 번호에만 해당합니다: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903
Safety Risk: 과열되거나 녹은 엔진 블록 히터 배선은 화재 위험을 초래할 수 있습니다.
Corrective Actions: 토요타는 엔진 블록 히터 사용을 즉시 중단할 것을 권장합니다. 토요타는 우편으로 소유자에게 통지하고, 블록 히터를 비활성화하기 위해 차량을 딜러에게 가져가도록 안내할 예정입니다. 일부 차량의 경우 이 리콜에 대한 시정 조치는 개발 중입니다. 그 밖의 차량에는 새 엔진 블록 히터를 설치할 수 없으며, 소유자는 블록 히터 구매 가격을 환불받게 됩니다.
캐나다 교통부2021년 11월 24일2021723연식 2000–2004자동 번역 · 원문: 영어자세히 보기 →
The ammonium nitrate propellant used in the airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event of an airbag being deployed, it may deploy too slowly or the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the occupants.
Safety Gate · EU2020년 1월 29일A12/00160/20연식 1997–1999원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Issue: On certain vehicles, exposure to moisture over time could cause the driver-front airbag not to inflate properly in a crash. In some cases, this could cause an airbag not to fully inflate, while in others it could cause it to deploy with more force than normal. It could also cause the inflator to rupture. If the airbag inflator ruptures, small pieces of metal could be propelled toward vehicle occupants or cause damage to the airbag and prevent its proper function. Safety Risk: In a crash requiring an airbag deployment, the driver-front airbag may not inflate properly or the inflator could rupture. This could create a risk of injury. Corrective Actions: Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to inspect, and if necessary, replace the front driver airbag inflator.
캐나다 교통부2020년 1월 22일2020018연식 1997–1999원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 1998-2000 RAV4, 1998-1999 RAV4 EV and Celica and 1997-1998 Supra vehicles. These vehicles were equipped with Non-Azide Driver air bag Inflators (NADI) and do not contain phase stabilized ammonium nitrate (PSAN) propellant. Due to a manufacturing issue, the NADI inflators may absorb moisture, causing the inflators to rupture or the air bag cushion to underinflate.
NHTSA · 미국2020년 1월 22일20V033000연식 1998–1999원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain passenger vehicles, the fuel tank check valve, located in the fuel tank inlet pipe, may become separated from the inlet pipe and fall into the fuel tank. If the check valve falls into the tank, fuel may spill from the fuel inlet pipe when the fuel pump automatically shuts off during fueling.
NHTSA · 미국2003년 3월 5일03V074000연식 2002–2003원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Due to an improper washing process of a metal part within the brake master cylinder there is a possibility that the groove for installing the rubber seal ring which is located at the end of the master cylinder may be corroded. In this condition brake fluid may leak from the seal or a small amount of air may enter the master cylinder which could lead to an increase in vehicle stopping distance.
DVSA · 영국2005년 4월 25일R/2004/168연식 1999–2000원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain passenger vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 108, 'lamps, reflective devices, and associated equipment.' the luminous intensity of the daytime running lamp (drl) will be modified to meet the standard requirements.
NHTSA · 미국2004년 11월 29일04V566000연식 2000–2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Certain passenger vehicles have the possibility that the recess retains a rubber seal ring, which is located at the end of the cylinder body, and may be corroded due to an improper washing process.
NHTSA · 미국2004년 9월 17일04V455000연식 2000원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, the recess that retains the rubber seal ring, which is located at the end of the brake master cylinder body, may be corroded due to an improper washing process. In this condition, brake fluid may leak from the seal, or a small amount of air may enter the master cylinder, which could lead to an increase in stopping distance. Correction: After inspection, if a brake fluid leak from the master cylinder is detected or there is air in the master cylinder, the dealer will replace the master cylinder and the brake booster.
캐나다 교통부2004년 9월 14일2004335연식 2000원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The check valve in the fuel tank inlet that prevents reverse fuel flow is incorrectly fitted on some vehicles . This could cause fuel to spill out when the cap is opened if there is high internal pressure in the fuel tank.
DVSA · 영국2003년 3월 12일R/2003/030연식 2002원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
차량에 크루즈 컨트롤이 장착된 경우, 크루즈 컨트롤 컴퓨터 회로 기판에 결함이 생길 수 있으며, 이로 인해 메인 크루즈 컨트롤 스위치가 "on" 위치에 있는 상태에서 시동을 걸면 엔진 회전수가 높아질 수 있습니다. 변속기(특히 자동변속기)를 기어에 넣고 운전자가 브레이크 페달을 힘껏 밟지 않으면 차량이 갑자기 가속할 수 있습니다. 이로 인해 차량 통제를 잃고 충돌 사고로 이어질 가능성이 있습니다. 시정 조치: 크루즈 컨트롤 컴퓨터를 점검하고 필요한 경우 교체합니다.
캐나다 교통부1986년 10월 9일1986114연식 1982자동 번역 · 원문: 영어자세히 보기 →
크루즈 컨트롤 컴퓨터의 납땜 단자가 인쇄회로기판에 코팅이 부적절하게 적용되어 균열이 생길 수 있습니다. 결함의 결과: 크루즈 컨트롤을 계속 사용하면 납땜 단자가 완전히 분리되고 회로가 고장 날 수 있으며, 이 경우 엔진 회전수가 즉시 급상승하고 차량이 갑자기 가속하여 사고로 이어질 수 있습니다.
NHTSA · 미국1986년 10월 2일86V132000연식 1982자동 번역 · 원문: 영어자세히 보기 →
The engine alternator pulley may break while the engine is operating. This condition could result in damage to underhood components or injury to service personnel.
캐나다 교통부1980년 4월 17일1980058연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Due to a faulty press die used in manufacturing alternator pulleys, pulleys installed on certain vehicles may crack and break during vehicle operation. The battery would then be constantly drained without recharging.
NHTSA · 미국1980년 4월 11일80V045000연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Gulf states toyota is recalling certain model year 2005-2010 vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims." these vehicles were sold between september 1, 2005 and june 2, 2008 without the requisite load carrying capacity modification labels.
NHTSA · 미국2010년 2월 3일10V035000연식 2005원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
1980 celica, corona and pickup trucks. In incomplete emission control label may cause the ignition timing to be misadjusted. Thus vehicles do not comploy with cmvss 1101 - emission devices.
캐나다 교통부1981년 2월 27일1981030연식 1980원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).