Boletim
This bulletin provides information for all gasoline engines when the MIL is on; DTC P240700 is stored - Fuel leak detection pump.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Audi A7 (todas as gerações)
Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.
This bulletin provides information for all gasoline engines when the MIL is on; DTC P240700 is stored - Fuel leak detection pump.
This Pending Service Solution (PSS) requests that technicains enter a record in the PSS database in instances where the MIL is on, Eval leak detection pump circuit, DTC240700.
This Pending Service Solution (PSS) requests that technicians enter a record in the PSS Database in instances where the MIL is on and DTC P240700 is stored; Evap leak detection pump circuit.
This bulletin requests that a record is created in the Pending Service Solutions database in instances where MIL is on in the presence of DTC P240700 - Evap leak detection pump circuit.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.
This bulletin contains instructions for using the UV additive to find engine oil leaks.
This bulletin contains intructions for installing the improved rubber plug and spring to correct an oil pressure warning.
The MIL is on due to a Fuel Rail/System Pressure Too Low DTC stored in the ECM. Drivability concerns such as hard starting/no starting are present. Fuel pump may be making a straining noise. Outside temperature is sub-freezing. This issue is related to the diesel fuel and not a technical problem with the vehicle.
Supersedes Technical Service Bulletin Group 01 number 14-69 dated March 6, 2014. The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing a MIL on, no-start, or rough running concern on a common rail diesel vehicle, and no root cause is found after checking all other components and following all GFF diagnostic procedures, it may be necessary to check for metallic particles in the High Pressure Fuel Pump.
The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
Audi: The oil filter, for some vehicles, are too short, (should be 155 (=/-1) mm long) for installation and drain flap, in oil filter housing, can not completely close causing lost of oil pressure. Model 2013 a6, a7, s4, s5, s5 cab, q7, q5. *pe
Audi service campaign: See document search button for owner letter. Under certain conditions the coolant pump may leak. *rm
This bulletin provides service informaiton when the Fuel Rail/system pressure too low P008700.
This bulletin contains repair instructions for when there is a knocking or rattling noise in the engine compartment.
This bulletin provides information on the discontinuation and mixing of Audi-approved engine coolants.
When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.
When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).