Wheel bearing failure and axle (US safety investigation)
NHTSA, the US road safety agency, received a defect petition (DP85019) about this problem on 10 April 1985 for 1982 models; it was closed on 14 May 1985 without a recall.
🔔 무료 계정을 만들고 Toyota Tercel I 이메일 알림 받기
이 파일은 Toyota Tercel I의 알려진 결함을 커뮤니티가 출처와 함께 정리한 것입니다. 누구나 무료로 읽을 수 있고, 무료 계정으로 기여할 수 있습니다. 신뢰할 수 있는 기여자가 충분히 검증하면 결함에 인증 마크가 붙습니다.
NHTSA, the US road safety agency, received a defect petition (DP85019) about this problem on 10 April 1985 for 1982 models; it was closed on 14 May 1985 without a recall.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE89134) into this problem on 3 July 1989 for 1982 models; it was closed on 22 September 1989 without a recall.
The lower control arms, which support the rear wheels, are subject to corrosion if operated in areas where a large amount of road salt is used to aid in snow and ice removal. Consequence of defect: Continuous exposure to road salt may cause corrosion failure of the lower control arm affecting vehicle operation; this could result in loss of control and an accident.
Vehicles located ontario, quebec and the maritime provinces. In areas of high corrosion, the rear control arm that supports the rear wheel may rust. Should the vehicle continue to be driven under severe environmental conditions the rusting will progress and the control arms could deform thereby adversely affecting vehicle operation.
Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance
TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.
TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).