Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Audi A4

1991– · 16 gerações · 132 defeitos documentados · 2 mercados
Gerações

Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.

Ano do modelo
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

This bulletin contains repair instructions for when an oil leak is present around the ATF sump. 2018 A5 Sportback

NHTSA · boletim do fabricante10161605Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

This bulletin contains repair instructions for when an oil leak is present around the ATF sump. Also includes 2018 A5 Sportback.

NHTSA · boletim do fabricante10158637Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

This bulletin contains repair instructions for when an oil leak is present around the ATF sump.

NHTSA · boletim do fabricante10145643Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

This bulletin contains repair instructions for when an oil leak is present around the ATF sump.

NHTSA · boletim do fabricante10133295Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

On-Hoist Inspection Section: Removed "Perform a coolant reservoir cap pressure test via ELSA -> Enter VIN # -> Repair manual Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking. Only the procedure ?Pressure Relief Valve in Cap, Checking? should be performed in the document Cooling System, Checking for Leaks

NHTSA · boletim do fabricante10120803Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 VI · 2017–2025
BoletimModeradoMotorNA

Boletim

"for a4 sedan only: Added to on-hoist inspection section: ""perform a coolant reservoir cap pressure test via elsa -> enter vin # -> repair manual engine -> 4-cylinder direct injection 1.8l; 2.0l 4v tfsi engine (generation iii) -> 19 cooling system -> coolant system/coolant -> cooling system, checking for leaks -> pressure relief valve in cap, checking. Only the procedure pressure relief valve in cap, checking should be performed in the document cooling system, checking for leaks"""

NHTSA · boletim do fabricante10094325Anos-modelo 2017Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · boletim do fabricante10124868Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 19 number 13-42 dated July 11, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.

NHTSA · boletim do fabricante10124496Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 19 number 13-40 dated June 17, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.

NHTSA · boletim do fabricante10124494Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.

NHTSA · boletim do fabricante10123905Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 19 number 13-36 dated April 15, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.

NHTSA · boletim do fabricante10123588Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

MIL on. DTCs for the cam actuators are stored in ECM memory. After the activation of the cam actuator to change to the other cam profile, the pin of the actuator is pushed back in by the cam. This is confirmed by a voltage impulse, which is registered by the engine control unit and confirms the operation. If this does not happen, or not at the right time, a DTC "implausible signal" is saved in ECM memory. Check the distance of the pin tip of the cam actuator for valve lift system to the camshaft when it is not operated with a gauge. The measurement of the tip to the basic camshaft circle outside of the groove must be taken. If this measurement is 0.9mm, the actuator 06E103697J must be installed. The actuator 06E103697J must only be used, if the measurement is 0.9mm or bigger.

NHTSA · boletim do fabricante10122800Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Supersedes Technical Service Bulletin Group 19 number 13-44 dated July 18, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.

NHTSA · boletim do fabricante10121490Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimModeradoMotorNA

Boletim

Audi: The connection of water pump and hose, on some vehicles, leading to heater core, has a coolant leakage from engine area and seal ring is not the cause. Model 2009-2013 a4, a5, q5, a6. *pe

NHTSA · boletim do fabricante10053906Anos-modelo 2013Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

Audi: On the turbocharger engine, the coolant supply line may leak, within a specific period and needs to be replaced. *pe

NHTSA · boletim do fabricante10043507Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

Audi service campaign: See document search button for owner letter. Under certain conditions the coolant pump may leak. *rm

NHTSA · boletim do fabricante10038584Anos-modelo 2011Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

Audi: It is possible that the coolant supply line at the turbocharger may leak on audi vehicles with 2.0l tfsi engines built within a specific period. *pe

NHTSA · boletim do fabricante10033027Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

Audi: It is possible that the coolant supply line at the turbocharger may leak on vehicles with 2.0l tfsi engines built within a specific period. *pe

NHTSA · boletim do fabricante10033026Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimModeradoMotorNA

Boletim

Audi: Engine oil may be leaking from upper engine area. Due to the porosity of the cam carrier casting, oil can drain into the thread of the cam bolt and cause an external engine leak. All bolts are installed with loctite. *pe

NHTSA · boletim do fabricante10030609Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B7 · 2004–2008
BoletimModeradoMotorNA

Boletim

Engine stumbles after cold start / warm engine may attempt to stall in idle when engaging gear with vehicle stationary. *tt

NHTSA · boletim do fabricante10018227Anos-modelo 2005Exibido no inglês original · tradução pendenteVer detalhes →
A4 IV · 2018–2025
BoletimLeveMotorNA

Boletim

This TSB provides information about engine control unit drive system faults P060C00 and U041600.

NHTSA · boletim do fabricante11027327Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
A4 III · 2012–2015
BoletimLeveMotorNA

Boletim

This bulletin provides information when the MIL is on, DTC P310B00 in ECM; Vapor pocket formation in fuel system.

NHTSA · boletim do fabricante11026295Anos-modelo 2012Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimLeveMotorNA

Boletim

This bulletin provides informatin when the engine does not run smoothly at idling speeds.

NHTSA · boletim do fabricante11016532Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimLeveMotorNA

Boletim

This bulletin provides information when the MIL is on; DTCs for misfire, air/fuel ratio imbalance, or lean fuel system stored in the ECM P030000.

NHTSA · boletim do fabricante11012476Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
A4 B8 · 2007–2015
BoletimLeveMotorNA

Boletim

This bulletin provides informatin when the engine does not run smoothly at idling speeds.

NHTSA · boletim do fabricante11009928Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
Mais antigos →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).