Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Audi A3

1996– · 7 gerações · 42 defeitos documentados · 6 mercados
Gerações

Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.

Ano do modelo
MercadoTodosNA
A3 S3 (8Y) · 2020–
BoletimModeradoMotorNA

Boletim

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · boletim do fabricante11022660Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
A3 S3 (8Y) · 2020–
BoletimModeradoMotorNA

Boletim

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · boletim do fabricante11022658Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
A3 S3 (8Y) · 2020–
BoletimModeradoMotorNA

Boletim

Esta Solução de Serviço Pendente (PSS) solicita que os técnicos criem um Registro PSS nos casos em que o motor não liga de forma esporádica.

NHTSA · boletim do fabricante11009955Anos-modelo 2024Traduzido automaticamente · original: inglêsVer detalhes →
A3 S3 (8Y) · 2020–
BoletimModeradoMotorNA

Boletim

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · boletim do fabricante10247146Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
A3 S3 (8Y) · 2020–
BoletimModeradoMotorNA

Boletim

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · boletim do fabricante10247145Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

On-Hoist Inspection Section: Removed "Perform a coolant reservoir cap pressure test via ELSA -> Enter VIN # -> Repair manual Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking. Only the procedure ?Pressure Relief Valve in Cap, Checking? should be performed in the document Cooling System, Checking for Leaks

NHTSA · boletim do fabricante10120803Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 87 number 14-56 dated September 12, 2014. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent . No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling. The Denso A/C compressor is currently being installed in production. An improved N280 valve for the Sanden A/C compressor is in development, as the installation of Sanden compressors for production will resume in the future.

NHTSA · boletim do fabricante10119951Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 10 number 13-10 dated September 5, 2013. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these metal debris pieces are not removed prior to the installation and operation of the replacement engine, they could be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · boletim do fabricante10119945Anos-modelo 2016Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

The MIL is on due to a Fuel Rail/System Pressure Too Low DTC stored in the ECM. Drivability concerns such as hard starting/no starting are present. Fuel pump may be making a straining noise. Outside temperature is sub-freezing. This issue is related to the diesel fuel and not a technical problem with the vehicle.

NHTSA · boletim do fabricante10119854Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

This bulletin describes the service for a vehicle that intermittently does not start or the engine is not performing.

NHTSA · boletim do fabricante10094666Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 01 number 13-86 dated April 15, 2013. The MIL is on. There is a rough idle. DTCs are stored in the ECM. Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.

NHTSA · boletim do fabricante10122184Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 01 number 14-59 dated January 21, 2014. The MIL is on. DTC may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · boletim do fabricante10122183Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 01 number 14-55 dated January 8, 2014. The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · boletim do fabricante10122180Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimModeradoMotorNA

Boletim

The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20 F (-7 C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No. 2 Diesel is blended by refineries to various levels of winterization (minimum useable temperature) based on month, geographical location, and the 10th percentile minimum ambient air temperature for the given region. Although rare, during sudden periods of extreme low temperatures (record lows), fuel stations may not be adequately prepared with No. 2 Diesel fuel with sufficient winterization to resist wax formation or ?gelling?.

NHTSA · boletim do fabricante10122176Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
A3 II · 2003–2013
BoletimModeradoMotorNA

Boletim

Audi: Mil on; no start or rough running (dtc p0087-rail fuel pressure too low). Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Rust or metallic debris found in the fuel system indicates a major component failure. *pe updated on 6/14/2011. *kb

NHTSA · boletim do fabricante10034751Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

Este boletim fornece informações quando o motor não está a funcionar suavemente; todos os motores a gasolina.

NHTSA · boletim do fabricante11039252Anos-modelo 2018Traduzido automaticamente · original: inglêsVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · boletim do fabricante11035829Anos-modelo 2018Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · boletim do fabricante11035828Anos-modelo 2018Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · boletim do fabricante11002998Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · boletim do fabricante11002929Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · boletim do fabricante10228295Anos-modelo 2016Exibido no inglês original · tradução pendenteVer detalhes →
A3 II · 2003–2013
BoletimLeveMotorNA

Boletim

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · boletim do fabricante10228356Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · boletim do fabricante10224974Anos-modelo 2016Exibido no inglês original · tradução pendenteVer detalhes →
A3 II · 2003–2013
BoletimLeveMotorNA

Boletim

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · boletim do fabricante10225035Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
A3 III · 2012–2020
BoletimLeveMotorNA

Boletim

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · boletim do fabricante10221947Anos-modelo 2016Exibido no inglês original · tradução pendenteVer detalhes →
Mais antigos →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).